Question is ⇒ For a transistor the normal collector voltage is 12 V. If actually it is found to be + 28 V, the trouble could be, Options are ⇒ (A) RL is open, (B) RE is open, (C) CE is shorted, (D) CE is open, (E) , Leave your comments or Download question paper.

Question is ⇒ For a transistor the normal collector voltage is 12 V. If actually it is found to be + 28 V, the trouble could be, Options are ⇒ (A) RL is open, (B) RE is open, (C) CE is shorted, (D) CE is open, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a transistor the normal collector voltage is 12 V. If actually it is found to be + 28 V, the trouble could be
A.	R_L is open [Wrong Answer]
B.	R_E is open [Correct Answer]
C.	C_E is shorted [Wrong Answer]
D.	C_E is open [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A transmission line of characteristic impedance z₀ = 50 Ω. Phase Velocity = 2 x 10⁸ m/sec, and length l = 1 m is terminated by a load z₁ = (30 - j 40) ohms. The input impedance of the line for a frequency of 100 MHz will be
(30 + j x 40) Ω
(30 - j 40) Ω
(50 + j x 40) Ω
(50 - j 40) Ω

⇒ In a 3 phase bridge inverter with 120° mode of operation the. number of thyristors conducting at one time are
1
2
3
4

⇒ The emitter follower is widely used in electronic instrument because
its voltage gain is less than unity
its voltage gain is very high
its O/P Impedance is low and input impedance is high
its O/P Impedance is high and I/P impedance is low

⇒ Which of the following is correct? The circuit shown in the fig
1, 2 and 3
2, 3 and 4
1, 3 and 4
1, 2 and 4

⇒ In a push pull circuit the two transistors are
both pnp
both npn
one pnp and other npn
either (a) or (b)

⇒ Dynamic memory cells are constructed using
FETs
MOSFETs
Transistors
Flip flops

⇒ A dielectric material must be
insulator
good conductor
resistor
semiconductor

⇒

Assertion (A): Linear ICs include audio amplifier, wideband amplifier, RF amplifier and IF amplifier

Reason (R): The error voltage in a feedback circuit is very small

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A 'n' bit sequence generator employing SR flip-flop has maximum length of the sequence as :
2ⁿ
n
2ⁿ - 1
2ⁿ^-1

⇒ In floating point representation decimal number 13.5 is
1101.1
1.1011 x 2³
0.11011 x 2⁴
11.011 x 2²

⇒ Fourier transform and F(jω) of a signal f(t) has the property
F(jω) = F(-jω)
F(jω) = -F(-jω)
F(jω) = F^*(jω)
F(jω) = -F^*(-jω)

⇒ The direction of vectors gives the direction of propagation of electromagnetic waves
Vector (E x H)
Vector (F x H)
Vector E
Vector H

⇒

Assertion (A): In an op-amp the voltage gain and band width can be adjusted as per requirement

Reason (R): Large value capacitor can also be fabricated on a chip

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ An atom of a rare gas is placed is an electric field E. Then
the nucleus will be shifted in the direction of E by an amount which is proportional to E.
the nucleus will not be shifted.
the nucleus will be shifted in the direction of E by an amount which is independent of E.
the nucleus will be shifted in a direction opposite to that of E.

⇒ For plane wave propagating in free space or two conductor transmission line, what must be the relationship between the phase velocity v_p , the group velocity v_g and speed of light c?
v_p > c > v_g
v_p < c < v_g
v_p = c = v_g
v_p < v_g < c

⇒ The width of a radio beam from a 1 m diameter parabolic antenna at 1 GHz is about
100°
50°
5°
2°

⇒ What will be conversion rate for a counter type A/D converter contains a 4 bit binary ladder and a counter driven by a 2 MHz clock. Then conversion time
125
125 x 10³
125 x 10⁶
None

⇒ Consider the following types of distortions in diode detectors

Distortion is caused due to the reason that dc and ac load impedances are unequal
Distortion is caused because ac load impedance has a reactive component at high audio frequencies
Audio frequency diode current is less than dc current

Which of the above are true?
1, 2 and 3
1 and 2
1 and 3
2 and 3

⇒ An npn transistor has a Beta cutoff frequency f_β of 1 MHz, and a common emitter short circuit low frequency current gain β₀ of 200. It unity gain frequency f_T and the alpha cut off frequency f_a2 respectively are
200 MHz, 201 MHz
200 MHz, 199 MHz
199 MHz, 200 MHz
201 MHz, 200 MHz

⇒ In figure it is desired that output wave is symmetrical.
both diodes should be similar and |V₁| = |V₂|
both diodes should be similar
|V₁| = |V₂|
either (a) or (b)

⇒ If initial value of PROD is zero and a program adds X to PROD, Y times we get the result
X + Y
XY
X / Y
X - Y

⇒ Which of the following microphones has lowest output impedance?
Moving coil
Ribbon
Crystal
Condenser

⇒ The voltage across a zener diode
is constant in forward direction
is constant in reverse direction
is constant in both forward and reverse directions
none of the above

⇒ A coil with large distributed capacitance has a
high resonant frequency
low resonant frequency
low quality factor
low resistance

⇒ A microcomputer has a 64 K memory. What is the hexadecimal notation for the first memory location?
0
FFFF
0FFF
3FFF

⇒ The total number of pins in 8085 are
20
30
40
50

⇒ In an induction wattmeter, the shading bands are made of non conducting material.
TRUE
FALSE

⇒ In a specimen of silicon steel, a field strength of 200 A/m causes a flux density of 0.5 T. In a specimen of cast iron, the same H would cause B to be
0.5 T
less than 0.5 T
more than 0.5 T
0.5 T or more or less

⇒ The V_o of the op-amp circuit shown in the give
11 V_i
10 V_i
V_i
zero

⇒

Assertion (A): When a high reverse voltage is applied to a p-n junction the diode breaks down.

Reason (R): High reverse voltage causes Avalanche effect.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true