Question is ⇒ The series element of a band stop filter is, Options are ⇒ (A) capacitive, (B) inductive, (C) parallel combination of L and C, (D) series combination of L and C, (E) , Leave your comments or Download question paper.

Question is ⇒ The series element of a band stop filter is, Options are ⇒ (A) capacitive, (B) inductive, (C) parallel combination of L and C, (D) series combination of L and C, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The series element of a band stop filter is
A.	capacitive [Wrong Answer]
B.	inductive [Wrong Answer]
C.	parallel combination of L and C [Correct Answer]
D.	series combination of L and C [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Nichrome is used for
overhead line wires
heater coils
lamp filaments
all of the above

⇒ The total bandwidth needed for an AM signal at 55.25 MHz with 0.5 MHz video modulation is
0.25 MHz
0.5 MHz
1 MHz
10 MHz

⇒ The output wave of a cycloconverter consists of a number of segments derived from the input wave.
TRUE
FALSE

⇒ A + (B . C) =
A . B + C
A . B + A . C
A
(A + B) . (A + C)

⇒ The unit for mmf is
A
Wb
T
V

⇒ A satellite that simply reflect back the signals from one region of the earth to the other region is known as
orbiting satellite
geostationary satellite
active satellite
passive satellite

⇒ If B is the bandwidth, the thermal noise voltage is proportional to
B
B^0.5
B^1.5
B²

⇒ In a coupled coil the primary has 100 turns and secondary has 200 turns. The primary produces, a flux Φ = e^-t. The coefficient of coupling is 1. The voltages induced in secondary is
200 e^-t V
200 e^t V
200 V
none of the above

⇒ On the basis of the type of chemical bonds, solids may be classified into
ionic crystals
ionic and valence crystals
ionic crystal, valence crystals and metals
ionic crystals, valence crystals, metal and vander wall crystals

⇒

Assertion (A): In the circuit shown figure the diode is used to protect the active devices. Transistor T goes into saturation when a positive pulse is applied at base and non conducting

Reason (R): When the current in an inductor is suddenly stopped, a high voltage is induced across
Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In a Vidicon camera tube
grid G₁ accelerates electrons
grid G₂ accelerates electrons and grid G₃, slows down electrons
grid G₃ accelerates electrons and grid G₂ slows down electrons
both grids G₂ and G₃ accelerate electrons

⇒ An antenna array pattern is to used for increasing
gain
directivity
directive gain
all

⇒ For a resistance of about 15 kΩ operating in a frequency range of a few MHz, the noise voltage is in the range of
a few μV
about 100 μV
a few μV
a few volts

⇒ FIR filter Passes __________ Phase.
non-linear phase
linear phase
variable phase
none

⇒ Power gain of antenna equals directive gain in VHF and UHF range if and only if efficiency of the antenna is __________ .
0.25
0.5
0.75
1

⇒ As compared to AM, FM requires
narrow channel
same channel
2 to 3 times as large channel
7 to 15 times as large channel

⇒ In a 4 input AND gate, the total number of High outputs for 16 input states are
16
8
4
1

⇒ A coil has a resistance of 2 Ω and inductance of 0.1 mH. The applied voltages is suddenly increased from 10 V to 20 V. After steady state condition have reached, the current is
0.0833333333333333
more than 2 A but less than 4 A
0.166666666666667
more than 4 A

⇒ Figure of merit is always unity in
AM
SSB-SC
FM
All

⇒ A bipolar transistor is a __________ controlled devices whereas a FET is a __________ controlled devices.
current, voltage
current, current
voltage, current
voltage, voltage

⇒ In equally tampered musical scale, an octave is divided into
12 intervals
10 intervals
7 intervals
5 intervals

⇒ Microwave signals follow the curvature of the earth and the phenomenon
tropospheric scatter
faraday effect
duct propagation
none

⇒ Fourier transform of f(t) =
jω F(f)
2pf F(f)
F'(f)
None

⇒ The electric field on the surface of a perfect conductor is 2V/m. The conductor is immersed in water with ε = 80 ε₀. The surface charge density on the conductor is ((ε₀ = 10^-9/36p)F/m)
0 c/m²
2 c/m²
1.8 x 10^-11 c/m²
1.14 x 10^-9 c/m²

⇒ Maximum usable frequency is [f_muf]
f_c sec i
f_c cos i
f_c sin i
f_c sec i

⇒ A parallel RLC circuit has ω₀ = 10⁶ and Q = 30, Given C = 30 pF, the value of R is
0
1 μΩ
2 MΩ
1 MΩ

⇒ A sinusoidal carrier voltage, having frequency 1000 Hz is amplitude modulated by a sinusoidal voltage of frequency 15 kHz. The frequency of upper and lower sidebands will be
1015 kHz and 985 kHz
1030 kHz and 970 kHz
13 kHz and 17 kHz
14 kHz and 16 kHz

⇒ In Java it is possible to have

Which of the above are correct?
All
1, 2 and 3 only
1 and 2 only
1, 3 and 4 only

⇒ The drain characteristics of JFET in operating region, are
inclined upwards
almost flat
inclined downwards
inclined upwards or downwards

⇒ An RC driving point impedance function has zeros at s = - 2 and s = - 5. The admissible poles are
s = 0 and s = -6
s = -1 and s = -3
s = 0 and s = -1
s = -3 and s = -4