Question is ⇒ In the given figure A = 1, B = 1. B is now changed to a sequence 101010................The outputs X and Y wil, Options are ⇒ (A) fixed at 0 and 1 respectively, (B) X = 1010.......and Y = 0101........, (C) X = 1010..........and Y = 1010, (D) fixed at 1 and 0 respectively., (E) , Leave your comments or Download question paper.

Question is ⇒ In the given figure A = 1, B = 1. B is now changed to a sequence 101010................The outputs X and Y wil, Options are ⇒ (A) fixed at 0 and 1 respectively, (B) X = 1010.......and Y = 0101........, (C) X = 1010..........and Y = 1010, (D) fixed at 1 and 0 respectively., (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the given figure A = 1, B = 1. B is now changed to a sequence 101010................The outputs X and Y wil
A.	fixed at 0 and 1 respectively [Correct Answer]
B.	X = 1010.......and Y = 0101........ [Wrong Answer]
C.	X = 1010..........and Y = 1010 [Wrong Answer]
D.	fixed at 1 and 0 respectively. [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If p is the probability of success and q is the probability of failure, then the probability that there are r successes in n trails is
ⁿc_r p^r qⁿ ^- ^r
ⁿc_r p^{n -} ^r q^r
ⁿc_r p^r qⁿ ⁺ ^r
ⁿc_r pⁿ qⁿ ^{- r}

⇒ A FET has
very high input resistance
very low input resistance
high connection emitter junction
forward biased PN junction

⇒ Pentavalent impurity creates n type semiconductor.
TRUE
FALSE

⇒

Match the following:

	List I		List II
A.	GTO	1.	Widely used in digital computers
B.	UJT	2.	Used for freewheeling
C.	Power Diode	3.	Can be turned off by negative gate signal
D.	MOSFET	4.	Used in generating triggering pulses

A-1, B-2, C-3, D-4
A-4, B-2, C-3, D-1
A-3, B-4, C-2, D-1
A-2, B-1, C-3, D-4

⇒ In a transistor receiver, the use of FET as the first stage amplifier is likely to
improve selectivity of the receiver
improve the effectiveness of the AGC
reduce the effect of negative peak clipping
reduce the effect of noise at all frequencies

⇒ Parallel adder is
sequential circuit
combinational circuit
either sequential or combinational circuit
none of the above

⇒ One of the advantages of base modulation over collector modulation in a class C transistor amplifier is
higher efficiency
more linear operation
more power output per transistor
lesser requirement of modulating power

⇒ In a single phase full wave controlled rectifier using centre tap transformer, the voltage across each half of secondary is V_m sin ωt. The peak inverse voltage is
2 V_m
V_m
0.5 V_m
0.25 V_m

⇒ The term __________ applies to troposcatter propagation
fading
Faraday rotation
SIDS
atmospheric storms

⇒ Following is a reason of distortion in communication system
external interference
random variations
insufficient Channel Bandwidth
all

⇒ In FSK no synchronous carrier is needed at the receiver
TRUE
FALSE
depend on distance
none

⇒ A person with a receiver is 5 km away from the transmitter. What is the distance that this person must move further to detect at 3 dB decrease in signal strength?
942 m
2070 m
4978 m
5320 m

⇒ An RLC series circuit has R = 8 Ω, X_L = 8 Ω and X_C = 8 Ω Its impedance is
8 + j 16 Ω
8 + j 8 Ω
8 Ω
24 Ω

⇒ Tesla is unit of
Φ
B
H
MMF

⇒ The divergence of a vector is a scalar, while the curl of a vector is another
scalar
vector
unit vector
none of the above

⇒ Which of the following instructions in 8085 does not belong to data transfer group?
LDA addr
STA addr
XCHG
SUB r

⇒ Consider the following logical IF statement in Fortran 77 IF (SALT - PEPPER) 11, 11, 13
IF (SALT - PEPPER) 13, 11, 11
IF (SALT - PEPPER) 13, 13, 11
IF (SALT - PEPPER) 11, 13, 13

⇒ A square current wave of magnitude 1 A is applied to an element for 5 seconds. The voltage across the element rises linearly from 0 to final value linearly. The element is
resistance
inductance
capacitance
R and C in series

⇒ The maximum percent overshoot with maximum value of first overshoot as 3.5 V and steady state value as 2.575 V is
0.3592
0.2643
0.5761
0.1524

⇒ In a transistor which of the following region is very lightly doped and is very thin?
Emitter
Base
Collector
None of the above

⇒ Some typical examples of macroscopic quantities are
conductivity
µ_r
dielectric constant
all of the above

⇒ A differential amplifier is invariably used in the I/P stage of all OP-amps. This is done basically to produce the OP-amp with a very high.
CMRR
bandwidth
slew rate
open-loop gain

⇒ The current in an RL series circuit is 1 - e^-t amperes. Then di/dt is
1 - e^-t
- e^-t
e^t
e^-2t

⇒

Assertion (A): An ideal rectifier should have unity harmonic factor

Reason (R): An ideal rectifier should have unity displacement factor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Consider the following statements for a driving point function F(jω):

Re F(jω) is an even function of ω and is 0 or positive for all values of ω.
Im F(jω) is an even function of ω and is 0 or positive for all values of ω.
Re F(jω) is an odd function of ω and is 0 or negative for all values of ω.
Re F(s) = 0 for Re s = 0.

Which one of the statements given above is/are correct?
1 only
1 and 4
2, 2 and 4
4 only

⇒ A 12-bit binary counter has the following state. The octal number represente
677
7163
7128
7183

⇒

Match the following:

	List I (Camera pick up tubes)		List II (Special feature)
A.	Vidicon	1.	Highest sensitivity
B.	Plumbicon	2.	Temperature sensitive
C.	Saticon	3.	Large lag
D.	New vicon	4.	Special target for red response

A-4, B-3, C-2, D-1
A-1, B-2, C-3, D-4
A-3, B-4, C-2, D-1
A-4, B-3, C-1, D-2

⇒ Two resistors R₁ = 36 Ω ± 5% and R₂ = 75 Ω ± 5% are connected in series. The total resistance is
111 ± 0 Ω
111 ± 2.778 Ω
111 ± 5.55 Ω
111 ± 7.23 Ω

⇒ The number of lobes on each side of a 31 resonant antenna will be
2
3
4
6

⇒ Which one is digital modulation technique?
AM
PAM
PCM
None