Question is ⇒ The maximum current and voltage ratings for a 0.5 W, 10 kW resistor are, Options are ⇒ (A) 7.07 mA and 70.7 V, (B) 70.7 mA and 70.7 V, (C) 0.707 mA and 70.7 V, (D) 7.07 mA and 70.7 x 10<sup>3</sup> V, (E) , Leave your comments or Download question paper.

Question is ⇒ The maximum current and voltage ratings for a 0.5 W, 10 kW resistor are, Options are ⇒ (A) 7.07 mA and 70.7 V, (B) 70.7 mA and 70.7 V, (C) 0.707 mA and 70.7 V, (D) 7.07 mA and 70.7 x 10<sup>3</sup> V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The maximum current and voltage ratings for a 0.5 W, 10 kW resistor are
A.	7.07 mA and 70.7 V [Correct Answer]
B.	70.7 mA and 70.7 V [Wrong Answer]
C.	0.707 mA and 70.7 V [Wrong Answer]
D.	7.07 mA and 70.7 x 10³ V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Some types of traps used in video IF amplifier of colour TV are
shunt traps
series traps
absorption traps
all of the above

⇒ As the temperature of a pure silicon specimen is increased
the number of free electrons increases
the number of holes decreases
the number of holes increases
the number of free electrons and holes increases

⇒ In the decimal number 27, the digital 2 represents
2
20
0.2
200

⇒

Assertion (A): An on off controller gives rise to oscillation of the output between two limits.

Reason (R): Location of a pair of poles on jω axis gives rise to self sustained oscillations in the output.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ A single phase full converter gives maximum and minimum output voltage at firing angles of
0 and 180° respectively
180° and 0° respectively
0 and 90° respectively
90° and 0° respectively

⇒ In high power radars, which of the following are used for switching?
Power diode
Power BJT
Power MOSFET
Thyristor

⇒ Refraction of electromagnetic waves occurs when they
pass through a small slot in a conducting plane
pass into a medium of different dielectric constant
are polarized at right angles to the direction of propagation
encounter a perfectly conduction surface

⇒ Generally op amp is used in
open loop
closed loop
cascaded loop
either (a) or (c)

⇒ When a pentavalent impurity is added, the semiconductor becomes
p type
n type
intrinsic
neutral

⇒ In which function is each term known as maxterm?
SOP
POS
Hybrid
SOP and Hybrid

⇒ Which one of the following is used to change data from spatial code to temporal code?
Shift register
Counter
A/D converters
Combinational circuits

⇒

Match the following:

	List I		List II
A.	bit	1.	10
B.	nat	2.	e
C.	decit	3.	2

A-1, B-2, C-3
A-1, B-3, C-2
A-3, B-2, C-1
A-2, B-3, C-1

⇒ Which of the following are true for magic tee in the given figure select the answer as per given c
1, 2 and 3
1, 2 and 4
2, 3 and 4
1, 3 and 4

⇒ In a composite filter terminating half sections are used for impedance matching.
TRUE
FALSE

⇒ Which one of the following is not a characteristic of a ferroelectric material?
High dielectric constant
No hysteresis
Ferroelectric characteristic only above the curie point
Electric dipole moment

⇒ Some features of RF stage in good radio receivers is

It increases sensitivity by providing amplification to RF signal
It eliminates image frequency interference
It increases selectivity
It reduces noise level

Which of the above are true?
1, 2 and 3 only
1, 2 and 4 only
2, 3, 4 only
1, 2, 3, 4

⇒ The resolution of 4 bit counting ADC is 0.5 volt, for an Analog input of 6.6 volts. The digital output of ADC will be
1011
1101
1100
1110

⇒ Power gain of an antenna in a given direction is the ratio of
average power to maximum power
radiation intensity in that direction to the total input radiated power
radiation intensity in that direction to the average radiated power
none of the above

⇒ Assuming V_{CE sat} = 0.2 V and β = 50, the minimum base current (I_B) required to drive the transistor in the given figure to saturatio
56 μA
140 μA
60 μA
3 μA

⇒ In satellite communication, frequency modulation is used because satellite channel has
small bandwidth and negligible noise
large bandwidth and severe noise
maximum bandwidth and minimum noise
high modulation index

⇒ A system has 12 poles and 2 zeros. Its high frequency asymptote in its magnitude plot has a slope of
-200 dB/decade
-240 dB/decade
-280 dB/decade
-320 dB/decade

⇒ A negative-feedback closed-loop system is supplied to an input 5 V. The system has a forward gain of 1 and a feedback gain of 1 and a feedback gain of 1. What is the output voltage?
1.0 V
1.5 V
2.0 V
2.5 V

⇒ In free space
phase velocity is greater than light velocity
phase velocity is equal to group velocity
phase velocity is equal to light velocity
Both (b) and (c)

⇒

Match the following:

	List I		List II
A.	Tangent galvanometer	1.	Can be used for dc only
B.	Moving coil instrument	2.	Integrating instrument
C.	Household energy meter	3.	Used for voltage measurement only
D.	Electrostatic instrument	4.	Absolute instrument

A-1, B-2, C-3, D-4
A-4, B-1, C-2, D-3
A-1, B-2, C-4, D-3
A-4, B-1, C-3, D-2

⇒ A battery charger can drive a current of 5A with 1Ω resistance connected at its output. If it can charge 2 V battery at 7 A rate, its Thevenin's equivalent circuit will be
7.5 in series with 0.5 Ω resistance
1.25 V in series with 1.5 Ω resistance
7.5 V in parallel with 0.5 Ω resistance
12.5 V in parallel with 1.5 Ω resistance

⇒

Assertion (A): The wave shown in the given figure does not contain the dc component and even harmo
Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The number of LED display indicators in logic probe are
1
2
1 or 2
4

⇒ L [f(t - a)] = F(jω) e^-jωa
TRUE
FALSE

⇒ 3N 200 is a
semi-conductor diode
P-N-P transistor
dual gate MOSFET
UJT

⇒ Which is correct for a vacuum triode?
μ = r_pg_m
r_p = μg_m
g_m = μr_p
r_pg_m