Question is ⇒ If temperature increases by about 50°, the resistance of thermistor changes to, Options are ⇒ (A) half of its initial value, (B) twice of its initial value, (C) eight times of its initial value, (D) one eight of its initial value, (E) , Leave your comments or Download question paper.

Question is ⇒ If temperature increases by about 50°, the resistance of thermistor changes to, Options are ⇒ (A) half of its initial value, (B) twice of its initial value, (C) eight times of its initial value, (D) one eight of its initial value, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If temperature increases by about 50°, the resistance of thermistor changes to
A.	half of its initial value [Wrong Answer]
B.	twice of its initial value [Wrong Answer]
C.	eight times of its initial value [Wrong Answer]
D.	one eight of its initial value [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The log magnitude curve of factor jω is a straight line having a slope of 20 dB/decade.
TRUE
FALSE

⇒ The directive gain of a transmitting antenna is proportional to
its cross-sectional area
square of cross-sectional area
square root of cross-sectional area
cube root of cross-sectional area

⇒ Which of the following statements is incorrect?
A mesh with two resistors has two mesh currents
The algebraic sum of all voltages around any mesh or any loop must be zero
The principle node is a function where branch current can divide or combine
A Norton is a series circuit

⇒ Which of the following alphanumeric characters is not allowed in Basic?
capital letters A to Z
lower case letters a to z
digits 0 to 9
special characters +, -, *, / etc

⇒ Consider the following applications

Switch
Attenuator
Phase shifter
Oscillator

In which of the above can a PIN diode be used?
1 2 3 and 4
1 2 and 3 only
1 and 2 only
2, 3 and 4 only

⇒ Three impedances (3 + j 4) Ω each are connected in star. The impedances of equivalent delta circuit will be
3 - j 4 Ω each
9 + j 12 Ω each
9 - j 12 Ω each
3 + j 4, 3 - j 4 and 4 - j 3 Ω

⇒ A three-section RC phase shift oscillator has R = 10K ohms and C = 0.001 μF. The frequency of oscillations is
1.1 kHz
2.5 kHz
3.3 kHz
6.5 kHz

⇒ Two coils are connected in parallel. Their fluxes are adding. If the connections of one of the coils are reversed, the total inductance of the arrangement
will decrease
may increase or decrease
will remain the same
will increase

⇒

Assertion (A): A high dv/dt may cause triggering of a thyristor.

Reason (R): A high dv/dt results in charging current in the thyristor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Consider following statements :

Maximum energy of electrons liberated photoelectrically is independent of light intensity
Maximum energy of electrons liberated photoelectrically varies nonlinearly with frequency of incident light.

statement (1) is true and (2) is false
statement (1) and (2) both are true
statement (1) is false and (2) is true
statement (1) and (2) both are false

⇒ Higher order active filters are used for variable
bandwidth
gain in the pass band
impedance
roll off rate

⇒ Let f₁(t) = G₁(t) + 4, f₂(t) = G₂(t) + 3. If G₁(t) and G₂(t) are uncorrected then the correlation between f₁(t) and f₂(t) are
12
7
6
zero

⇒ Computers use thousands of flip-flops. To coordinate the overall action, a common signal is sent to all flip-flop known as
debug signal
toggle signal
active signal
clock signal

⇒ Fields are said to be circularly polarised if their magnitudes are
equal and they are in phase
equal but they differ in phase by ± 90°
unequal and differ in phase by ± 90°
unequal but are in phase

⇒ Stability factor for S is given by for a fixed bias
1 + β
1 - β
1/β
β - 1

⇒ If frames are repeated at 60 Hz and each frame has 525 lines, the time for scanning one horizontal line (for progressive scanning and no interlacing) is about
320 μs
32 μs
3.2 μs
0.32 μs

⇒ The refractive index of E layer, if angle of incidence is 30°
0.5
0.25
0
1

⇒ The inputs to a 4 channel MUX have the following bandwidths. Channel 1-50 Hz, channel 2-200 Hz. Channel 3-75 Hz. Channel 4-90 Hz. The theoretical minimum sampling rate of the MUX is
200 Hz
400 Hz
415 Hz
1600 Hz

⇒ A ramp input applied to a unity feedback system results in 5% steady state error. The type number and zero frequency gain of the system are respectively.
1 and 20
0 and 20
0 and 1/20
1 and 1/20

⇒ Polarization is a measure of
dielectric constant per unit volume
voltage gradient to produce electrical breakdown
product of charge and distance
excess charge density

⇒ In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. The image frequency at 1000 kHz will be
1010 kHz
1455 kHz
1910 kHz
545 kHz

⇒ As the temperature of an intrinsic semiconductor material is increased
additional holes are created in the conduction band
protons get excited
protons acquire charge
energy of the atom is increased

⇒ Which of the following is a computer language?
MS WORD
Page maker
MS EXCEL
LISP

⇒ If the iron core of a coil is removed so that it becomes an air cored coil, its inductance
will increase
will decrease
will remain the same
may increase or decrease

⇒

Assertion (A): An op-amp has high voltage gain, high input impedance and low output impedance

Reason (R): Negative feedback increases output impedance

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A ground wave travels along surface of ground.
TRUE
FALSE

⇒ The 'h' parameters of the circuit shown in the figure are h_ib = 25 Ω, h_fb = 0.999 and h_ob = 10^-6Ω The Voltage gai
0.99
1.98
2
4

⇒ For static electric and magnetic fields in an homogenous source-free medium, which of the following represents the correct form of Maxwell's equations?
Δ.E = 0
Δ.E = 0
Δ x E = 0
Δ x E = 0

⇒ If the repeller voltage in a klystron oscillator is increased the transit time of electron
will be increased
will be decreased
will remain the same
either (a) or (b)

⇒ In the above case if the modulating frequency is increased to 20 kHz the bandwidth will be
0.05 MHz
1 MHz
2 MHz
4 MHz