Question is ⇒ For underdamped second order systems the rise time is the time required for the response to rise from, Options are ⇒ (A) 0% to 100% of its final value, (B) 10% to 90% of its final value, (C) 5% to 95% of its final value, (D) either (a) or (b), (E) , Leave your comments or Download question paper.

Question is ⇒ For underdamped second order systems the rise time is the time required for the response to rise from, Options are ⇒ (A) 0% to 100% of its final value, (B) 10% to 90% of its final value, (C) 5% to 95% of its final value, (D) either (a) or (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For underdamped second order systems the rise time is the time required for the response to rise from
A.	0% to 100% of its final value [Correct Answer]
B.	10% to 90% of its final value [Wrong Answer]
C.	5% to 95% of its final value [Wrong Answer]
D.	either (a) or (b) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In Quine-Mclusky method of Boolean function reduction; __________ , are treated as __________ and therefore discrepancies may occur in the final solution, therefore this method is not applicable to the functions with __________ .
zeros, don't care conditions, zeros
one's, don't care conditions, one's
don't care conditions, zeros, don't care conditions
don't care conditions, don't care conditions, don't care conditions

⇒ A capacitance transducer can be used to measure
thickness of sheet
displacement
level of fluids
all of the above

⇒ Zener breakdown occurs
due to rapture of covalent band
mostly in germanium junctions
in lightly doped junctions
due to thermally generated minority carriers

⇒ D FF can be used as a
differentiator
divider circuit
delay switch
none

⇒ In control systems the output of sensor usually, is
analog electrical signal
digital electrical signal
mechanical signal
analog or digital electrical signal

⇒ Which of the following best represents the input impedance of an actual op-amp?
10 ohm
1 k ohm
1 M ohm
100 M ohm

⇒ The poles with greater displacement from the real axis correspond to
higher frequencies of oscillations
stable response
lower frequencies of oscillations
unbounded output

⇒ In a full wave diode rectifier circuit each diode carries current for
90° in each cycle
180° in each cycle
270° in each cycle
360° in each cycle

⇒ Which of the following cannot be used to demodulate SSB?
Complete phase-shift generator
Product detector
Diode balanced modulator
Bipolar transistor balanced modulator

⇒ A trigonometric function is synonyms to
orthogonal function
triangular function
singular function
none of the above

⇒ In Weston synchronoscope the fixed coils are connected across
bus bars
incoming alternator
lamp
either (a) or (b)

⇒ In FM, when the bandwidth is doubled, the signal to noise ratio improves by a factor of
2 dB
4 dB
6 dB
8 dB

⇒ In a purely inductive ac circuit the power curve is a sinusoid of the same frequency as the voltage.
TRUE
FALSE

⇒ If the carrier modulated by a digital bit stream has one of the possible phases of 0°, 90°, 180° and 270°. Then the modulation is called
BPSK
QPSK
QAM
MSK

⇒ A decade counter
counts for ten days
counts ten times faster than a binary counters
counts to 9 and reset on the next pulse
reverts on the pulse after the tenth

⇒ A permeable substance is one
which is strong magnet
which is a weak magnet
which is a good conductor
through which magnetic lines of force can pass easily

⇒ In a Ballistic galvanometer
inertia is small and damping is also small
inertia is large and damping is critical
inertia is large and damping is small
both inertia and damping are large

⇒ The orbital period of a geostationary communication satellite is
12 hours
24 hours
36 hours
48 hours

⇒ In the state equation x = AX + Bu is a n x m matrix.
TRUE
FALSE

⇒ A delta modulation system is designed to operate at 3 times the Nyquist rate for a signal with a 3 KHz bandwidth. The quantization step size is 250 mv. The maximum amplitude of a 1 KHz input sinusoidal for which the delta modulator does not show slope overload is :
716.2 mV
500 mV
647.87 mV
400 mV

⇒ An instruction used to set cany flag in a computer is classified as
data transfer
arithmetic
logical
program control

⇒ Fermi level in intrinsic semiconductor is at the centre of forbidden energy band.
TRUE
FALSE

⇒ In a microprocessor
one machine cycle is equal to one clock cycle
one clock cycle consists of several machine cycles
one machine cycle consists of several clock cycles
one machine cycle is always less than one clock cycle

⇒ Figure shows the self bias circuit for CE amplifier and its equivalent circuit. V_BB and R_B respectively
10 V and 4 k ohm
5 V and 4 k ohm
2 V and 4 k ohm
2 V and 10 k ohm

⇒ Figure repres
Integrator
Differentiator
High Pass Filter
Band Pass Filter

⇒ In radio receiver, the maximum contribution to noise is from
mixer stage
power supply
power amplifier
equally from above three

⇒ When P-N junction is in forward bias, by increasing the battery voltage
current through P-N junction reduces
current through P-N junction increases
circuit resistance increases
none of the above

⇒ If temperature is increased, the temperature coefficient of a metal
increases
decreases
may increase or decrease
remains constant

⇒ Statement 1
Statement 1 is true but statement 2 is false
Statement 1 is false but statement 2 is true
Both the statements are true
Both the statements are false

⇒ The double energy transients occur in the
pure inductive coil
R-L circuit
R-C circuit
R-L-C circuit

Users Also Read
Previous Papers

Aptitude

Reasoning

Gen.Knowledge

Speak English

English / Verbal

Online / Mock Test

Vedic Math