Users Also Read

MCQ's Search Engine

Electrical Engineering

Mechanical Engineering

Civil Engineering

Automobile Engineering

Chemical Engineering

Computer Engineering

Electronics Engineering

Medical Science Engg

Q1. | A conductor in x-y plane and having length 1 m is moving with a velocity V = (2i + 3j + k) m/sec. A magnetic induction field B = (i + 2j) Wb/m^{2} is applied to the conductor. The potential difference between the ends of the conductor is |

A. | 0 [Wrong Answer] |

B. | 4.88 V [Wrong Answer] |

C. | 6 V [Correct Answer] |

D. | None of these [Wrong Answer] |

View Answer
Explanation:-
Answer : CDiscuss it below :!! OOPS Login [Click here] is required to post your answer/resultHelp other students, write article, leave your comments |

**Also Read Similar Questions Below :**

⇒ Consider a system whose input

*x*and output

*y*are related by the equa

Causal, LP

BIBO, LTI

BIBO, Causal, LTI

LP, LTI

⇒ Fourier analysis indicate that a square wave can be represented as

a fundamental sine wave and odd harmonics

a fundamental sine wave and even harmonics

a fundamental sine wave and harmonics

fundamental and subharmonic sine waves

⇒ The power dissipation in a transistor is the product of

emitter current and emitter to base voltage

emitter current and collector to emitter voltage

collector current and collector to emitter voltage

none of the above

⇒ In which function is each term known as minterm?

SOP

POS

Hybrid

Both SOP and POS

⇒ Which of the following cannot be the Fourier series expansion of a periodic signal?

*x*(

*t*) = 2 cos

*t*+ 3 cos 3

*t*

*x*(

*t*) = 2 cos pt + 7 cos

*t*

*x*(

*t*) = cos

*t*+ 0.5

*x*(

*t*) = 2 cos 1.5p

*t*+ sin 3.5 p

*t*

⇒ A single phase half wave rectifier is feeding a resistive load. As firing angle is increased

dc output voltage and rms output voltage decrease in the same proportion

dc output voltage and rms output voltage decrease

dc output voltage and rms output voltage increase

dc output voltage and rms output voltage increase in the same proportion

⇒ An RC coupled amplifier has an open loop gain of 200 and a lower cutoff frequency of 50 Hz. If negative feedback with β = 0.1 is used, the lower cut off frequency will be

about 50 Hz

about 5 Hz

about 2.38 Hz

about 70.5 Hz

⇒ The conductivity of materials found in nature ranges from 10

^{9}ohm

^{-1}m

^{-1}to nearly 10

^{18}ohm

^{-1}m

^{-1}from this it can be concluded that the conductivity of silicon in ohm

^{-1}cm

^{-1}will be nearly

0.5 x 10

^{-15}

0.5 x 10

^{-21}

0.5 x 10

^{-12}

0.5 x 10

^{-3}

⇒ Consider the program segment written for 8085 based sys

41

69

44

Indeterminate

⇒ In the circuit shown in the figure, the approximate voltage at the transist

base and emitter respectively are -8 V and -7.3 V

base and collector respectively are -8 V and -5 V

Collector and emitter respectively are -5 V and -7.3

base, emitter and collector respectively are -8 V, 7.3 V and -5 V

⇒ As access time is decreased, the cost of memory

remains the same

increases

decreases

may increase or decrease

⇒ In the expression

*b*= 2.1 / 1.2 * 3.1 + 3 / 7.1 * 6 which operation would have the first priority in C?

2.1 / 1.2

1.2 * 3.1

2.1 / 1.2 * 3.1

3 / 7.1

⇒

**Assertion (A):** The phase angle plot in Bode diagram is not affected by change in system gain.

**Reason (R):** The variation in gain has no effect on phase margin of the system.

Both A and R are correct and R is correct explanation of A

Both A and R are correct but R is not correct explanation of A

A is correct but R is wrong

R is correct but A is wrong

⇒ The disadvantage of FET over BJT is

poor high frequency performance

low power-handling ability

low values of voltage gain

all of the above

⇒ A JFET behaves as a constant current source when

V

_{GS}= 0

V

_{GS}is less than pinch off voltage

V

_{GS}= V

_{DS}

V

_{GS}is more than pinch off voltage

⇒ In a single phase full wave regulator feeding R-L load, short gate pulse are not suitable.

TRUE

FALSE

⇒ In a bipolar transistor

the base is thick and highly doped

the base is thin and highly doped

the base is thick and lightly doped

the base is thin and lightly doped

⇒ A narrow band noise n(

*t*) has symmetrical spectrum and has power density spectrum 0.2 x 10

^{-6}. The power density of quadrature component is

0.2 x 10

^{-6}

10

^{-7}

4 x 10

^{-7}

5 x 10

^{-8}

⇒ Decimal -90 equals __________ in 8 bit 2s complement

1000 1000

1010 0110

1100 1100

0101 0101

⇒ Entropy gives

measure of Uncertainty

rate of Information

average information

probability of Information

⇒

Match the following:

List I (DOS commands) | List II (Meaning) | ||
---|---|---|---|

A. | DBLSPACE | 1. | Deletes a director and its sub-directories |

B. | MEM | 2. | Displays the amount of used and free memory |

C. | SYS | 3. | Put a copy of DOS on disk |

D. | DELTREE | 4. | Compresses files to increase the storage capacity of disc |

A-4, B-3, C-2, D-1

A-2, B-3, C-4, D-1

A-4, B-2, C-3, D-1

A-1, B-2, C-3, D-4

⇒ Reciprocity theorem is applicable to

circuits with one source

circuits with only one independent source

circuits with any number of sources

circuits with any number of independent sources

⇒ A single phase fully controlled bridge rectifier is fed by a source having inductance. The output voltage during overlap period is

V

_{m}

0.5 V

_{m}

zero

0.5 V

_{m}- voltage drop across inductance

⇒ The main function of a balanced modulator is to

produce balanced modulation of a carrier wave

produce 100% modulation

suppress carrier signal in order to create a single-sideband or double sideband

limit noise picked by a receiver

⇒ To separate channels in FDM receiver we have to use

integration

AND gate

band pass filter

differentiation

⇒ When a 10 K, 10%, 1/4 Ω resistor is connected in series with a 12 K, ± 1%, 1/4 Ω resistor, the resulting combination has the following specifications

22 K, ± 11%, 1/2 Ω

22 K, ± 5.5%, 1/2 Ω

22 K, ± 5.5%, 1/8 Ω

none of these

⇒ Determine the voltage V

_{CB}in the circuit bel

3.4 V

5.4 V

7.4 V

9.4 V

⇒ Oscillator with best frequency stability is

Crystal oscillator

Phase shift oscillator

Clapp oscillator

Hartley oscillator

⇒ If a shunt of 200 Ω resistance is used with a galvanometer of 1000 Ω resistance, the multiplying power is

6

5

42740

42741

⇒