Question is ⇒ In the graphical analysis of CE amplifier circuit, the upper end of load line is called, Options are ⇒ (A) saturation point, (B) cut off point, (C) Q point, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In the graphical analysis of CE amplifier circuit, the upper end of load line is called, Options are ⇒ (A) saturation point, (B) cut off point, (C) Q point, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the graphical analysis of CE amplifier circuit, the upper end of load line is called
A.	saturation point [Correct Answer]
B.	cut off point [Wrong Answer]
C.	Q point [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -2 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A TRIAC is a semiconductor device which acts as a
2 terminal unidirectional switch
2 terminal bidirectional switch
3 terminal bidirectional switch
4 terminal multidirectional switch

⇒ A series R, L, C circuit has R = 2Ω, L = 1H, C = 1 μF. It is connected to an ac variable frequency source of peak voltage 10 V. At resonance the power supplied by the source will be
50 Ω
25 Ω
12.5 Ω
6.25 Ω

⇒ The advantages of flash memory over EEPROM are
higher density
lower cost
both higher density and lower cost
none of the above

⇒ In a FM waveform, the side bands are spaced at intervals equal to
four times the modulating frequency
twice the modulating frequency
half the modulating frequency
modulating frequency

⇒ In the circuit shown in figure the current I of sinusoidal sourc
25 A
0.166666666666667
20 A
Not determinable from given data

⇒

Match the following:

	List I		List II
A.	LED	1.	Heavy Doping
B.	Avalanche Photodiode	2.	Coherent Radiation
C.	Tunnel diode	3.	Spontaneous Emission
D.	LASER	4.	Current gain

A-2, B-4, C-3
A-2, B-3, C-1, D-4
A-3, B-4, C-1, D-2
A-2, B-1, C-4, D-3

⇒ The electric field of an EM wave propagating in the z direction given
linearly polarized in z direction
elliptically polarized
left hand circularly polarized
right hand circularly polarized

⇒ The relaxation time of electrons in a metal is of the order of
10^-6 secs
10^-10 secs
10^-14 secs
10^-20 secs

⇒ Radiation resistance of an antenna is a
dc resistance
ac resistance
either (a) or (b)
none of the above

⇒ Which of the following is Doppler effect not used?
CW radar
FM radar
MTI system
Moving target plotting on PPI

⇒ Which of the following noise becomes of great importance at high frequencies?
Transit-time noise
Shot noise
Flicker noise
Agitation noise

⇒ Wired AND connection can be used in TTL with totem pole output.
TRUE
FALSE

⇒ For most static RAM the write pulse width should be at least
10 ns
60 ns
300 ns
1 μs

⇒ In a resistance loaded, RC coupled amplifier the d.c. component is blocked by
Transistor
C_C
R_B
R_C

⇒ The disadvantage of transformer coupling in amplifier is
cost of transformer at audio frequencies
size of transformer at audio frequencies
size of transformer at radio frequencies
cost and size of transformer at audio frequencies

⇒ If the inputs to a 2 input XOR gate are high then, the output is high.
TRUE
FALSE

⇒ Which of the following is not an interrupt line in 8085?
TRAP
RST 5.5
RST 7.5
RST 9.5

⇒ In the circuit of figure β = 50 and V_BE = 0.5 V. The quiescent value of base current I_{Babout 28 μA
about 28 mA
about 0.28 μA
about 2.8 A}

⇒ In solid dielectrics the rate of deterioration doubles for every 10-12°C rise in temperature.
TRUE
FALSE

⇒ The input impedance of CRO is about
zero
10 Ω
100 Ω
one mega ohm

⇒ Which of the following statement is correct for two wattmeters method of power measurement in 3 phase circuit?
Power can be measured by this method only for star connected loads
When two wattmeters have equal readings power factor is 0.5.
When power factor is 1, one of the wattmeters readings is zero
When the two wattmeter read equal and opposite, p.f. is zero.

⇒ Turn off time of a transistor switch is equal to (where t_s is storage time and t_f is fall time.)
t_s + t_f
t_s - t_f
2t_s
2t_f

⇒ The load end of a quarter wave transformer gets disconnected thereby causing an open-circuited load. What will be the input impedance of the transformer?
Zero
Infinite
Finite and Positive
Finite and Negative

⇒

Assertion (A): Demodulation of SSB and AM signals is exactly similar

Reason (R): The basic SSB demodulation device is product detector.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Consider the following, logic diagr
0000 to 1111
0000 to 1001
0000 to 1010
1001 to 0000

⇒ The inputs to a 4 channel MUX have the following bandwidths. Channel 1-50 Hz, channel 2-200 Hz. Channel 3-75 Hz. Channel 4-90 Hz. The theoretical minimum sampling rate of the MUX is
200 Hz
400 Hz
415 Hz
1600 Hz

⇒ Using the same flip flops
a synchronous flip flop can operate at higher frequency than ripple counter
a ripple counter can operate at higher frequency than synchronous counter
both ripple and synchronous counter can operate at the same frequency
can not determine

⇒ In a channel voice coder, the outputs of sixteen 20 Hz low pass filters are sampled, multiplexed and A/D converted. If sampling is at 40 samples/second and 3 bits/sample represents each voltage sample, the bit rate is about
1.9 k bits/sec
0.95 k bits/sec
3.8 k bits/sec
7.6 k bits/sec

⇒ Decimal 1932 when converted into 10's complement will become
8868
8060
8608
8806

⇒

Match the following:

	List I		List II
A.	Mu Metal	1.	very high magnetic permeability
B.	Samrium/cobalt	2.	very high magnetic remanence
C.	Sapphire	3.	very high thermal conductivity
D.	Ferrites	4.	very stable magnetic permeability

A-1, B-2, C-3, D-4
A-3, B-4, C-1, D-2
A-2, B-3, C-4, D-1
A-4, B-1, C-2, D-3