Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
Assertion (A): When reverse voltage across a p-n junction is increased, the junction capacitance decreases. Reason (R): Capacitance of any layer is inversely proportional to thickness. | |
A. | Both A and R are true and R is correct explanation of A [Correct Answer] |
B. | Both A and R are true but R is not a correct explanation of A [Wrong Answer] |
C. | A is true but R is false [Wrong Answer] |
D. | A is false but R is true [Wrong Answer] |
View Answer
Explanation:-
Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ A dynamometer wattmeter can be used for
dc only
ac only
dc and 50 Hz ac
dc and high frequency ac
⇒ In a multicavity klystron amplifier the signal to be amplified develops an ac voltage of signal frequency across the gap in buncher cavity
TRUE
FALSE
⇒ A dual trace CRO has
one electron gun
two electron guns
one electron gun with one two pole switch
two electron guns with one two pole switch
⇒ It is desired to evaluate the expression
⇒ A dynamometer wattmeter can be used for
dc only
ac only
dc and 50 Hz ac
dc and high frequency ac
⇒ In a multicavity klystron amplifier the signal to be amplified develops an ac voltage of signal frequency across the gap in buncher cavity
TRUE
FALSE
⇒ A dual trace CRO has
one electron gun
two electron guns
one electron gun with one two pole switch
two electron guns with one two pole switch
⇒ It is desired to evaluate the expression
F = B * COS (Y) + C * SQR (COS (Y) + A * COS (Y) * COS (Y) * COS (Y)
F = B * COS (Y) + C * SQR [COS (Y)] + A * COS (Y) * SQR [COS (Y)]
F = B * COS (Y) + C * COS(Y) * COS (Y) + A * COS (Y) * COS (Y) * COS (Y)
X = COS(Y)
⇒ RC network shown in the given figure can provide a maximum theoretical phase shif
90°
180°
270°
360°
⇒ In a digital counter the number of flip-flops is
always 2
always even
always odd
equal to the number of bits required in the final binary count
⇒ Which one of the following is true for EM wave propagation through rectangular waveguide of cross-section 2a x a
critical wavelength for TE_{10} mode is the same as that for TE_{02} mode
critical wavelength for TE_{10} mode is one half of that for TE_{10} mode
critical wavelength for TE_{10} mode is the same as that for TM_{10} mode
critical wavelength for TE_{10} mode is double that for TE_{01}mode
⇒ An RF carrier of 12 kV at 1 MHz is amplitude modulated by 1 kHz signal having peak value of 6 kV. The modulation pattern is seen on CRO screen. The voltage indicated will be
18 kV
1.001 kV
6 kV
36 kV
⇒ For real and odd signals, the Fourier series coefficient a_{k} is __________ .
purely imaginary and even
purely real and even
purely imaginary and odd
purely real and odd
⇒ In CCIR-B system, the time between start of one H syn. pulse and next is
64 μs
6.4 μs
640 μs
0.64 μs
⇒ The signal input to a given amplifier is made up of 100 mΩ signal power and 1 mΩ noise power. The amplifier contributes an additional 100 mΩ of noise and has a power gain of 20 dB. The output signal-to-noise ratio is
100
50
10
5
⇒ The modulation index of a narrowband FM signal is
nearly equal to 0.3
much less than unity
nearly 0.5
much more than unity
⇒ When the modulating frequency is doubled, the modulation index is halved and the modulating voltage remains constant. The modulation system is
FM
AM
phase modulation
none of the above
⇒ Find R_{TH} across the terminals A a
52.28 Ω
58.28 Ω
52.82 Ω
58.82 Ω
⇒ A voltage tripler circuit uses
2 diodes and 2 capacitors
3 diodes and 3 capacitors
2 diodes and 3 capacitors
3 diodes and 2 capacitors
⇒ A choke coil has a resistance to reactance ratio of 0.2. The power factor of the choke coil is
less than 0.2 lagging
less than 0.2 leading
about 1
about 0
⇒ If input frequency is 50 Hz, the frequency of output wave in a full wave diode rectifier circuit is
25 Hz
50 Hz
100 Hz
200 Hz
⇒ FM broadcast is used in
VHP range
UHF range
MF range
both VHP and UHF range
⇒ The primary function of a clamper circuit is to
suppress variations in signal voltage
raise +ve half cycle to the signal
Lower -ve half cycle of the signal
introduce a dc level into an a.c. signal
⇒ The signal cos ω_{c}t + 0.5 cos ω_{m}t sin ω_{c}t is
FM only
AM only
both AM & FM
neither AM nor FM
⇒ Programs like compilers, assemblers etc. are stored in a mircocomputer in
registers
cache memory
primary memory
mass storage
⇒ Norton's theorem reduces a two terminal network to
a constant current source and an impedance is parallel
a constant current source and an impedance in series
a constant voltage source and an impedance in parallel
a constant voltage source and an impedance in series
⇒ If A = 629 ± 8 and B = 131 ± 3, A - B with range of doubt is
498 ± 8
498 ± 4
498 ± 11
498 ± 13
⇒ FET amplifier is more difficult to analyse than BJT amplifier.
TRUE
FALSE
⇒ In band III of TV, distant reception (beyond line of sight range) is possible due to
tropospheric bending by refraction
reflection of waves
ionospheric scattering
none of the above
⇒ The width of air gap on recording head in a tape recorder is about
6 micron
3 micron
1 micron
25 micron
⇒ Curl of gradient A is
∇ x (∇A) = 1
∇ x (∇A) = ∞
∇ x (∇A) = 0
∇ x (∇A) = - ∞
⇒ For the circuit of the following figure, with an ideal op-amp, the maximum phase shift of the output with reference to the input
0°
90°
-90°
± 180°
⇒ For a transistor if a_{dc} = 0.98 and emitter current I_{E} is 2 mA, then base current will be
10 μA
40 μA
80 μA
200 μA
⇒ In VHS format width of audio track is
5 mm
2 mm
1 mm
0.1 mm