Question is ⇒ Which of the following transformers has low primary current?, Options are ⇒ (A) Current transformer, (B) Potential transformer, (C) Distribution transformer, (D) Both (a) and (b), (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following transformers has low primary current?, Options are ⇒ (A) Current transformer, (B) Potential transformer, (C) Distribution transformer, (D) Both (a) and (b), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following transformers has low primary current?
A.	Current transformer [Wrong Answer]
B.	Potential transformer [Correct Answer]
C.	Distribution transformer [Wrong Answer]
D.	Both (a) and (b) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In single tone AM modulation, the transmission efficiency for m = 1 is
0.333
0.5
1
0.1665

⇒ Read the following statements about Excel

It supports many arithmetic functions like SUM, ABS, EXP, INT, MOD etc.
It supports many trigonometric functions.
It supports IRR function to calculate interest rate.
It supports PV function to calculate the present value of future receipts.

Which of the above are correct?
All
1, 2 and 3 only
1, and 2 only
1 only

⇒ A ring counter with 5 flip-flops will have __________ states.
5
10
32
Infinite

⇒ The two-transistor model of a thyristor consists of two transistors :
one n-p-n and other p-n-p
both p-n-p
both n-p-n
one n-p-n and other UJT

⇒

Assertion (A): Bandwidth of a TV signal is 5 MHz.

Reason (R): TV systems use vestigial side band transmission.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Figure shows the V-i characteristics of a material. The material is likely t
copper
carbon
zinc oxide
rubber

⇒ A voltage of 9 V is applied in forward direction to a semiconductor diode in series with a load resistance of 1000 Ω. The voltage across the load resistance is zero. It indicates that
diode is short circuited
diode is open circuited
resistor is open circuited
diode is either o.c or s.c

⇒ Which of the following meters requires an external power source for its operation?
P.M.M.C. meter
Hot wire ammeter
Electronic voltmeter
Electrodynamometer

⇒ In each of circuits below, indicate which diode is conduct
Figure A
Figure B
Figure C
All the three

⇒ The upper end of the d.c. load line is called the __________ point and the lower end is the __________ point.
cut off, saturation
saturation, active
saturation, cut off
active saturation

⇒

Assertion (A): Temperature control of the passenger compartment of car uses both feed forward and feedback controls.

Reason (R): Feed forward control gives corrective action before the disturbance affects the output and feedback control applies corrective action after output changes.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ Which of the following computer memories is fastest?
Cache
Primary
Mass storage
Off line back up

⇒ Read the following statements about address space in microprocessors

An address space is a set of all possible addresses which can be generated by a microprocessor.
Each address in the address space allows a designer to provide at least one memory or I/O location in the system.
Two types of address spaces are memory and I/O address space.
Some micro processors have only one type of address space.

Which of the above are correct?
All
1, 2, 3 only
1, 2, 4 only
1, 3, 4 only

⇒ For maximum unclipped output from a CE amplifier, the Q point should be
at the centre of dc load line
at the centre of ac load line
at the centre of collector current
none of the above

⇒ If X(z) = (1 - a)z^-1/[(1 - z^-1)(1 - az^-1)] and 1 < |z|, the final value of x_k is
0
1
∞
2

⇒ In a microprocessor system the stack is used for
starting the program return address whenever a subroutine jump instruction is execute
transmitting and receiving input and output data
starting all important CPU register contents whenever an interrupt is to be serviced
storing program instructions for interrupt service routine

⇒ The following properties are associated with ferroelectric materials:

Its susceptibility is negative.

The susceptibility is expresse
1 only
1 and 3
2 only
1, 2 and 3

⇒ The most noise resistant modulation system is
PCM
SSB suppressed carrier
FM
pulse position modulation

⇒ In an RC series circuit excited by dc voltage E, the current at t = 0 is
E/R
E/C
zero
infinity

⇒ The core of an atom consists of
nucleus
nucleus and all orbits
nucleus and inner orbits
none of the above

⇒ Half bridge and full bridge inverters of one type use different commutation methods.
TRUE
FALSE

⇒ A two branch parallel tuned circuit has a coil of resistance 100 Ω and inductance 0.005 H in one branch and 10 nF capacitor in the second branch. At resonance frequency, the dynamic resistance is
1 Ω
10 Ω
100 Ω
more than 100 Ω

⇒
Assertion (A): Microprocessor 8085 has an 8 bit register called accumulator which stores intermediate answers during a computer operation.
Reason (R): Accumulator can send or receive data.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ The thermionic emission current is given by
Fermi-Dirac distribution
Maxwell's equation
Richardson Dushman equation
Langmuir Child law

⇒ Given figure shows the magnitude plot for a system. The steady state error for unit step inpu
1/101
1/100
14977
14611

⇒ The energy to cause thermionic emission is supplied by heating the cathode.
TRUE
FALSE

⇒ For a symmetrical network
z₁₁ = z₂₂
z₁₂ = z₂₁
z₁₁ z₂₂ and z₁₂ = z₂₁
z₁₁ z₁₂ - z₁₂² = 0

⇒ Capacitive transducer is superior to inductive type for measurement of capacitance because of
absence of non-linearity
high frequency response
small size
high accuracy

⇒ Two resistances R₁ = 18.7 Ω. and R₂ = 3.624 Ω in series. The total resistance to the appropriate number of significant figures is
22.324 Ω
22.32 Ω
22.3 Ω
22 Ω

⇒ The approximate value of input impedance of CE amplifier with emitter resistance R_E is given by
h_ie + A_i R_E
h_ie + (1 + h_fe) R_E
h_ie
(1 + h_fe) R_E