Question is ⇒ Gain stability in an oscillator can bs achieved by, Options are ⇒ (A) providing negative feedback, (B) providing positive feedback, (C) using low Q circuits, (D) controlling the gain, (E) , Leave your comments or Download question paper.

Question is ⇒ Gain stability in an oscillator can bs achieved by, Options are ⇒ (A) providing negative feedback, (B) providing positive feedback, (C) using low Q circuits, (D) controlling the gain, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Gain stability in an oscillator can bs achieved by
A.	providing negative feedback [Wrong Answer]
B.	providing positive feedback [Wrong Answer]
C.	using low Q circuits [Wrong Answer]
D.	controlling the gain [Correct Answer]
View Answer 1 -3 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Match the following:

	List I		List II
A.	Wein bridge oscillator	1.	Low output impedance
B.	Voltage shunt feedback amplifier	2.	RF frequency range
C.	Crystal oscillator	3.	Audio frequency range
D.	Current shunt feedback amplifier	4.	High input impedance
		5.	High output impedance

A-3, B-1, C-2, D-5
A-3, B-5, C-1, D-2
A-4, B-3, C-1, D-2
A-5, B-1, C-2, D-1

⇒ In the following figure C = 0.02 μF, and V_th is known to be of frequency ω = 10⁷ rad/sec and r_d = 2.5 Ω and Z_Th = R_Th = 10 Ω Then phase angle between i_d and V_{d26.5°
25°
30°
0°}

⇒ For the waveform shown below, the slew rate and full power bandwidth with respect to op-amp will be respecti
0.02 V/μsec, 1.59 KHz
0.04 V/μsec, 1.59 KHz
0.02 V/μsec, 3.58 KHz
0.02 V/μsec, 1.59 KHz

⇒ Consider the following rules for constructing variable names in C

It can have alphabets, digits or underscores but no other special character.
The maximum number of characters is 8.
The first character may be an alphabet or digit but not underscore.

Which of the above are correct?
All
1 and 2 only
1 and 3 only
2 and 3 only

⇒ Emitter follower is in which of following configuration.
common Base
common Emitter
common collector
common Base or common Emitter

⇒ The amplifier used in bootstrap voltage sweep should have a gain of
1
+∞
-1
-∞

⇒ Electrons within a metal have energy levels from zero to Fermi level E_F.
TRUE
FALSE

⇒ In a semi converter feeding a resistive load
the waveshapes of output voltage and output current are exactly similar
the waveshapes of output voltage and output current can not be similar
the waveshapes of output voltage and output current are similar only for low values of firing angle
the waveshapes of output voltage and output current may be similar or dissimilar

⇒ When three 100 K, ± 10% fixed resistors of 1/4 W Power rating are connected in parallel, the resulting 33 K resistor will have a tolerance specification and power rating of
± 10% and 3/4 W respectively
± 10% and 1/12 W respectively
± 3.3.% and 3/4 W respectively
± 30% and 3/4 W respectively

⇒ The function Z(s) has a pole at infinity if
the degree of numerator and denominator of Z(s) are equal
the numerator of Z(s) is one degree higher than denominator
the denominator of Z(s) is one degree higher than numerator
the degree of numerator and denominator are either equal or differ by one

⇒ The relative permeability is taken as unity for which of the following?
Air
Cobalt
Vacuum
Bismuth

⇒ An FM radio receiver which is tuned to a 91.6 MHz broadcast station may receive an image frequency of __________ MHz.
102.3
113
70.2
80.9

⇒ The maximum temperature limit of class B insulation is
90°C
105°C
120°C
130°C

⇒ In a PCM the amplitude levels are transmitted in a 7 unit code. The no. of levels is
18
14
128
64

⇒ The polar plot of transport lag is a unit circle.
TRUE
FALSE

⇒ If the input to the ideal comparator shown in the figure is a sinusoidal signal of 8 V (peak to peak) without any DC component, then the output of the comparator has a duty cycl
42737
42738
42741
42747

⇒ Subroutines are used in larger programs not
to increase the programming case
to reduce storage equipment
to reduce program extension time
for ease of program testing at the program development time

⇒ A vibration galvanometer is a
moving coil instrument
moving iron instrument
dynamometer instrument
induction instrument

⇒

Assertion (A): The function δ'(t - b) is equal to 0 for t ≠ b

Reason (R): A number of impulses spaced from one another form an impulse train.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A h is the unit of quantity of electricity.
TRUE
FALSE

⇒ In the series circuit shown in figure, for series resonance, the value of the coupling coefficient, K wil
0.25
0.5
0.1
1

⇒ Which statement is false as regards holes
Holes exist in conductors as well as semiconductors
Holes constitute positive charges
Holes exist only in semiconductors
Holes and electrons recombine

⇒ A 360 W carrier is simultaneously modulated by two audio wave with modulation percentage of 55 and 65 respectively. Total sideband power radiated will be
500 W
360 W
180 W
130 W

⇒ Given I_s = 20 A, V_s = 20 V, the current I in the 3 Ω resistance is give
0.166666666666667
0.333333333333333
0.0833333333333333
16 A

⇒ Consider the following statem
2 and 3
1 only
2 and 4
none

⇒ An inverting amplifier has R₁ = 10 kΩ, and R_f = 150 kΩ then the O/P voltage, if input voltage V_i = 1 volt.
-15 V
-10 V
15 V
-14 V

⇒ If we manage to __________ our natural resources, we would leave a better planet for our children.
uphold
restrain
Cherish
conserve

⇒ In a JFET, the drain current is maximum when
V_GS = V_DS
V_GS = pinch off voltage
V_GS = 0
V_GS is negative

⇒ Beamwidth (between first nulls) will be for an antenna at 3 MHz with directivity of 100
140°
70°
210°
60°

⇒ A communication satellite is a repeater between
a transmitting station and a receiving station
a transmitting station and many receiving station
many transmitting station and many receiving station
none