Question is ⇒ If load impedance ZL >> Z0, then, Options are ⇒ (A) Z0 = ZL (VSWR), (B) ZL = Z0 (VSWR), (C) ZL = Z0 (VSWR - 1), (D) ZL = Z0 VSWR, (E) , Leave your comments or Download question paper.

Question is ⇒ If load impedance ZL >> Z0, then, Options are ⇒ (A) Z0 = ZL (VSWR), (B) ZL = Z0 (VSWR), (C) ZL = Z0 (VSWR - 1), (D) ZL = Z0 VSWR, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If load impedance Z_L >> Z₀, then
A.	Z₀ = Z_L (VSWR) [Wrong Answer]
B.	Z_L = Z₀ (VSWR) [Correct Answer]
C.	Z_L = Z₀ (VSWR - 1) [Wrong Answer]
D.	Z_L = Z₀ VSWR [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ An oscillator requires an amplifier
with negative feedback
with positive feedback
with either positive or negative feedback
none of the above

⇒ Which colour picture tube uses slotted aperture mask?
Trinitron
Shadow mask tube
PIL
None of the above

⇒ The number of counter states which an 8 bit stair step A/D converter has to pass through before conversion takes place is equal to
1
8
255
256

⇒ A bulb rated at 60 W, 120 V is used for 30 minutes. The charge associated with this operation is
3600 C
900 C
7200 C
600 C

⇒

Assertion (A): In AM the amplitude of carrier is made proportional to the instantaneous amplitude of modulating wave

Reason (R): In AM, frequency of side band = frequency carrier ± frequency of modulating wave.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Consider the resonant circuit as shown b
R = 10⁴ L = 5 μH C = 20 pF
1000 L = 50 μH C = 200 pF
10 K L = 50 μH C =20 pF
None of these

⇒ Consider the following state
1 only
1 and 2
2 only
3 only

⇒ Suppose a microprocessor has memory locations from 0000 to 3FFF, each storing I byte. How many bytes the memory can storing I bytes the memory can store?
4384
8644
12688
16384

⇒ Lead mounting for SCR is used for
rating less than mA
rating about 1 A or less
rating of 20 A or less than 20 A
rating 100 A or less

⇒ In a minimum phase system
all poles lie in the left half plane
all zeros lie in the left half plane
all poles lie in the right half plane
all except one pole or zero lie in the left half plane

⇒ An OR gate has 4 inputs. One input is high and the other three are low. The output
is low
is high
is alternately high and low
may be high or low depending on relative magnitude of inputs

⇒ When a semiconductor bar is heated at one end, a voltage across the bar is developed. If the heated is positive the semiconductor is
P-type
n-type
intrinsic
highly degenerate

⇒ For a MOD-12 counter, the FF has a t_pd = 60 ns The NAND gate has a t_pd of 25 n sec. The clock frequency is
3.774 MHz
> 3.774 MHz
< 3.774 MHz
4.167 MHz

⇒ The addition of a pole to the open loop transfer function pulls the root locus
to the right
to the left and making the system more stable
towards right or left depending on the position of new pole
none of the above

⇒ A meter has a square law scale. For 2 A current the deflection in 90°. For a deflection of 45°, the current is
0.0416666666666667
1.5 A
1.414 A
1.61 A

⇒ 9's complement of 56₁₀ is
43₁₀
84₁₀
65₁₀
53₁₀

⇒ Crossover distortion behaviour is characteristic of
class A O/P stage
class B O/P stage
class AB output stage
common pulse O/P state

⇒ The average load current supplied by a thyristor depends on
firing angle
firing frequency
magnitude of gate current
all of the above

⇒ Dielectric loss due to polarisation occurs in
bipolar dielectrics
non-metallic dielectrics
liquid dielectrics
all of the above

⇒ The RF section of a radio transmit generally consists of
master oscillator
final power amplifier to feed antenna
buffer stage
all of the above

⇒ Analysis of EM wave in waveguide based on
circuit theory
field theory
optical theory
both (a) and (b)

⇒ In the circuit shown in the figure the power dissipated in 30 Ω resistor will be maximum if the value of
30 Ω
10 Ω
9 Ω
zero

⇒ A low-pass filter frequency responce H (jω) = A (ω) e^jΦ(ω) does not produce any phase distortion, if
A(ω) = Cω², Φ (ω) = kω³
A(ω) = Cω², Φ (ω) = kω
A(ω) = Cω², Φ (ω) = kω²
A(ω) = C, Φ (ω) = kω^-1

⇒ For the waveform shown below, the slew rate and full power bandwidth with respect to op-amp will be respecti
0.02 V/μsec, 1.59 KHz
0.04 V/μsec, 1.59 KHz
0.02 V/μsec, 3.58 KHz
0.02 V/μsec, 1.59 KHz

⇒ In a semiconductor material. The hole concentration is found to be 2 x 2.5 x 10¹⁵ cm^-3. If mobility of carriers is 0.13 m²/ v-s. Then find the current density if electric field intensity is 3.62 x 10^-19
7.6237 x 10^-4 A/cm²
7.6237 x 10^-5 A/cm²
7.6237 x 10^-3 A/cm²
none of these

⇒

Match the following:

	List I		List II
A.	Evanescent wave	1.	Pattern multiplication
B.	Skip distance	2.	Mismatched transmission line
C.	Return loss	3.	Propagation in lossy medium
D.	Antenna array	4.	Short wave propagation
		5.	Propagation below cut-off

A-5, B-2, C-4, D-3
A-2, B-4, C-1, D-5
A-5, B-4, C-2, D-1
A-1, B-3, C-4, D-5

⇒ In rectifiers the use of RC filters is recommended when
load current is high
load current is small
load current is neither high nor small
either (a) or (c)

⇒ In C the keywords are also called
special words
reserved words
class words
character words

⇒ In which material do conduction and valence bands overlap
insulators
conductors
both conductor and semiconductor
semiconductors

⇒ An infinite ladder is constructed with 1 Ω and 2 Ω resistors shown be
8.18 A
0
0.375
can't determined