Question is ⇒ When Pc is the unmodulated carrier power and Pt is the total power in the modulated wave, then the maximum power in AM wave is, Options are ⇒ (A) Pt = 1.5 Pc, (B) Pt = 2.5 Pc, (C) Pt = 2, (D) Pt = 22 Pc, (E) , Leave your comments or Download question paper.

Question is ⇒ When Pc is the unmodulated carrier power and Pt is the total power in the modulated wave, then the maximum power in AM wave is, Options are ⇒ (A) Pt = 1.5 Pc, (B) Pt = 2.5 Pc, (C) Pt = 2, (D) Pt = 22 Pc, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When P_c is the unmodulated carrier power and P_t is the total power in the modulated wave, then the maximum power in AM wave is
A.	P_t = 1.5 P_c [Correct Answer]
B.	P_t = 2.5 P_c [Wrong Answer]
C.	P_t = 2 [Wrong Answer]
D.	P_t = 22 P_c [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The model of a system
is unique
depends on desired degree of accuracy
depends on the type of analysis
both (b) and (c)

⇒ To count 1000 bottles in a milk plant, the minimum number of flip flops requires is
12
10
8
6

⇒ The 2 out of 5 code has
two 0s and three 0s in each code group
one 1s and four 0s in each code group
four 1s and one 0s in each code group
three 1s and two 0s in each code group

⇒ Logic analyser is
a multichannel oscilloscope
similar to logic pulser
similar to current tracer
none of the above

⇒ To turn off an SCR, it is necessary to reduce its current to less than :
trigger current
holding current
breakover current
none of the above

⇒ The pole zero plot of the given figure is
non-minimum phase function
minimum phase function
all pass function
none of the above

⇒ A JFET can operate on
enhancement mode only
depletion mode only
both depletion as well as enhancement modes
neither depletion nor enhancement mode

⇒ In the circuit of figure the switch is closed at t = 0, At t = 0⁺ this current through inductanc
0
0.416666666666667
6.67 A
5.1 A

⇒ In a Communication system, noise is most likely to affect the signal.
at the transmitter
In the channel
in Information source
at the destination

⇒ The total number of leads in MOS controlled thyristor is
2
3
4
2 or 3

⇒ Internally the two distinct units of 8086 are called
bus interface unit and execution unit
command unit and follow unit
master unit and slave unit
memory unit and operation unit

⇒ FM signal can be generated by
diode reactance modulator
saturable reactor modulator
reactance tube modulator
none of the above

⇒ Which of the following amplifier circuits has highest input impedance?
Circuit using BJT
Circuit using JFET
Circuit using MOSFET
Either (a) or (b)

⇒ The increase in intensity of trace in a CRO causes a change in
beam current
frequency of time base
gain of Y amplifier
accelerating voltage

⇒ Figure sho
JFET
n-channel MOSFET
p-channel MOSFET
none of the above

⇒ Hay bridge is suitable for measuring inductance of which one of the following inductors?
Having Q value less than 10
Having Q value greater than 10
Having any value of Q
Having phase angle of reactance very large

⇒ Fermi level in intrinsic semiconductor is at the centre of forbidden energy band.
TRUE
FALSE

⇒ Mouse is a very suitable input device for computers.
TRUE
FALSE

⇒ Microwaves are used for
telephony
radio broadcast
TV systems
all of the above

⇒

Assertion (A): If Z₁(s) and Z₂(s) are positive real then Z₁(s) + Z₂(s) as well as 1/Z₁(s) and 1/Z₂(s) are positive real.

Reason (R): The poles of a positive real function are real or occur in conjugate pairs.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a series RLC circuit the dB level of currents at half power frequencies as compared to current at resonance is
3
-3
0.5
-0.5

⇒ A dc power supply has no load voltage of 30 V and full load voltage of 25 V at full load current of 1 A. The output resistance and voltage regulation respectively are
5 Ω and 25%
25 Ω and 20%
5 Ω and 16.7%
25 Ω and 16.7%

⇒ In an electrochemical process the mass of material deposited at an electrode is proportional to
time for which current is passed
magnitude of current
electric charge through the electrolyte
none of the above

⇒ The semiconductor diode which can be used in switching circuit in microwave range is
PIN diode
Varactor diode
Tunnel diode
Gunn diode

⇒ Consider the frequency modulated signal 10 cos (2p x 10⁵t + 5 sin (2p x 1500t) + 7.5 sin (2p x 1000t) with carrier frequency of 10⁵Hz. The modulation index is
12.5
10
7.5
5

⇒ In the wave mechanical theory, the maximum of the charge distribution in the ground state occurs for a distance from the nucleus equal to
first Bohr radius
second Bohr radius
third Bohr radius
either first or second Bohr radius

⇒ A single mode fibre not suffer from which type of dispersion?
Waveguide dispersion
Material dispersion
Intermodal dispersion
Polarization mode dispersion

⇒ Circular polarization
is useful in reducing depolarization effect on received wave
involves critical alignment of transmitting and receiving antenna
is useful in discrimination between reception of adjacent beams
none of the above

⇒ Four sig
2f₀
3f₀
4f₀
8f₀

⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls find cut off wavelength for dominant mode.
4 cm
1 cm
2 cm
8 cm