Question is ⇒ The signal flow graph of a system is shown in the given figure. The effect of disturbance TD can be reduce, Options are ⇒ (A) increasing G2 (s), (B) decreasing G2 (s), (C) increasing G1 (s), (D) decreasing G1 (s), (E) , Leave your comments or Download question paper.

Question is ⇒ The signal flow graph of a system is shown in the given figure. The effect of disturbance TD can be reduce, Options are ⇒ (A) increasing G2 (s), (B) decreasing G2 (s), (C) increasing G1 (s), (D) decreasing G1 (s), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The signal flow graph of a system is shown in the given figure. The effect of disturbance T_D can be reduce
A.	increasing G₂ (s) [Wrong Answer]
B.	decreasing G₂ (s) [Wrong Answer]
C.	increasing G₁ (s) [Correct Answer]
D.	decreasing G₁ (s) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ As compared to a p-n junction diode
a schottky diode has lower cut in voltage and lower reverse saturation current
a schottky diode has higher cut in voltage and higher reverse saturation current
a Schottky diode has lower cut in voltage and higher reverse saturation current
a schottky diode has higher cut in voltage and lower reverse saturation current

⇒ The Y plates of a CRO are excited by a voltage 2 sin 100 t and the X plates are not connected. The display would be
a vertical line
a horizontal line
sine wave
slant line

⇒ An m derived low pass filter has f_c = 1000 Hz, f_∞ = 1250 Hz and m = 0.6. If m is increased, then
both f_c and f_∞ will increase
both f_c and f_∞ will decrease
f_c will remain constant but f_∞ will decrease
f_c will remain constant but f_∞ will increase

⇒ The operating modes of 8255 A are called
mode 0 and mode 1
mode 0, mode 1 and mode 2
mode 0 and mode 2
mode 0, mode 2 and mode 3

⇒ The dynamometer principle can be used for
ammeter only
voltmeter only
wattmeter only
ammeter, voltmeter and wattmeter

⇒ The first column of a Routh arra
2
3
4
5

⇒ Which of the following is not used as a microwave mixer or detector?
PIN diode
Crystal diode
Schottky barrier diode
Backward diode

⇒ For operation of enhancement only N-channel MOSFET, value of gate voltage has to be
zero
low positive
high negative
high positive

⇒ Negative feedback is used in audio amplifiers to
operate class C
reduce distortion
increase distortion
increase gain

⇒ A single phase energy meter has the rating 1200 resolutions/ kWh. If a 500 W electric gadget is used for 4 hours, the energy meter will make
1200 revolutions
1800 revolutions
2100 revolutions
2400 revolutions

⇒ Which one of the following is applicable to any network-linear or non-linear, active or passive, time-varying or invariant - as long as Kirchhoff laws are not violated?
Tellegen's theorem
Reciprocity theorem
Maximum power transfer theorem
Superposition theorem

⇒ 1111 + 11111 =
101111
101110
111111
11111

⇒ Integral error compensation changes a second order system to
first order system
third order system
fourth order system
either (a) or (b) depending on the system

⇒ In figure V_BE = 0.7 V. The base curren
above 97 μA
about 97 mA
about 75 μA
about 75 mA

⇒ In a N-P-N transistor, when emitter junction is forward biased and collector junction is reverse biased the transistor will operate in
active region
saturation region
cut-off region
inverted region

⇒ Microprocessor 8088 has
16 bit registers and 16 bit data bus
8 bit registers and 8 bit data bus
8 bit registers and 16 bit data bus
16 bit registers and 8 bit data bus

⇒ Which of the following term does not apply to the Yagi-Uda array?
High gain
Folded dipole
Parasitic
Good bandwidth

⇒ A series RLC circuit is supplied from a variable frequency source. The resonant frequency is ω₀. The voltage across L is maximum at a frequency
equal to ω₀
slightly less than ω₀
slightly more than ω₀
none of the above

⇒ Which of these triggering methods for series connected SCRs use LASCR in the gate circuit?
Resistance triggering
Simultaneous triggering
Sequential triggering
Optical triggering

⇒ For a stable system
both phase and gain margin are negative
both phase and gain margin are positive
phase margin is positive but gain margin is negative
gain margin is positive but phase margin is negative

⇒ Which of following digital modulation technique?
ASK
FSK
PSK
All

⇒ If the number of atoms per unit volume of a monoatomic gas changes, the dielectric constant still remains constant.
TRUE
FALSE

⇒ The amount of photoelectric emission current depends on
frequency of incident radiation
intensity of incident radiation
both frequency and intensity of incident radiation
none of the above

⇒ The power requirement of a RADAR used in military operations is
a few watts
about 500 W
about 2000 W
a few megawatts

⇒ An RLC series circuit has R = 8 Ω, X_L = 8 Ω and X_C = 8 Ω Its impedance is
8 + j 16 Ω
8 + j 8 Ω
8 Ω
24 Ω

⇒ The length of half-wave antenna is at 30 MHz
2.5 meter
5 meter
10 meter
100 meter

⇒ In the case of the circuit shown in the figure, the collector current I_C will be, if β = 100, V_BE = 0.7 V, I_CO = 0.1 βA at 20&d
2.26 mA
1.85 mA
0.357 mA
0.185 mA

⇒

Assertion (A): Relaxation time and mean time between collisions are equal when scattering is isotropic.

Reason (R): Mean free path of an electron λ, velocity of electron v and mean time between collisions t_c are related as λ = vT_c.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In the signal flow graph of figure, y/x equ
3
42857
2
None of the above

⇒ Which of the following can be used to isolate a low impedance from a high impedance source?
Emitter follower
p filter
Darlington pair
Any of the above