Question is ⇒ For a message signal m(t) = cos (2pfmt) and the carrier frequency fc, which of the following represents a single side band (SSB) signal?, Options are ⇒ (A) cos (2pfmt) cos (2pfct), (B) cos (2pfct), (C) cos [2p(fc + fm) t], (D) [1 + cos (2pfmt) cos (2pfct)], (E) , Leave your comments or Download question paper.

Question is ⇒ For a message signal m(t) = cos (2pfmt) and the carrier frequency fc, which of the following represents a single side band (SSB) signal?, Options are ⇒ (A) cos (2pfmt) cos (2pfct), (B) cos (2pfct), (C) cos [2p(fc + fm) t], (D) [1 + cos (2pfmt) cos (2pfct)], (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	For a message signal m(t) = cos (2pf_mt) and the carrier frequency f_c, which of the following represents a single side band (SSB) signal?
A.	cos (2pf_mt) cos (2pf_ct) [Wrong Answer]
B.	cos (2pf_ct) [Wrong Answer]
C.	cos [2p(f_c + f_m) t] [Correct Answer]
D.	[1 + cos (2pf_mt) cos (2pf_ct)] [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The current through a 1 mH inductance is i(t) = 2.56 x 10^-2 - 4 x 10³ t for 2 ≤ t ≤ 20 μ sec. The voltage across the inductor is
4
8
0
8 x 10³

⇒ A few minutes disturbance in space communications occurs twice a year during Sunblinding when __________ are in line.
Sun and satellite
Sun and Earth station
Satellite and Earth station
Sun, satellite and Earth station

⇒ In the state equation x = AX + Bu is a n x m matrix.
TRUE
FALSE

⇒ Polarization of a wave is
direction of electric field
direction of magnetic field at some fixed point in space
either (a) or (b)
none of the above

⇒ The dominant mode in a rectangular wave-guide is
TE₀₁
TM₀₁
TE₁₀
TM₁₁

⇒ Fourier transform is defined for
periodic
non-periodic
finite duration
all

⇒ In a dynamometer 3 phase power factor meter, the planes of the two moving coils are at
60°
0°
120°
90°

⇒ RMS value of i(t) = 10[1 + sin (- t)] is
10
10/2
l50
102

⇒ In figure V_CC = + 30 V, I_C corresponding to Q point is 1 mA. If R_C = 5 kΩ and R_E = 5 kΩ, V_CE corresponding to Q poin
30 V
20 V
25 V
5 V

⇒ D FF can be used as a
differentiator
divider circuit
delay switch
none

⇒ Which one of the following is non-resonant antenna?
Folded dipole
Broad side array
End fire array
Rhombic antenna

⇒ Volume control found on the front panel of television receivers
a ganged resistor
a variable resistor of logarithmic type
a variable resistor of linear type
a trimmer potentiometer

⇒ A dc voltage source is connected across a series RLC circuit, Under steady state conditions, the applied dc voltage drops entirely across the
R only
C only
L only
R and L

⇒

Assertion (A): The colour signal consists of only luminance signal

Reason (R): In India PAL colour signal system is used.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The addition of impurity in extrinsic semiconductor is about 1 part in 10⁸ parts.
TRUE
FALSE

⇒ Poles and zeros of a driving point function of a network are simple and alternate on jω axis. The network consists of
R and C
L and C
R and L
R, L and C

⇒ The open wired circuit in the given figure works
EX - NOR gate
AND gate
XOR gate
NOR gate

⇒ If φ_sh is flux of shunt magnet, φ_se is flux of series magnet, i_sh is eddy current due to φ_se, the torque in an induction wattmeter is proportional to
φ_se i_se + φ_sh i_sh
φ_sh i_se - φ_se i_sh
φ_sh i_sh - φ_se i_se
φ_sh i_sh + φ_se i_se

⇒ A full wave bridge diode rectifier uses diodes having forward resistance of 50 ohms each. The load resistance is also 50 ohms. The voltage regulations is
0.2
0.5
1
2

⇒ A memory chip has 65536 cells in it. Then
time required to access cell is same as that to access cell 65536
time required to access cell is less than that required to access cell 65536
time required to access cell is more than that required to access cell 65536
either (a) or (b)

⇒ An amplifier has open loop gain of 100, input impedance 1 kΩ and output impedance 100 Ω. If negative feedback with β = 0.99 is used, the new input and output impedances are
10 Ω and 1 Ω
10 Ω and 10 kΩ
100 kΩ and 1 Ω
100 kΩ and 10 Ω

⇒ It is desired to route data from many registers to one register. The device needed is
decoder
multiplexer
demultiplexer
counter

⇒ A pre-emphasis circuit provides extra noise immunity by
converting the phase modulation to frequency modulation
pre-amplifying the whole audio band
boosting the base frequencies
amplifying the higher audio frequencies

⇒ In the given figure the E and H lines in a coaxial c
The radial lines are E lines and circular lines are H lines
Radial lines are H lines and circular lines are E lines
The directions of E and H lines are wrong
Radial lines may be E and H lines depending an direction of current

⇒ All other parameters remaining the same, a 3 phase bridge inverter with 180° mode of operation
has the same peak thyristor current as in 120° mode of operation
has higher peak thyristor current than in 120° mode of operation
has lower peak thyristor current than in 120° mode of operation
any of the above

⇒ Piezoelectric quartz crystal resonators find application where
signal amplification is required
rectification of the signal is required
signal frequency control is required
modulation of signal is required

⇒

Assertion (A): The number of basic loops is equal to number of links.

Reason (R): The graph theory helps in choosing independent variables in circuit analysis.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ The polar plot of transport lag is a unit circle.
TRUE
FALSE

⇒ Two currents have the same peak value. Wave 1 is sinusoidal and wave 2 is rectangular. The ratio of their heating effects are
0.0423611111111111
1 : 2
0.0430555555555556
0.000711805555555555

⇒ In 8085
P flag is set when the result has even parity
P flag is set when the result has odd parity
P flag is reset when the result has odd parity
P flag is reset when the result has even parity