Question is ⇒ A digital voltmeter can count from 0 to 9999. If full scale reading is 9.999 V, the resolution of full scale reading is, Options are ⇒ (A) 0.001, (B) 1000, (C) 2 digit, (D) 1 mV, (E) , Leave your comments or Download question paper.

Question is ⇒ A digital voltmeter can count from 0 to 9999. If full scale reading is 9.999 V, the resolution of full scale reading is, Options are ⇒ (A) 0.001, (B) 1000, (C) 2 digit, (D) 1 mV, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A digital voltmeter can count from 0 to 9999. If full scale reading is 9.999 V, the resolution of full scale reading is
A.	0.001 [Wrong Answer]
B.	1000 [Wrong Answer]
C.	2 digit [Wrong Answer]
D.	1 mV [Correct Answer]
View Answer 2 -3 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ CMRR is the ratio of differential voltage gain to common mode gain.
TRUE
FALSE

⇒ An electron rises through a voltage of 100 V. The energy acquired by it will be
100 eV
100 joules
(100)^1.2 eV
(100)^1.2 joules

⇒ A periodic voltage has following values for equal time intervals changing suddenly from one value to next, 0, 5, 10, 20, 50, 60, 50, 20, 10, 5, 0, -5, -10 etc. then rms value of the waveform is
31 volt
32 volt
insufficient data
none

⇒ The reverse saturation current in a semiconductor diode consists of
avalanche current
zener current
minority carrier current
minority carrier current and surface leakage current

⇒ The output of the circuit shown below will be of the frequ
125 Hz
250 Hz
500 Hz
750 Hz

⇒ With reference to C programming language, which of the following statements are correct?

An identifier may start with an underscore.
An identifier may end with an underscore.
If is a valid identifier.
The number of significant characters in and identifier is implementation dependent.

Select the correct answer from the codes given below:
1 and 2 only
2 and 3 only
1, 2, 3 and 4
3 and 4 only

⇒

Match the following:

	List I (Digital circuit)		List II (Circuit type)
A.	BCD to 7 segment decoder	1.	sequential circuit
B.	4-to-1 MUX	2.	combinational circuit
C.	4 bit shift register	3.	neither sequential nor combinational circuit

A-2, B-1, C-2, D-1
A-3, B-2, C-1, D-3
A-2, B-2, C-1, D-1
A-3, B-1, C-2, D-3

⇒ The resolution of 4 bit counting ADC is 0.5 volt, for an Analog input of 6.6 volts. The digital output of ADC will be
1011
1101
1100
1110

⇒ A TV remote control works on the principle of
pulse code modulated ultra violet light
pulse code modulated infrared light
demodulation
either (a) or (b)

⇒ In figure V_CC = + 30 V, I_C corresponding to Q point is 1 mA. If R_C = 5 kΩ and R_E = 5 kΩ, V_CE corresponding to Q poin
30 V
20 V
25 V
5 V

⇒

Match the following:

	List I (Modes)		List II (Characteristic)
A.	Evanescent	1.	Rectangular waveguide does not support
B.	Dominant mode	2.	No wave propagation
C.	TM₁₀ and TM₀₁	3.	Lowest cut-off frequency

A-1, B-2, C-3
A-2, B-3, C-1
A-1, B-3, C-2
A-2, B-1, C-3

⇒ The characteristic equation of a control system is given as s⁴ + 8s³ + 24s² + 32s + K = 0. What is the range of values of K for this system to be stable?
0 ≤ K < 80
0 ≤ K < 100
0 ≤ K < 2300
0 ≤ K < 600

⇒ In free space
phase velocity is greater than light velocity
phase velocity is equal to group velocity
phase velocity is equal to light velocity
Both (b) and (c)

⇒ In figure, the magnitude
must be more than that of V_a
must be more than that of V_b
must be more than that of V_a or V_b
can be equal to or less than or more than that of V_a or V_b

⇒ The voltage across a zener diode
is constant in forward direction
is constant in reverse direction
is constant in both forward and reverse directions
none of the above

⇒ Consider the following statements a half adder.

As a half subtractor also
has two outputs C_H = x x y and S_n = x ⊕ y for two inputs x and y
has two outputs CH = x + y and SH = x ⊕ y for two inputs x and y
is a combinational circuit

Which of the statements given above is/are correct?
1, 3, 4
1, 2, 4
4 only
2 and 3

⇒ Which of the following statement is correct for two wattmeters method of power measurement in 3 phase circuit?
Power can be measured by this method only for star connected loads
When two wattmeters have equal readings power factor is 0.5.
When power factor is 1, one of the wattmeters readings is zero
When the two wattmeter read equal and opposite, p.f. is zero.

⇒ Magnetic susceptibility of a medium is the ratio of
magnetic field strength to mmf
intensity of magnetization to magnetic flux density
intensity of magnetization to field strength
mmf to magnetic field strength

⇒ For the NMOS gate in the given figure,
ABCDE
(AB + C) (D + E)
A(B + C) + DE
A + B C + DE

⇒ Consider the following statements, SWR of a transmission line is infinite when the load is

a short circuit
a complex impedance
an open circuit
a pure reactance

Which of the above statements are correct?
1 and 3 only
1, 2, 3
2, 3, 4
1, 2, 4

⇒

Assertion (A): Free space does not interfere with normal radiation and propagation of radio waves

Reason (R): Free space has no magnetic or gravitational fields.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A thyristor circuit is feeding an R-L load. The turn on time can be reduced by
decreasing R
decreasing L
increasing L
decreasing R and L together

⇒ The first column of a Routh arra
2
3
4
5

⇒ Which is correct for a transfer function?
The poles and zero must be complex
If the poles and zeros are complex or imaginary, they must be conjugate
If the poles and zeros are complex they must be simple
If a zero is imaginary, it must be simple

⇒ To ensure that only dominant mode TE₁₀ is allowed to propagate in an air filled rectangular waveguide, the lower frequency limit and upper frequency limit are
about 25% above f_c for TE₁₀ and 5% below f_c for TE₂₀ mode respectively
about 50% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
about 25% above f_c for TE₁₀ and 25% below f_c for TE₂₀ mode respectively
none of the above

⇒ In a combination limiter with sinusoidal input voltage the output wave can be nearly square.
TRUE
FALSE

⇒ A single-sideband (SSB) signal contains 3 kW. The power content of the carrier is __________ kW.
2
2
3
0

⇒ The phase angle of a lag circuit is
between 0 and -90°
between 0 and +90°
90°
more than 90°

⇒ A certain transistor has a_dc of 0.98 and a collectors leakage current of 5 μA. If I_E = 1 mA, the collector current will be
1.005 mA
0.985 mA
0.975 mA
0.955 mA

⇒ For operation of enhancement only N-channel MOSFET, value of gate voltage has to be
zero
low positive
high negative
high positive