Question is ⇒ A frequency doubler has an FM signal input at 13 MHz with a deviation of 5 kHz. The output frequency of the carrier will be, Options are ⇒ (A) 26 kHz, (B) 260 kHz, (C) 26 MHz, (D) 260 MHz, (E) , Leave your comments or Download question paper.

Question is ⇒ A frequency doubler has an FM signal input at 13 MHz with a deviation of 5 kHz. The output frequency of the carrier will be, Options are ⇒ (A) 26 kHz, (B) 260 kHz, (C) 26 MHz, (D) 260 MHz, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A frequency doubler has an FM signal input at 13 MHz with a deviation of 5 kHz. The output frequency of the carrier will be
A.	26 kHz [Wrong Answer]
B.	260 kHz [Wrong Answer]
C.	26 MHz [Wrong Answer]
D.	260 MHz [Correct Answer]
View Answer 1 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A hexadecimal odometer displays F52F. The next reading will be
E 52 F
E 52 E
E 53 F
F 53 O

⇒ In Z_RC (s) has a pole at s = ∞, the last element in first Foster realization is
R
C
R and C in series
R and C in parallel

⇒ In microprocessor 8088
8 data bits are multiplexed with 8 least significant bits of address bus
8 data bits are multiplexed with 8 most significant bits of address bus
16 data bits are multiplexed with 16 bits of address bus
none of the above

⇒ In level clocking the output can change
on rising edge of clock cycle
on falling edge of clock cycle
during entire half cycle of the clock
none of the above

⇒ The register set and instruction set of 8088 is similar to that of
8085
8086
partly 8085 and partly 8086
none of the above

⇒ An increase in junction temperature of a semiconductor diode
causes a small increase in reverse saturation current
causes a large increase in reverse saturation current
does not affect reverse saturation current
may cause an increase or decrease in reverse saturation current depending on rating of diode

⇒

Assertion (A): A parallel resonant circuit is also called anti-resonant circuit.

Reason (R): In a parallel resonant circuit impedance is maximum at resonance.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ In which of the following case the rating of the transformer to deliver 100 watts of d.c. power to a load, will be least?
Half wave rectifier
Full wave rectifier
Bridge type full wave rectifier
Three phase full wave rectifier

⇒ In the figure shows the circuits symbo
FET
PMOSFET
CMOSFET
NMOSFET

⇒ The Z inverse of the given Z transfor
Unit step
Unit ramp
Unit impulse
Unit parabola

⇒ Square law modulators utilise
linear range of V-I characteristics of a diode
linear range of V-I characteristics of a triode
non-linear region of V-I dynamic characteristics of a diode
non-linear region of V-I dynamic characteristics of a triode

⇒ The reverse saturation current in a semiconductor diode consists of
avalanche current
zener current
minority carrier current
minority carrier current and surface leakage current

⇒ Which of the following closely represents the resistance-temperature characteristics of thermistor?
R_T = a R₀ e^b/t
R_T = a R₀ E^-b/t
R_T = - a R₀ e^-b/t
R_T = - R₀ e^b/t

⇒ The magnitude response of a normalised Butterworth low pass filter is
linear starting with value of unity at zero frequency and 0.707 at cut off frequency
non linear all through but with values of unity at zero frequency and 0.707 at cut off frequency
linear upto cut off frequency and nonlinear thereafter
nonlinear upto cut off frequency and linear thereafter

⇒ Let f₁(t) = G₁(t) + 4, f₂(t) = G₂(t) + 3. If G₁(t) and G₂(t) are uncorrected then the correlation between f₁(t) and f₂(t) are
12
7
6
zero

⇒ A high resistance was measured by loss of charge method. The voltmeter resistance was 10¹⁰ ohms. The calculation gave the value of unknown resistance as 0.8 x 10⁹ ohms. The true value of resistance is
0.8 x 10⁹ Ω
less than 0.8 x 10⁹ Ω
more than 0.8 x 10⁹ Ω
either (b) or (c)

⇒ For a system to work, as oscillator the total phase shift of the loop gain must be equal to
90°
45°
270°
360°

⇒ Separation property of state-transition matrix is
φ(t - t₀) = φ(t) φ(t₀)
φ(t - t₀) = φ^-1(t) φ^-1(t₀)
φ(t - t₀) = φ(t) φ^-1(t₀)
φ(t - t₀) = φ^-1(t) φ^-1(t₀)

⇒ A voltage wave having 5% fifth harmonic content is applied to a series RC circuit. The percentage fifth harmonic content in the current wave will be
0.05
more than 5%
less than 5%
equal or more than 5%

⇒ Consider the following DO statement in Fortran 77 1
10
3
4

⇒ The v-i characteristics of a diode may be linear or non linear.
TRUE
FALSE

⇒ In 8085 microprocessor, which of the following interrupts has the highest priority?
RST 5.5
RST 7.5
TRAP
INTR

⇒ Which of the following bridges is also used in an oscillator?
Maxwell
Schering
Hay
Wien

⇒

Assertion (A): A half wave controlled rectifier has poorer efficiency and higher ripple factor than a full wave controlled rectifier.

Reason (R): The use of a freewheeling diode in half wave controlled rectifier circuit improves the waveform of load current and circuit power factor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The directive gain of a transmitting antenna is
proportional to wavelength
inversely proportional to wavelength
proportional to square of wavelength
inversely proportional to square of wavelength

⇒ The forbidden band in semiconductors is of the order of
6 eV
1 eV
10 eV
0.01 eV

⇒ As regards ferromagnetic Curie temperature Q_f and paramagnetic curie temperature θ
Q_f > θ
θ > Q_f
θ equal to or less than Q_f
θ may be equal to less than or more Q_f

⇒ Wagner earthing device is used to eliminate error due to
electromagnetic coupling
electrostatic coupling
both electrostatic and electromagnetic coupling
either (a) or (b)

⇒ Maximum effective aperture (A_e)max of short dipole antenna is
1.119 λ²
0.119 λ²
1.19 λ²
1.919 λ²

⇒ If the secondary burden of a CT 15 VA and secondary current is 5 A, the load impedance of CT is
0.6 Ω
5 Ω
6 Ω
10 Ω