Question is ⇒ Figure shows the V-<i>i</i> characteristics of a material. The material is likely t, Options are ⇒ (A) copper, (B) carbon, (C) zinc oxide, (D) rubber, (E) , Leave your comments or Download question paper.

Question is ⇒ Figure shows the V-<i>i</i> characteristics of a material. The material is likely t, Options are ⇒ (A) copper, (B) carbon, (C) zinc oxide, (D) rubber, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Figure shows the V-i characteristics of a material. The material is likely t
A.	copper [Wrong Answer]
B.	carbon [Wrong Answer]
C.	zinc oxide [Correct Answer]
D.	rubber [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In 8085 microprocessor, when TRAP interrupt is triggered program control is transferred to location
0020 H
0024 H
0028 H
002 CH

⇒ An amplifier has open loop gain of 100, input impedance 1 kΩ and output impedance 100 Ω. If negative feedback with β = 0.99 is used, the new input and output impedances are
10 Ω and 1 Ω
10 Ω and 10 kΩ
100 kΩ and 1 Ω
100 kΩ and 10 Ω

⇒ If 137 + 276 = 435 how much is 731 + 672?
534
1403
1623
1513

⇒ With the switch in STOP position, Y will be equa
0
1
CLK
none of these

⇒ Which of the following draws minimum power from source?
PMMC
Electronic voltmeter
Electrostatic voltmeter
Moving iron voltmeter

⇒ The electrolyte in nickel cadmium cell is dilute potassium hydroxide.
TRUE
FALSE

⇒ A TV receiver has a width of 60 cm. The aspect ratio is 4/3. The required EHT supply is about
29 kV
2.9 kV
45 kV
4.5 kV

⇒ Before doping the semiconductor material is
dehydrated
heated
hardened
purified

⇒ For formation of state equations, the inductors and current sources
should be in tree
should be in cotree
may be in tree or cotree
should be in both tree and cotree

⇒ In figure the cut in voltage of diode is 0.7 V and its bulk resistance is 20 Ω. The peak value of circuit current of during positive and negative half cycles
10 mA and zero
9.12 mA and zero
9.3 mA and zero
zero and 9.12 mA

⇒ In the field controlled motor the entire damping comes from
armature resistance
back emf
motor friction and load
field resistance

⇒ Two RLC series circuit has same damping ratio. Circuit 1 has higher natural frequency as compared to circuit 2. Then
transients in circuit 2 will decay faster
transients in circuit 1 will decay faster
transients in both circuits will decay at the same rate
transients in any one may decay faster than in the other

⇒ The effect of current shunt feedback in an amplifier is to
increase the I/P resistance and decrease the O/P resistance
increase both I/P and O/P resistance
decrease both I/P and O/P resistance
decrease the I/P resistance and increase O/P resistance

⇒ As the bandwidth increases, the cost of components
generally decreases
generally increases
may increase or decrease
does not change

⇒ A pre-emphasis circuit provides extra noise immunity by
converting the phase modulation of FM
preamplifying the whole audio band
amplifying the higher audio frequencies
boosting the pass frequencies

⇒ The output V₀ in figur
-100 V
-100 mV
10 V
10 mV

⇒ In a series LCR circuit the maximum inductor voltage is twice the maximum capacitor voltage however current lags by 30° and drop across the inductance is v_L = 100 sin 377t V. Assuming the resistance being 20 Ω, Find the values of the capacitance and inductance.
235 μF, 61.18 μH
230 μF, 61.18 μH
61.18 μF, 230 μH
None of the above

⇒ The function of duplexer in a RADAR is
to permit the use of same antenna for transmission and reception
to provide gain to the transmitted power
to amplify the received signal
both (b) and (c)

⇒ PAL stands for
Phase Attenuation by Line
Phase Alternation by Line
Parabolic Alternation by Line
Picture Alternation by Line

⇒ It two voltages are v₁ = 100 sin (ωt - 30°) and v₂ = cos ω t then
v₁ is leading v₂ by 30°
v₂ is leading v₁ by 30°
v₂ is leading v₁ by 60°
v₁ is leading v₂ by 60°

⇒ One of the advantages of base modulation over collector modulation in a class C transistor amplifier is
higher efficiency
more linear operation
more power output per transistor
lesser requirement of modulating power

⇒ All magnetic materials exhibit the phenomenon of saturation.
TRUE
FALSE

⇒ A silicon PN junction with no bias have a doping concentration
3.345 x 10^-3 cm
3.345 x 10^-4 cm
3.345 x 10^-5 cm
3.345 x 10^-6 cm

⇒ In floating point representation, mantissa is expressed in
excess 3 notation
gray code
excess 32 notation
2's complement

⇒ In p mode of operation of magnetron the spikes due to phase focussing effect rotate at an angular velocity corresponding to
one pole/cycle
two pole/cycle
four pole/cycle
six pole/cycle

⇒ For Ergodic Process
ensemble Average equal to time Average
ensemble Average is not equal to time Average
ensemble Average > Time Average
ensemble Average < Time Average

⇒ In 8085
P flag is set when the result has even parity
P flag is set when the result has odd parity
P flag is reset when the result has odd parity
P flag is reset when the result has even parity

⇒ In monolithic ICs, all the components are fabricated by
diffusion process
oxidation
evaporation
none

⇒ Which of the following insulating material is restricted to temperatures below 100°C?
Micanite
Asbestos
Teflon
Polythene

⇒ In a tape recorder the erase head is
engaged during playback but disengaged during recording
engaged both during recording and playback
disengaged both during recording and playback
engaged during recording but disengaged during playback