Question is ⇒ The conductivity of intrinsic semiconductor is given by, Options are ⇒ (A) eni(μp - μn), (B) eni(μp + μn), (C) ni(μp + μn), (D) ni(μpμn), (E) , Leave your comments or Download question paper.

Question is ⇒ The conductivity of intrinsic semiconductor is given by, Options are ⇒ (A) eni(μp - μn), (B) eni(μp + μn), (C) ni(μp + μn), (D) ni(μpμn), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The conductivity of intrinsic semiconductor is given by
A.	en_i(μ_p - μ_n) [Wrong Answer]
B.	en_i(μ_p + μ_n) [Correct Answer]
C.	n_i(μ_p + μ_n) [Wrong Answer]
D.	n_i(μ_pμ_n) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Norton's equivalent circuit
is same as Thevenin's circuit
has no relation with Thevenin's circuit
is dual of Thevenin's circuit
is reciprocal of Thevenin's circuit

⇒

Assertion (A): The angular momentum of an atom is due to three contributions viz. orbital, electron spin and nuclear spin.

Reason (R): The nuclear spin magnetic moment is much more than electron spin magnetic moment.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a flash type ADC, employing 15 comparators resolution with 10 volts reference; is expected to be :
0.625 V
0.656 V
0.525 V
insufficient data

⇒ Consider the following statements

Usable bandwidth of ridge wave guide is more than that of rectangular waveguide.
For a given value of TM₁₀ cutoff frequency the cross section of ridge wave guide is lesser that that of rect angular waveguide.
Ridge wave guide has higher conductor losser than a rectangular waveguide.
Ridge guide has higher conductor losser than a rectangular waveguide.

Which of the above statements are correct?
1 and 2 only
1, 2 and 3 only
2 and 3 only
All

⇒ Which of the following oscillator circuits uses three capacitors in the phase shifting network?
Hartley
Clapp
Colpitt's
Both (b) and (c)

⇒ Velocity of the wave when it passes from air into sphere
decreases
increases
same
no change

⇒ A bridge rectifier circuit has a dc load current of 10 mA and a filter capacitance of 1000 μF. The peak to peak ripple voltage is
0.01 V
0.05 V
0.1 V
0.5 V

⇒ System
causal
stable
non causal
anticausal

⇒ A number of impulses spaced fron one another form an impulse train.
TRUE
FALSE

⇒ The ideal characteristics of a stabilizer is
constant output voltage with low internal resistance
constant output current with low internal resistance
constant output voltage with high internal resistance
constant internal resistance and constant output current

⇒ In the given figure reflection coefficient at loa
0.6
-0.6
0.4
-0.4

⇒ The series 54 H/74 H denotes
Standard TTL
High speed TTL
Low Power TTL
High Power TTL

⇒ Which one of the following logic families can be operated using a supply voltage from 3 V to 15 V?
TTL
ECL
PMOS
CMOS

⇒ Consider the following galvanometers

D'Arsonval
Ballistic
Vibration

Which of these are permanent magnet moving coil instruments?
1 and 2 only
1, 2 and 3
2 and 3 only
1 and 3 only

⇒ Two resistances are R₁ = 36 ± 5% and R₂ = 75 ± 5%. If they are connected in parallel, the limiting error in percent will be
0.05
0.1
0.15
0.2

⇒ In one's complement 8 bit representation 11111111 represents
0
0
1
-1

⇒

Assertion (A): A semiconductor strain gauge is more accurate than a resistance strain gauge.

Reason (R): The gauge factor of a semiconductor strain gauge is about 100 where as the gauge factor of a resistance strain gauge is only about 2.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true R is false
A is false R is true

⇒ In figure, the steady state current through 1H inductanc
Zero
0.125
0.208333333333333
0.25

⇒ Which type of modulator amplifier is used in AM transmitter?
Class A
Class B
Classes AB
Class C with negative feedback

⇒ Skip distance depends on time of day and angle of incidence.
TRUE
FALSE

⇒ Which synthesis procedure requires the use of mutual inductance?
Foster's synthesis
Cauer synthesis
Bott-Duffin synthesis
Brune's synthesis

⇒ A power transistor dissipates 5 W. If ambient temperature is 30° and case to air thermal resistance is 10° C/W, the case temperature is
80°C
20°C
32°C
305°C

⇒ Consider the following instruments

Tangent galvanometer
Rayleigh current balance
Household energy meter
Hot wire ammeter

Out of above absolute instruments are
1, 2 and 3
1, 2 and 4
1 and 2
2, 3 and 4

⇒ The antenna current of an AM transmitter is 8 A. When only the carrier is sent, but it increases to 8.93 A. when the carrier is sinusoidally modulated. The percentage modulation is nearly
0.9
0.8
0.75
0.7

⇒ In an op-amp a virtual ground is a ground for
voltage only
current only
both voltage and current
neither voltage nor current

⇒

Assertion (A): For a reciprocal microwave junction the S matrix is symmetrical.

Reason (R): In a symmetrical matrix S_ij = S_ji.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ A binary with a digits, all of which are unity has the value
n² - 1
2ⁿ
2(^{n - 1})
2ⁿ - 1

⇒ Zener diode is invariably used with
forward bias
reverse bias
either (a) or (b)
zero bias

⇒ In a feedback series regular circuit, the output voltage is regulated by controlling the
magnitude of the I/P voltage
gain of the feed back BJT
reference Voltage
voltage drop across the series pass transistor

⇒ In the given figure power meters at A and B indicate 1 mW and 110 μW respectively. VSWR of lin
1.5
2
2.5
3