Question is ⇒ Which of the following circuits cannot be demodulate SSB?, Options are ⇒ (A) Product detector, (B) Balanced modulator, (C) Phase discriminator, (D) BFO, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following circuits cannot be demodulate SSB?, Options are ⇒ (A) Product detector, (B) Balanced modulator, (C) Phase discriminator, (D) BFO, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following circuits cannot be demodulate SSB?
A.	Product detector [Wrong Answer]
B.	Balanced modulator [Wrong Answer]
C.	Phase discriminator [Correct Answer]
D.	BFO [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of these has degenerate p and n materials?
Zener diode
PIN diode
Tunnel diode
Photo diode

⇒ The output voltage of 5-bit D/A binary ladder that has a digital input of 11010 (Assuming 0 = 0 V and 1 = + 10 V) is
3.4375 V
6.0 V
8.125 V
8.6875 V

⇒ In a 4 bit parallel in parallel out shift register A = 1, B = 1, C = 0, D = 1. The data output after 3 clock pulses is
1101
1001
101
1

⇒ End fire array is called a linear resonant dipole array.
TRUE
FALSE

⇒ A mobile telephone has a range of about
50 km
10 km
1 km
0.1 km

⇒ Calculate the stability factor and change in I_C from 25°C to 100°C for, β = 50, R_B/ R_E = 250, ΔI_C0 = 19.9 nA for emitter bias configuration.
42.53, 0.85 μA
40.91, 0.58 μA
40.91, 0.58 μA
41.10, 0.39 μA

⇒ A super heterodyne receiver has a IF of 465 kHz. It is tuned to a station broadcasting at 500 KHz and its oscillator is operating at 965 KHz, then the 1330 KHz frequency would be
adjacent channel frequency
image frequency
gyro frequency
maximum usable frequency

⇒ In figure the phase
will be 90° at ω = 0 and 0° at ω = ∞
will be 0° at ω = 0 and 90° at ω = ∞
will be 45° at ω = 0 and 0° at ω = ∞
will be 45° at ω = 0 and 90° at ω = ∞

⇒ In AM the amplitude of carrier components ... while in FM it
remains constant, does not remain constant
does not remain constant ... remains constant
remains constant... also remains constant
does not remain constant, also does not remain constant

⇒ An AND gate has two inputs A and B and one inhibit input 3, Output is 1 if
A = 1, B = 1, S = 1
A = 1, B = 1, S = 0
A = 1, B = 0, S = 1
A = 1, B = 0, S = 0

⇒ A two branch parallel tuned circuit has a capacitance C in one of the two branches and resistance R in second branchs. As C is decreased the dynamic resistance
increases
decreases
remains constant
may increases or decreases

⇒ A 3 bit binary adder should use
3 full adders
2 full adders and 1 half adder
1 full adder and 2 half adders
3 half adders

⇒ For a nonlinear resistance
v-i plot is not a straight line
resistance increases as current increases
resistance decreases as current increases
current decreases as voltage increases

⇒ Germanium and Si phosphorus have their maximum spectral response in the
infrared region
ultraviolet region
visible region
X-ray region

⇒

Assertion (A): A GTO can be turned on and turned off by gate pulses

Reason (R): A GTO can be turned off by negative gate pulse.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The length of half-wave antenna is at 30 MHz
2.5 meter
5 meter
10 meter
100 meter

⇒ In an 8085 microprocessor, the instruction CMP B has been executed while the content of the accumulator is less than that of register B, As a result.
carry flag will be set but zero flag will be reset
carry flag will be reset but zero flag will be set
both carry flag and zero flag will be reset
both carry flag and zero flag will be set

⇒ In a step down chopper using pulse width modulation, T_on = 3 x 10^-3 and T_off = 1 x 10^-3 s. The chopping frequency is
333.33
250
500
1000

⇒ An antisymmetric filter having odd number of coefficient may have a performance as
low pass
high pass
band pass
all pass

⇒ If Laplace transform of f(t) is F(s), then £ f(t - a) u (t - a)= 0
e^as F(s)
e^-as F(s)
- e^as F(s)
- e ^-as F(s)

⇒

Assertion (A): The s domain impedance of a series R-L circuit is R + sL irrespective of initial conditions.

Reason (R): Complex frequency s = σ + jω.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ Ferromagnetic materials exhibit
a linear B-H behaviour
a non-linear B-H behaviour
an exponential B-H behaviour
none of the above

⇒ A telephone channel requires a bandwidth of about
1 kHz
3 kHz
10 kHz
50 kHz

⇒ The number of select lines in ALU 1C 74181 is
2
4
8
16

⇒

Assertion (A): In computers the data is stored in hexadecimal form

Reason (R): Hexadecimal representation is short as compared to binary representation.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A half wave diode rectifier has a capacitance input filter. If input voltage is V_m sin ωt, PIV is
V_m
2 V_m
3 V_m
4 V_m

⇒ Which has the lowest propagation delay time?
ECL
TTL
CMOS
PMOS

⇒ The emitter follower is widely used in electronic instrument because
its voltage gain is less than unity
its voltage gain is very high
its O/P Impedance is low and input impedance is high
its O/P Impedance is high and I/P impedance is low

⇒ In the circuit shown in the given figure, switch k is closed at t = 0. The circuit was initially relaxed then which one of the following sources of v(t) will produce maximum current at t = 0^{+Unit step
Unit impulse
Unit ramp
Unit step plus unit ramp}

⇒ If input ac is 10 V_rms, then maximum voltage that will appear across the diode of a half wave rectifier with a capacitor I/P filter will be
10 V
14 V
20 V
28 V