Question is ⇒ What is typical bandwidths of a 2-wire telephone line?, Options are ⇒ (A) 300 Hz to 3.4 kHz, (B) 20 Hz to 4 kHz, (C) dc to 4 kHz, (D) 20 Hz to 20 kHz, (E) , Leave your comments or Download question paper.

Question is ⇒ What is typical bandwidths of a 2-wire telephone line?, Options are ⇒ (A) 300 Hz to 3.4 kHz, (B) 20 Hz to 4 kHz, (C) dc to 4 kHz, (D) 20 Hz to 20 kHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	What is typical bandwidths of a 2-wire telephone line?
A.	300 Hz to 3.4 kHz [Correct Answer]
B.	20 Hz to 4 kHz [Wrong Answer]
C.	dc to 4 kHz [Wrong Answer]
D.	20 Hz to 20 kHz [Wrong Answer]
View Answer 2 -5 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If a number of even functions are added, the resultant sum is
even function
odd funtion
either even or odd function
mixture of odd amd even functions

⇒ The equation v(t) = A cos [ω_ct + φ(t)] where A and ω_c are constant and φ(t) is a function of base signal represents

Phase modulation
Amplitude modulation
Angle modulation
Frequency modulation

Which of the above are true?
3 only
1, 3 and 4
1, 2, 3, 4
3 and 4 only

⇒ A register is
a group is memories
a group of devices that store digital data
a chip used in computers
a pure silica piece used in digital systems

⇒ In the above case if the modulating frequency is increased to 20 kHz the bandwidth will be
0.05 MHz
1 MHz
2 MHz
4 MHz

⇒

Match the following:

	List I (Diode Rectifier)		List II (Efficiency is R_f/R_L = 0.25)
A.	Half wave	1.	0.54
B.	Bridge Rectifier	2.	0.65
C.	Full wave using tapped centre transformer	3.	0.325

A-1, B-2, C-3
A-2, B-1, C-3
A-3, B-2, C-1
A-3, B-1, C-2

⇒ Schering bridge operates at a high voltage of about 10 kV.
TRUE
FALSE

⇒ In a specimen of cast iron, a field strength of 400 AT/m cause a flux density of 0.6 T. In a specimen of silicon steel, the same value of H would cause B to be
0.6 T
more than 0.6 T
less than 0.6 T
0.6 T or less than 0.6 T

⇒ As the temperature of an intrinsic semiconductor material is increased
additional holes are created in the conduction band
protons get excited
protons acquire charge
energy of the atom is increased

⇒ The equation sin (z) = 10 has
no real or complex solution
exactly two distinct complex solutions
a unique solution
an infinite number of complex solutions

⇒ The density of dynamic RAM is
the same as static RAM
less than that of static RAM
more than that of static RAM
either equal or less than that of static RAM

⇒ Self impedance is
same for transmitting (T_t) and receiving antenna (T_r)
T_t > T_r
T_r > T_t
no relation

⇒ A single phase cycloconverter with centre tapped input transformer requires
2 thyristors
4 thyristors
8 thyristors
either 2 or 4 thyristors

⇒ A transistor has two p-n junctions. The batteries should be connected such that
both junctions are forward biased
both junctions are reverse biased
one junction is forward biased and the other is reverse biased
none of the above

⇒ Consider a Binary Symmetric Channel (BSC) with probability of error being p. To transmit a bit, say 1, we transmit a sequence of three 1 s. The receiver will interpret the received sequence to represent 1 if at least two bits are 1. The probability that the transmitted bit will be received in error is
p³ + 3p² (1 - p)
p³
(1 - p)³
p³ + p² (1 -p)

⇒

Assertion (A): In an op-amp the voltage gain and band width can be adjusted as per requirement

Reason (R): Large value capacitor can also be fabricated on a chip

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Examine the following statements

Air and gases are compressible.
Air, gases and some liquids are compressible.
Oil can function as hydraulic fluid as well as lubricator.

Which of the above statements are correct?
3 only
2 and 3 only
1 and 3 only
2 only

⇒ Which of the following operations will give the result 2 in C?
42857
4.0 / 2
4.0 / 2.0
4 / 2.0

⇒ The emission of light is LED due to
emission of holes
emission of electrons
generation of electromagnetic radiations
conversion of heat energy into illumination

⇒ In a base driver amplifier the voltage gain is the ratio of
ac collector voltage to ac base voltage
ac emitter voltage to ac base voltage
ac collector voltage to ac emitter voltage
ac base voltage to ac emitter voltage

⇒ Which of them radiates emission?
LED only
LCD only
Both LED and LCD
Neither LED nor LCD

⇒ The stray capacitance between the last stage and the first stage of an oscillator may cause
unwanted low frequency oscillations
unwanted high frequency oscillations
unwanted oscillations at low and high frequencies
large feedback

⇒ DC tachogenerator can be used in
speed control system
position control system
both (a) and (b)
neither (a) nor (b)

⇒ In a single phase full wave regulator feeding an R-L load, the power factor angle of load is θ. The range of control of firing angle a is
0 ≤ a ≤ p
θ ≤ a ≤ p
0 ≤ a ≤ (p - θ)
θ ≤ a ≤ (p + θ)

⇒ A buffer is
always non-inverting
always inverting
inverting or non-inverting
none of the above

⇒ In the network of figure it is desired that maximum power be supplied to Z₂. The values of Z₁ and Z₂ are fixed. However the transformation ratio 'a' of transformer can be changed. The value of 'a' for maximum power transfe
|Z₂|/|Z₁|
[|Z₂|/|Z₁|]^0.5
[|Z₂|/|Z₁|]²
[|Z₂|/|Z₁|]^0.75

⇒ When the phase velocity of an EM wave depends on frequency in any medium the phenomenon is called
scattering
polarisation
absorption
dispersion

⇒ The important postulate arising out of Maxwell's modification of Ampere's law is
a changing magnetic field produces an electric field
a changing electric field produces a magnetic field
a motional e.m.f. is produced by a coil moving in a magnetic field
a steady current produce a magnetic field

⇒ If frames are repeated at 60 Hz and each frame has 525 lines, the time for scanning one horizontal line (for progressive scanning and no interlacing) is about
320 μs
32 μs
3.2 μs
0.32 μs

⇒ The time constant of the network shown in figur
2 RC
5/3 RC
RC/2
None of these

⇒ Which of the following statement regarding the advantages of the phase discriminator over the slope detector is false?
Better linearity
Fewer tuned circuits
Much easier alignment
Greater limiting