Question is ⇒ Status register in the 8156 contains information about, Options are ⇒ (A) the timer, (B) the ports, (C) both (a) and (b), (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Status register in the 8156 contains information about, Options are ⇒ (A) the timer, (B) the ports, (C) both (a) and (b), (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Status register in the 8156 contains information about
A.	the timer [Wrong Answer]
B.	the ports [Wrong Answer]
C.	both (a) and (b) [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For the time domain response shown in figure the
lies on negative real axis
lies on positive real axis
lies on imaginary axis
is complex or imaginary

⇒ In 8085
the upper 8 address bits appear on address bus and lower 8 bits on address data bus
the lower 8 address bits appear on address bus and the upper 8 address bits appear on address data bus
either upper or lower 8 address bits may appear at address bus
either upper or lower 8 address bits may appear at address data bus

⇒ An amplifier with loop gain Aβ will be more stable for value of Aβ as
0.95
0.7
1.2
1.5

⇒ In a series circuit with X_L constant and R variable the current locus lies in the third quadrant.
TRUE
FALSE

⇒

Assertion (A): F(s) is valid throughout s plane except at poles of F(s).

Reason (R): £[f₁(t) + f₂(t)] = £[f₁(t)] + £[f₂(t)]

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The number of noise sources in a BJT are
3
2
1
4

⇒ A separately excited dc motor is run from a dc source through a chopper. At 600 rpm and rated torque, the duty cycle of chopper is 0.8. At 600 rpm and half the rated torque, the duty cycle is likely to be
0.9
0.8
0.75
0.6

⇒ A 3 phase ac regulator uses
3 thyristors
6 thyristors
9 thyristors
12 thyristors

⇒ In an n type semiconductor the fermi level is 0.35 eV below the conduction band, the concentration of donor atoms is increased to three times. The new position of Fermi level will be
0.35 eV below conduction band
about 0.32 eV below conduction band
about 0.32 eV above conduction band
about 0.1 eV below conduction band

⇒ 4 bit ripple counter and 4 bit synchronous counter are made using flip-flop having a propagation delay of 10 ns each. If the worst case delay in the ripple counter and the synchronous counter be R and S respectively, then
R = 10 ns, S = 40 ns
R = 40 ns, S = 10 ns
R = 10 ns, S = 30 ns
R = 30 ns, S = 10 ns

⇒ The resonant frequency of an R_F amplifier is 1 MHz and its bandwidth is 10 kHz. The Q factor will be
10
100
0.01
0.1

⇒ A Hall effect transducer has K_H = - 1 x 10^-8. If B = 1 Wb/m², I = 3 A and bismuth slab is 2 mm wide, the Hall voltage is
-7.5 x 10^-6 V
-15 x 10^-6
-20 x 10^-4 V
-22.5 x 10^-4 V

⇒ In a power system, reactive power is necessary for
power transmission
stabilising the voltage level
counteracting the effect of reactance in the transmission system
none of the above

⇒

Assertion (A): Superposition theorem can be used to find the output of a full wave rectifier excited by sinusoidal signal sources of different frequencies connected in series.

Reason (R): Superposition theorem is valid for all linear systems.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which one of the following is not necessarily an advantage of the phase cancellation method of obtaining SSB over the filter method?
It is possible to generate SSB at any frequency
SSB with lower audio frequencies present can be generated
Switching from one sideband to other is simpler
There are more balanced modulators; therefore the carrier is suppressed better

⇒ The power rating of radio transmitters is around
100 mW
10 W
10 kW
10 MW

⇒ An ac bridge uses galvanometer as detector.
TRUE
FALSE

⇒ The number of spectral component when two cosine waves are multiplied of different frequency
1
2
8
4

⇒ The voltage in a circuit follows the law v = 100 sin ωt if the frequency is 25 Hz, how long will it take for the voltage to rise to 50 volts?
1/150 s
1/100 s
1/300 s
1/600 s

⇒ The natural frequency S_n of the given circui
-1
1
42737
-2

⇒ The directivity of 20 turn helix having a = 12° circumference equal to one wavelength, will be
1.8 dB
6 dB
12 dB
18 dB

⇒ 10's complement of 16₁₀ is
83₁₀
84₁₀
38₁₀
48₁₀

⇒ In 8086 a word OA 50 FH is stored in 02 and 03 memory locations. Then
OFH is stored at location 02 and 0 A 5 at location 03 and address of word is 02
OFH is stored at location 03 and 0 A 5 at location 02 and address of word in 02
OFH is stored at location 02 and 0 A 5 at location 03 and address of word is 03
OFH is stored at location 03 and 0 A 5 at location 02 and address of word is 03

⇒ Periodic recharging of the memory cells at regular intervals of 3 to 8 millisecond is required in a
ROM
Static RAM
Dynamic RAM
PLA

⇒ The disturbance from adjacent telephone line is known as
cross fire
cross talk
inductive disturbance
none of the above

⇒ The 1150 kg geosynchronous satellite INSAT-IA parked 36000 km above India had greatly improved India's
intelligence gathering capacity
domestic communications
meteorological capability
both (b) and (c)

⇒ In control systems the word controller includes
error detector and feedback element
feedback element and control elements
error detector and control elements
error detector, control elements and feedback elements

⇒ Which of the following computer memories is fastest?
Cache
Primary
Mass storage
Off line back up

⇒ In figure V_i may vary from 15 to 20 V and load current may vary from 20 mA to 100 mA. Suitable maximum value of
20 Ω
50 Ω
100 Ω
200 Ω

⇒ All poles and zeros of a driving point immittance function of an L-C network
should lie on the jω axis
should lie on the +ve real axis
should lie on the - ve real axis
can lie anywhere in s-plane