Question is ⇒ The VLF, LF and MF antennas are, Options are ⇒ (A) horizontally polarized, (B) vertically polarized, (C) non linearly polarized, (D) either (a) or (b), (E) , Leave your comments or Download question paper.

Question is ⇒ The VLF, LF and MF antennas are, Options are ⇒ (A) horizontally polarized, (B) vertically polarized, (C) non linearly polarized, (D) either (a) or (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The VLF, LF and MF antennas are
A.	horizontally polarized [Wrong Answer]
B.	vertically polarized [Correct Answer]
C.	non linearly polarized [Wrong Answer]
D.	either (a) or (b) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The characteristics of a non-linear resistance is i = kv⁴. If i becomes 100 times, v becomes
about 100 times
about 10 times
about 3 times
about twice

⇒ The Gain margin for the system with open loop transfer functi
∞
0
1
-∞

⇒ A full wave bridge rectifier is supplied voltage at 50 Hz. The lowest ripple frequency will be
400 Hz
200 Hz
100 Hz
50 Hz

⇒ Linear diode detector utilizes
linear portion of static characteristics of diode
linear portion of dynamic characteristic of diode
square law portion of dynamic characteristics of diode
rectification property of diode

⇒ Flow charts that contain decision sy
represent straight line programs
do not represent straight line programs
all of the above
none of the above

⇒

Assertion (A): Shunt of an ammeter has a low resistance.

Reason (R): Shunt may be connected in series or in parallel with ammeter.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ High speed counter
ring counter
ripple counter
synchronous counter
asynchronous counter

⇒ In the above case if another sine wave corresponding to 40% modulation is transmitted simultaneously, the total radiated power will be
9.9 kW
10.15 kW
10.84 kW
18.4 kW

⇒ Polarization is a measure of
dielectric constant per unit volume
voltage gradient to produce electrical breakdown
product of charge and distance
excess charge density

⇒ The relational operators allowed in Pascal are
=, >, <, > =, < = and < >
=, >, < and < >
=, >, <, > = and < =
>, <, > = and < =

⇒ Which of the following analog modulation scheme requires the minimum transmitted power and minimum channel bandwidth?
VSB
DSB-SC
SSB
AM

⇒ EEPROM is also known as
UVPROM
EAPROM
both UVPROM and EAPROM
none of the above

⇒ Nichrome is used for
overhead line wires
heater coils
lamp filaments
all of the above

⇒

Assertion (A): The maximum range of a radar is proportional to fourth root of the peak transmitted pulse power.

Reason (R): Radar signals are subjected twice to inverse square law.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A network contains only independent current source and resistors. If the values of all resistors are doubled, the value of the node voltage
will become half
will remain unchange
will become one third
cannot be determined unless the circuit configuration and the values of the resistors are known

⇒ Two coils X and Y have self inductances of 5 mH and 10 mH and mutual inductance of 3 mH. If the current in coils X change at a steady rate of 100 A/s, the emf induced in coil Y is
0.3 V
0.5 V
1 V
1.5 V

⇒ Which of the following quantities have same dimension in emu and esu?

Current
Electrical power
Electrical energy

Select the answer as per following codes
1 only
1 and 2
2 and 3
1 and 3

⇒ In the op-amp circuit of figure, V_{03 V₁ - 4 V₂
-3 V₁ + 4 V₂
3(V₁ - V₂)
-3(V₁ - V₂)}

⇒ The emitter coupled pair of BJT's gives a linear transfer relation between the differential output voltage and the differential input voltage V_id only when the magnitude of V_id is less a times the thermal voltage, where a is
4
3
2
1

⇒

Assertion (A): Tie set schedule is used in nodal analysis.

Reason (R): Loop currents are fictitious quantities.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In carbon resistor colour code, if the third band is of silver, it indicates
that three zeros are to be added to indicate the resistance value
multiplier is 0.01
multiplier is 0.1
tolerance is ± 5%

⇒ The sensitivity of a superheterodyne receiver is determined by
the gain IF amplifier
the gain of RF amplifier
the noise figure
all of the above

⇒ A coil is connected across a 200 V, 50 Hz supply and takes a current of 10 A. The loss in the coil is 1000 W. The impedance and resistance of the coil are
10 Ω, 8 Ω
15 Ω, 8 Ω
20 Ω, 10 Ω
30 Ω, 15 Ω

⇒ Which one of the following logic families can be operated using a supply voltage from 3 V to 15 V?
TTL
ECL
PMOS
CMOS

⇒ In n-well CMOS fabrication substrate is:
heavily doped n-type
heavily doped p-type
lightly doped n-type
lightly doped p-type

⇒ Nickel is a non-magnetic material.
TRUE
FALSE

⇒ For a rectified sinusoidal wave clipped at 0.707 its peak value (figure), the average valu
70.7 V
63.7 V
54 V
15 V

⇒ How is inversion achieved using EX-OR gate?
Giving input signal to the two input lines of the gate tied together
Giving input to one input line and logic one to the other line
Giving input to one input line and logic one to the other line
Inversion cannot be achieved using EX-OR gate

⇒ An angle modulated signal is expressed by f_a(t) = cos (2 x 10⁸ pt) + 75 sin (2 x 10³ pt). The peak frequency deviation of the carrier is
1 kHz
7.5 kHz
75 kHz
100 MHz

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after ACI 0 A4 H?
4 AH, 0
4 AH, 1
4 BH, 0
4 BH, 1