Question is ⇒ One coulomb charge is equal to the charge on, Options are ⇒ (A) 6.24 x 1018 electrons, (B) 6.24 x 1024 electrons, (C) 6.24 x 1018 atoms, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ One coulomb charge is equal to the charge on, Options are ⇒ (A) 6.24 x 1018 electrons, (B) 6.24 x 1024 electrons, (C) 6.24 x 1018 atoms, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	One coulomb charge is equal to the charge on
A.	6.24 x 10¹⁸ electrons [Correct Answer]
B.	6.24 x 10²⁴ electrons [Wrong Answer]
C.	6.24 x 10¹⁸ atoms [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): The velocity of electromagnetic waves on overhead lines and coaxial cables is the same.

Reason (R): Free space has an intrinsic impedance of 377 ohms.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Time delay of a TTL standard family is about
180 ns
50 ns
18 ns
3 ns

⇒ The derating factor, for ambient temperature higher than specified, for a transistor is about
2.5 mW/°C
0.5 mW/°C
10 mW/°C
20 mW/°C

⇒ If the network in figure (1), (2) are equivalent at terminals A - B, then voltage V and resistance R
100V and 12 Ω
60V and 12 Ω
100V and 30 Ω
60V and 30 Ω

⇒ In an integral controller
the output is proportional to input
the rate of change of output is proportional to input
the output is proportional to rate of change of input
none of the above

⇒ In the circuit shown, all the transmission line sections are lossless. The Voltage Standing Wave Ration (VSWR) on the 60W lin
1
1.64
2.5
3

⇒

Assertion (A): A backward wave oscillator can be used as a sweep generator.

Reason (R): The frequency of oscillation of a backward wave oscillator can be changed by varying the voltage which controls the beam velocity.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A transmission line is feeding 1 watt of power to a horn antenna having a gain of 10 dB. The antenna is matched to the transmission line. The total power radiated by the horn antenna into the free space is
10 watts
1 watt
0.1 watt
0.01 watt

⇒ Consider the following statements:

A flip-flop is used to store 1-bit of information.
Race-around condition occurs in a J-K flip-flop when both the inputs are 1.
Master-slave configuration is used in flip-flops to store 2-bits of information
A transparent latch consists of a D-type flip-flop.

Which of the above statements is/are correct?
1 only
1, 3 and 4
1, 2 and 4
2 and 3 only

⇒ Lead mounting for SCR is used for
rating less than mA
rating about 1 A or less
rating of 20 A or less than 20 A
rating 100 A or less

⇒ Which of the following statement is correct?
FET and junction transistor both are unipolar
FET and junction transistor both are bipolar
The FET is bipolar, while junction transistor are unipolar
The FET is unipolar, while junction transistor are bipolar

⇒ The fuse material used in electrical lines must have which one of the following properties?
High resistivity
Low conductivity
High melting point
Low melting point

⇒ Companding is used in PCM to
reduce bandwidth
increasing S/N ratio
get almost uniform S/N ratio
increase bandwidth

⇒ The radiation pattern of loop antenna is
circle
semicircle
elliptical
cardoid or Limacon

⇒ In the circuit shown, in switch S is open for a long time and is closed at t = 0. The current i(t) for t ≥ 0^{+i(t) = 0.5 - 0.125e^-1000t A
i(t) = 1.5 - 0.125e^-1000t A
i(t) = 0.5 - 0.5e^-1000t A
i(t) = 0.375e^-1000t A}

⇒ Which of the following statement is false?
A half-wave dipole is a resonant antenna
A horizontal antenna transmits radio signal with horizontal polarization
The field strength of 200 mV/m will produced 200 μV of signal in an antenna 2 m long
All of the above

⇒ Which of the following parameters is negligible in transmission lines?
R
L
C
G

⇒ In figure the open circuit em
15 V
1.45 V
1.475 V
1.485 V

⇒ For the system in the given fi
y_k = u_k + 0.5 y_{k - 2}
y_k = u_k + 0.5 u_{k - 2}
y_k = u_k - 0.5 y_{k - 2}
y_k = u_k - 0.5 u_{k - 2}

⇒ Which one of the following can be used for amplification of microwave energy?
TWT
Magnetron
Reflex klystron
Gunn diode

⇒ The frequency of oscillation in a backward wave oscillator can be changed by
varying the voltage which controls beam velocity
varying the beam current
both by varying the beam current and by light varying the voltage which controls beam velocity
changing the rate of thermionic emission

⇒ In the following non-planar graph no.of independent loop equations
8
12
7
5

⇒ In case of synchro error detector the electrical zero position of control transformer is obtained when angular displacement between rotors is
zero
45°
90°
180°

⇒ PCM employing 4 bit code is used to send data having frequency range from 0 to 2 kHz. The minimum required bandwidth of carrier channel is
2 kHz
4 kHz
8 kHz
16 kHz

⇒ A Karnaugh map with 4 variables has
2 cells
4 cells
8 cells
16 cells

⇒ Which is the dominant mode in rectangular waveguides?
TE₁₀
TE₁₁
TE₀₁
TM₁₁

⇒ A h is the unit of quantity of electricity.
TRUE
FALSE

⇒ In a bridge rectifier circuit the rms value of input ac voltage is 10 V. The PIV across each diode is
7.07 V
14.14 V
10 V
28.28 V

⇒ In 8085 microprocessor based system running at 3 MHz clock frequency what should be the minimum pulse width of the INTR signal, so that it is recognized successfully?
0.33 μs
0.666 μs
5.8 μs
none of these

⇒ Which of the following figures is an ideal equivalent circuit of a n-p-n transis
figure A
figure B
figure C
none