Question is ⇒ In which of the following case the rating of the transformer to deliver 100 watts of d.c. power to a load, will be least?, Options are ⇒ (A) Half wave rectifier, (B) Full wave rectifier, (C) Bridge type full wave rectifier, (D) Three phase full wave rectifier, (E) , Leave your comments or Download question paper.

Question is ⇒ In which of the following case the rating of the transformer to deliver 100 watts of d.c. power to a load, will be least?, Options are ⇒ (A) Half wave rectifier, (B) Full wave rectifier, (C) Bridge type full wave rectifier, (D) Three phase full wave rectifier, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In which of the following case the rating of the transformer to deliver 100 watts of d.c. power to a load, will be least?
A.	Half wave rectifier [Wrong Answer]
B.	Full wave rectifier [Wrong Answer]
C.	Bridge type full wave rectifier [Wrong Answer]
D.	Three phase full wave rectifier [Correct Answer]
View Answer 2 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): In monolithic IC the components are part of one chip

Reason (R): An op-amp is a high gain dc amplifier

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ If the differential voltage gain and the common mode voltage gain of a differential amplifier are 48 dB and 2 dB respectively, then its common mode rejection ratio is
23 dB
25 dB
46 dB
50 dB

⇒ As compared to TTL, ECL has
lower power dissipation
lower propagation delay
higher propagation delay
higher noise margin

⇒ In a photo transistor the photocurrent is
emitter base junction
collector base junction
collector
either (a) or (b)

⇒

Match the following:

	List I (Location of characteristics roots)		List II (System characteristic)
A.	(- 1 + j), (- 1 - j)	1.	Marginally stable
B.	(- 2 + j), (- 2 - j), (2, j) (- 2, j)	2.	Unstable
C.	- j, j - 1, 1	3.	Stable

A-1, B-2, C-3
A-2, B-3, C-1
A-3, B-1, C-2
A-1, B-3, C-2

⇒ When the length of antenna is a whole wavelength
the radiation at right angles is zero
the radiation at right angles is maximum
the radiation is zero in all directions
the radiation is maximum in all directions

⇒ The characteristic equation of an SR flip-flop in given by
Q_n+1 = S + RQ_n
Q_n+1 = RQ_n + SQ_n
Q_n+1 = S + RQ_n
Q_n+1 = S + RQ_n

⇒ The poles of an RC function
are simple and lie on jω axis
are simple and lie on negative real axis
may be complex conjugate
may be anywhere in s plane

⇒ Which of the following statements regarding two transistor model of p-n-n-p device is correct?
It explain only the turn on portion of the device characteristics
It explain only the turn off portion of the device characteristics
It explain only the negative region portion of the device characteristics
It explain all the regions of the device characteristics

⇒ A dependent source
may be a current source or voltage source
is neither a current source nor a voltage source
is always a voltage source
is always a current source

⇒ FF₁₆ when converted to 8421BCD =
0000 0101 0101
0010 0101 0101
1111 0101 0101
1000 0101 0101

⇒ When the light falling on a photodiode increases, the reverse minority current
increases
increases or decreases
decreases
remains the same

⇒ Binary number 11001 is equivalent to decimal number
35
15
105
25

⇒ Which one of the following statements is not a property of RL driving point impedance?
The first critical frequency at the origin is a zero
The last critical frequency is a pole
The impedance at S = ∞ always less than the impedance at S = zero
The slope of the impedance curve is positive at all points

⇒ Limiter is not essential in the following detector
foster-Seeley
ratio detector
balanced
none of the above

⇒

Assertion (A): Doping level in extrinsic semiconductors is very small.

Reason (R): Additional of impurity in the ratio of 1 part in 10⁸ parts increases the number of charge carriers by about 20.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following is non-sinusoidal oscillator?
Multivibrator
Relaxation oscillator using UJT
Relaxation oscillator using tunnel diode
Any of the above

⇒ A particular current is made up of two components 10A dc and sinusoidal current of peak value 14.14A. The average of resultant current is
zero
24.14A
10A
14.14A

⇒ A D-flip-flop is
dial type flip-flop
delay flip-flop
differential flip-flop
digital flip-flop

⇒ Which of the following oscillators is used for the generation of high frequencies?
R-C phase shift oscillator
Wien bridge oscillator
L-C oscillator
Blocking oscillator

⇒ An interrupt in which the external device supplies its address as well as the interrupt is known as
vectored interrupt
maskable interrupt
polled interrupt
non-maskable interrupt

⇒ f_unity of an op-amp is about 1 kHz.
TRUE
FALSE

⇒ The theoretical power of white noise is
zero
finite
depend upon frequency of signal
infninite

⇒ In cell communication, cell stands for
Geographical Area
Battery
Location
No meaning

⇒ Diamond is a paramagnetic material.
TRUE
FALSE

⇒ In a thyristor the gate current is increased, then
anode current will increase
anode current will decrease
anode current will remain constant
anode current may increase or decrease

⇒ Read the following statements as regards register pairs in microprocessor 8085

B represents B, C pair with B as high order register and C as low order register.
D represents D, E pair with D as high order register and E as low order register.
H represents H, L pair with H as high order register and L as low order register.

Which of the above statements are correct?
All
1 and 3
1 and 2
2 and 3 only

⇒ For maximum unclipped output from a CE amplifier, the Q point should be
at the centre of dc load line
at the centre of ac load line
at the centre of collector current
none of the above

⇒ As per Hall effect, if any specimen carrying a current I is applied in a transverse magnetic field B, then an electric field E is induced in the specimen in the direction.
parallel to I
perpendicular to B and parallel to I
parallel to I and B
perpendicular to both I and B

⇒ Two messages m₁, and m₂ have a probability of 0.5 each. The entropy is
0.25
0.5
0.75
1