Question is ⇒ A mode-10 counter can divide the clock frequency by a factor of, Options are ⇒ (A) 10, (B) 100, (C) 1000, (D) 10000, (E) , Leave your comments or Download question paper.

Question is ⇒ A mode-10 counter can divide the clock frequency by a factor of, Options are ⇒ (A) 10, (B) 100, (C) 1000, (D) 10000, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A mode-10 counter can divide the clock frequency by a factor of
A.	10 [Correct Answer]
B.	100 [Wrong Answer]
C.	1000 [Wrong Answer]
D.	10000 [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): When p-n junction is forward biased, steady current flows.

Reason (R): When a p-n junction is forward biased, free electrons cross the junction from n to p and holes from p to n.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒

Assertion (A): CE amplifier is the most widely used BJT amplifier

Reason (R): CE amplifier has zero phase difference between input and output

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ The class of insulation of impregnated paper is
A
B
C
F

⇒

Assertion (A): Transient analysis uses Laplace transformation.

Reason (R): Laplace transform method is suitable for solution of integro differential equations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ Kirchoff's laws are applicable to
dc only
ac sinusoidal wave only
dc and ac sinusoidal waves
all wave shapes

⇒ The current wave shown in figure is applied by a 0.1 F capacitor at t = 0. At t = 0⁺, the voltage across capacito
0
4 V
10 V
20 V

⇒ A full adder adds
2 bits
3 bits
4 bits
any number of bits

⇒ The simplest register is
buffer register
shift register
controlled buffer register
bidirectional register

⇒ In 8085 microprocessor based system running at 3 MHz clock frequency what should be the minimum pulse width of the INTR signal, so that it is recognized successfully?
0.33 μs
0.666 μs
5.8 μs
none of these

⇒ A p-n junction diode has
low forward and high reverse resistance
a non-linear v-i characteristics
zero forward current till the forward voltage reaches cut in value
all of the above

⇒ Figure shows the variation of Z(ω) for a positive real function. The functio
RC impedance
RL impedance
RLC impedance
Reactance function

⇒

Match the following:

	List I		List II
A.	Direct addressing	1.	MOV A, M
B.	Register addressing	2.	MOV C, A
C.	Register indirect addressing	3.	LDA 7
D.	Immediate addressing	4.	STA FFC

A-1, B-2, C-3, D-4
A-4, B-2, C-1, D-3
A-2, B-3, C-4, D-1
A-3, B-2, C-1, D-4

⇒ In a second order system, the time constant t of exponential envelopes depends
only on damping factor
only on natural frequency
both on damping factor and natural frequency
neither on damping factor nor on natural frequency

⇒ Pick the odd one
variance
standard deviation
expectation
chebyshev inequality

⇒ What was the first commercial geostationary communication satellite?
INTELSAT 1
ECHO
INSAT-1A
SPUTNIK

⇒ Pressing a key on telephone set generates two frequencies. The basis for selection of these frequencies is
the harmonics of one frequency should not be mistaken for the other frequency
the audio input to the handset transmitter should not be mistaken for a key pressing
both (a) and (b)
neither (a) nor (b)

⇒

Match the following:

	List I		List II
A.	Ternary	1.	0, 1, 3
B.	Quaternary	2.	0, 1, 2, 3, 4, 5, 6 7, 8, 9, A, B
C.	Quinary	3.	0, 1, 2, 3, 4
D.	Duodecimal	4.	0, 1, 2

A-1, B-2, C-3, D-4
A-2, B-3, C-4, D-1
A-3, B-1, C-4, D-3
A-4, B-1, C-3, D-2

⇒ The effective height of an antenna is slightly greater than physical height because
wave velocity in conductor is less than its velocity in free space
wave velocity in conductor is more than its velocity in free space
resistance of conductor is less than that of free space
none of the above

⇒ The I/P impedance (Z_i) and the O/P impedance (Z_o) of an ideal trans conductance (Voltage controlled current source) amplifier are
Z_i = 0, Z_o = 0
Z_i = 0, Z_o = ∞
Z_i = ∞, Z_o = 0
Z_i = ∞, Z_o = ∞

⇒ A wire has a diameter d and resistance R. If the diameter is made 3d, the length and material remaining the same, the new value of resistance will be
R/3
3 R
R/9
9 R

⇒ A liquid has N permanent dipoles μ_p per unit volume and has been subjected to dc field for a long time such that orientation polarization is P₀. At t = 0, the field is suddenly removed, then polarization
will remain constant at P₀
will become zero at t = 0
will delay to zero with a time constant
either b or c

⇒ A rectangular waveguide measures 3 x 4.5 cm internally and has a 10 GHz signal propagated in it. Calculate the cut off frequency for dominant mode.
4 GHz
7.5 GHz
5 GHz
10 GHz

⇒ The minimum number of equations required to analyze the circuit shown in the figur
3
4
6
7

⇒ The linear transistor circuits always operate in the
saturation
cut off
active
inactive

⇒ The opposition of an inductor to current flow
depends only on the resistance of the coil
depends on the magnitude of the applied voltage
varies directly with frequency
varies inversely with frequency

⇒ The units of μ₀ and μ_r are
H/m for both
H/m for μ_r and no units for μ₀
H/m for μ₀ and no units for μ_r
Wb/m for μ₀ and no units for μ_r

⇒ Ferrites have
low copper loss
low eddy current loss
low resistivity
higher specific gravity compared to iron

⇒ In a practical voltage source, the terminal voltage
cannot be less than source voltage
cannot be higher than source voltage
is always less than source voltage
is always equal to source voltage

⇒ In an SSB transmitter one is most likely to find
class C audio amplifier
tuned modulator
class B RF amplifier
class AB power amplifier

⇒ Cross-over distortion behaviour is a characteristic of
class A output stage
class B output stage
class AB output stage
common base output stage