Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
Which of the following operation are performed on linear queues?
| |
A. | 1, 2 and 3 [Wrong Answer] |
B. | 2, 3 and 4 [Wrong Answer] |
C. | 1, 3 and 4 [Wrong Answer] |
D. | 1, 2, 3 and 4 [Correct Answer] |
View Answer
Explanation:-
Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ A plot of modulation index vs carrier amplitude yields a
horizontal line
vertical line
parabola
hyperbola
⇒ A memory system of size 16 k bytes is to be designed using memory chips which have 12 address lines and 4 data lines each. The number of such chips required to design the memory system is
2
4
8
18
⇒ Which is most important subsystem for recovering and reconstructing signal in a TDM system?
Envelope detector followed by a low pass filter
Synchronization ckt for proper timing
Bandpass filter to segregate channels
Coherent detector to ensure frequency and phase connection
⇒ Varactor diode is forward biased when it is used.
TRUE
FALSE
⇒ Which of the following power amplifiers has highest efficiency?
Class A
Class AB
Class B
Class C
⇒ A transistor will operate in inverted region when
emitter junction is forward biased and collector junction is reverse biased
emitter junction is reverse biased and collector junction is forward biased
emitter junction as well as collector junction are forward biased
emitter junction as well as collector junction are reverse biased
⇒ A series resonant circuit has inductance L. If L is increased, the resonant frequency
increases
decreases
remains constant
may increases or decreases
⇒ Consider the following as regards cumulative disribution function F(x)
1 and 2 only
1, 2 and 3 only
1, 2, 3 and 4
2 and 4
⇒ Which of the following materials in not an insulator?
Diamond
Graphite
Bakelite
Lucite
⇒ A sequential multiplexer is connected as shown in figure. Each time the multiplexer receives the clock, it switches to the next channel from 6 to 1. If the input signals a
8 kHz
50 kHz
20 kHz
10 kHz
⇒ A rectifier voltmeter using bridge rectifier and PMMC meter is calibrated to read rms value of sine wave. A triangular wave is applied to it and it reads 6.82 V. The rms value of triangular wave is
about 6.82 V
about 7.1 V
about 6.5 V
about 10 V
⇒ For infinite value of SWR on a transmission line, the line be terminated with impedance as
an open-circuit
a short-circuit
a pure resistance
all of the above
⇒ Boolean algebra obeys
commutative law
associative law
distributive law
commutative, associative and distributive law
⇒ The amplifier network is shown bel
6.42 kΩ, 5.6 kΩ
6.42 Ω, (5.62) kΩ
6.4kΩ, (5.62) kΩ
6.42 Ω, 5.6 kΩ
⇒ Which of the following bus is used to transfer data from main memory to peripheral device?
DMA bus
Output bus
Input bus
Data bus
⇒ A delta modulation system is designed to operate at 3 times the Nyquist rate for a signal with a 3 KHz bandwidth. The quantization step size is 250 mv. The maximum amplitude of a 1 KHz input sinusoidal for which the delta modulator does not show slope overload is :
716.2 mV
500 mV
647.87 mV
400 mV
⇒ The properties of FETs closely resemble those of a
thermionic valve
P-N-P transistor
N-P-N transistor
UJT
⇒ An 8 bit binary number is to be entered into an 8 bit serial shift register. The number of clock pulses required is
1
2
4
8
⇒ As the ratio R_{f}/R_{L} increases the efficiency of a rectifier increases.
TRUE
FALSE
⇒ A function Z(s) has zero at infinity if
the degree of numerator and denominator are equal
the numerator of Z(s) is one degree higher than denominator
the denominator of Z(s) is one degree higher than numerator
the degree of numerator and denominator are either equal or differ by one
⇒
Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct
⇒ A signal with ± 10 V ranged and 1 KHz band width is being digitized using a sample and hold circuit and a 10 bit quantizer. The quantization step is :
1 x 10^{-9} V
5 x 10^{-9} V
2.5 x 10^{-9} V
0.5 x 10^{-9} V
⇒ In a series R-L circuit when excited by a 1 volt battery the current is 1 - e^{-t}. If it is excited by a source 2 sin t, the current will be
2 sin (t - 45°) + e^{-t}
2 sin (t + 45°) + e^{-t}
sin (t - 45°) + e^{-t}
sin (t + 45°) + e^{-t}
⇒ A + (B . C) =
A . B + C
A . B + A . C
A
(A + B) . (A + C)
⇒ Generally op amp is used in
open loop
closed loop
cascaded loop
either (a) or (c)
⇒ Which of the following method cannot be used to increase the bandwidth for cascaded RF amplifier stages?
Wave traps in each stage
Stagger tuning
A shunt damping resistor across each tuned circuit
Doubled tuned transformers with tighter coupling
⇒ An 8156 has A_{15} connected to its CE input. A_{14} to A_{8} are unconnected, and AD_{7} to AC_{0} are connected ignoring shadows, what are the RAM locations?
(4000)_{H} - (40FF)_{H}
(8000)_{H} - (80FF)_{H}
(8000)_{H} - (40FF)_{H}
Any of the above
⇒ A blank EPROM has
all bits set to logical 0
all bits set to logical 1
half the total number of bits set to 0 and remaining half to logical 1
either (a) or (b)
⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The power gain is
125
250
1125
3125
⇒ The conductivity of materials found in nature ranges from 10^{9} ohm^{-1}m^{-1} to nearly 10^{18} ohm^{-1} m^{-1} from this it can be concluded that the conductivity of silicon in ohm^{-1} cm^{-1} will be nearly
0.5 x 10^{-15}
0.5 x 10^{-21}
0.5 x 10^{-12}
0.5 x 10^{-3}
⇒ A plot of modulation index vs carrier amplitude yields a
horizontal line
vertical line
parabola
hyperbola
⇒ A memory system of size 16 k bytes is to be designed using memory chips which have 12 address lines and 4 data lines each. The number of such chips required to design the memory system is
2
4
8
18
⇒ Which is most important subsystem for recovering and reconstructing signal in a TDM system?
Envelope detector followed by a low pass filter
Synchronization ckt for proper timing
Bandpass filter to segregate channels
Coherent detector to ensure frequency and phase connection
⇒ Varactor diode is forward biased when it is used.
TRUE
FALSE
⇒ Which of the following power amplifiers has highest efficiency?
Class A
Class AB
Class B
Class C
⇒ A transistor will operate in inverted region when
emitter junction is forward biased and collector junction is reverse biased
emitter junction is reverse biased and collector junction is forward biased
emitter junction as well as collector junction are forward biased
emitter junction as well as collector junction are reverse biased
⇒ A series resonant circuit has inductance L. If L is increased, the resonant frequency
increases
decreases
remains constant
may increases or decreases
⇒ Consider the following as regards cumulative disribution function F(x)
- 0 ≤ F(x) ≤ 1
- F(- ∞) = 0
- F(∞) = 1
- F(x_{1}) ≤ F(x_{2}) If x_{1} < x_{2}
1 and 2 only
1, 2 and 3 only
1, 2, 3 and 4
2 and 4
⇒ Which of the following materials in not an insulator?
Diamond
Graphite
Bakelite
Lucite
⇒ A sequential multiplexer is connected as shown in figure. Each time the multiplexer receives the clock, it switches to the next channel from 6 to 1. If the input signals a
8 kHz
50 kHz
20 kHz
10 kHz
⇒ A rectifier voltmeter using bridge rectifier and PMMC meter is calibrated to read rms value of sine wave. A triangular wave is applied to it and it reads 6.82 V. The rms value of triangular wave is
about 6.82 V
about 7.1 V
about 6.5 V
about 10 V
⇒ For infinite value of SWR on a transmission line, the line be terminated with impedance as
an open-circuit
a short-circuit
a pure resistance
all of the above
⇒ Boolean algebra obeys
commutative law
associative law
distributive law
commutative, associative and distributive law
⇒ The amplifier network is shown bel
6.42 kΩ, 5.6 kΩ
6.42 Ω, (5.62) kΩ
6.4kΩ, (5.62) kΩ
6.42 Ω, 5.6 kΩ
⇒ Which of the following bus is used to transfer data from main memory to peripheral device?
DMA bus
Output bus
Input bus
Data bus
⇒ A delta modulation system is designed to operate at 3 times the Nyquist rate for a signal with a 3 KHz bandwidth. The quantization step size is 250 mv. The maximum amplitude of a 1 KHz input sinusoidal for which the delta modulator does not show slope overload is :
716.2 mV
500 mV
647.87 mV
400 mV
⇒ The properties of FETs closely resemble those of a
thermionic valve
P-N-P transistor
N-P-N transistor
UJT
⇒ An 8 bit binary number is to be entered into an 8 bit serial shift register. The number of clock pulses required is
1
2
4
8
⇒ As the ratio R_{f}/R_{L} increases the efficiency of a rectifier increases.
TRUE
FALSE
⇒ A function Z(s) has zero at infinity if
the degree of numerator and denominator are equal
the numerator of Z(s) is one degree higher than denominator
the denominator of Z(s) is one degree higher than numerator
the degree of numerator and denominator are either equal or differ by one
⇒
Assertion (A): An ac regulator uses natural commutation
Reason (R): An ac regulator can be used for static on load tap changing of transformer.
Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct
⇒ A signal with ± 10 V ranged and 1 KHz band width is being digitized using a sample and hold circuit and a 10 bit quantizer. The quantization step is :
1 x 10^{-9} V
5 x 10^{-9} V
2.5 x 10^{-9} V
0.5 x 10^{-9} V
⇒ In a series R-L circuit when excited by a 1 volt battery the current is 1 - e^{-t}. If it is excited by a source 2 sin t, the current will be
2 sin (t - 45°) + e^{-t}
2 sin (t + 45°) + e^{-t}
sin (t - 45°) + e^{-t}
sin (t + 45°) + e^{-t}
⇒ A + (B . C) =
A . B + C
A . B + A . C
A
(A + B) . (A + C)
⇒ Generally op amp is used in
open loop
closed loop
cascaded loop
either (a) or (c)
⇒ Which of the following method cannot be used to increase the bandwidth for cascaded RF amplifier stages?
Wave traps in each stage
Stagger tuning
A shunt damping resistor across each tuned circuit
Doubled tuned transformers with tighter coupling
⇒ An 8156 has A_{15} connected to its CE input. A_{14} to A_{8} are unconnected, and AD_{7} to AC_{0} are connected ignoring shadows, what are the RAM locations?
(4000)_{H} - (40FF)_{H}
(8000)_{H} - (80FF)_{H}
(8000)_{H} - (40FF)_{H}
Any of the above
⇒ A blank EPROM has
all bits set to logical 0
all bits set to logical 1
half the total number of bits set to 0 and remaining half to logical 1
either (a) or (b)
⇒ A generator with an internal resistance of 600 Ω drives an amplifier whose input resistance is 400 Ω. The generator's open circuit voltages is 1 mV; the amplifier develops 100mV across an 8kΩ load. The power gain is
125
250
1125
3125
⇒ The conductivity of materials found in nature ranges from 10^{9} ohm^{-1}m^{-1} to nearly 10^{18} ohm^{-1} m^{-1} from this it can be concluded that the conductivity of silicon in ohm^{-1} cm^{-1} will be nearly
0.5 x 10^{-15}
0.5 x 10^{-21}
0.5 x 10^{-12}
0.5 x 10^{-3}