Question is ⇒ In an RC-coupled amplifier for improving the low frequency response, Options are ⇒ (A) lower RL is provided, (B) more bias is used, (C) less gain is provided, (D) higher CC is used, (E) , Leave your comments or Download question paper.

Question is ⇒ In an RC-coupled amplifier for improving the low frequency response, Options are ⇒ (A) lower RL is provided, (B) more bias is used, (C) less gain is provided, (D) higher CC is used, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In an RC-coupled amplifier for improving the low frequency response
A.	lower R_L is provided [Wrong Answer]
B.	more bias is used [Wrong Answer]
C.	less gain is provided [Wrong Answer]
D.	higher C_C is used [Correct Answer]
View Answer 2 -2 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ For a BJT if β = 50, I_CEO = 3 μA and I_C = 1.2 mA then I_B
24 μA
23 μA
20 μA
10 μA

⇒ In a TWT the loss in attenuator is
almost equal to forward gain of tube
much less than forward gain of tube
much higher than forward gain of tube
almost infinite

⇒ When a semiconductor bar is heated at one end, a voltage across the bar is developed. If the heated is positive the semiconductor is
P-type
n-type
intrinsic
highly degenerate

⇒ What is the period of the sinusoidal signal x(n) = 5 cos [0.2 pn]?
10
5
1
0

⇒ The gate width of a monostable multivibrator is given by
T = 1.1 RC
T = 0.693 RC
0.963 RC
T = 0.369 RC

⇒ A (0.75 - j50) ohm load is connected to a coaxial transmission line of Z₀ = 75 ohms at a frequency of 10 GHz Which of the following will be the best method of matching?
Connecting an inductance at the end
Connecting a short circuited stub at the load
Connecting a capacitance at some distance from the load
Connecting a short circuited stub at some specified distance from the load

⇒ Magnetic field intensity has the dimensions
IL
I²L
IL^-1
IL^-2

⇒ Phase velocity of waves propagating in a hollow metal waveguide is
greater than the group velocity
less than the velocity of light in free space
equal to the velocity of light in free space
equal to group velocity

⇒ Which one of the following statements is not a property of RL driving point impedance?
The first critical frequency at the origin is a zero
The last critical frequency is a pole
The impedance at S = ∞ always less than the impedance at S = zero
The slope of the impedance curve is positive at all points

⇒ Which one of the following is not LED material?
GaAs
GaP
SiC
SiO₂

⇒ If the Q of a single-stage single-tuned amplifier is doubled, then its bandwidth will
remain same
become half
become doubled
become four times

⇒

Assertion (A): BCD code is used in pocket calculators

Reason (R): BCD code is slower than binary.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒

Match the following:

	List I		List II
A.	Interface	1.	A measure of rate of data transmission
B.	A bit	2.	A binary digit
C.	Band speed	3.	The common boundary between various sections and subsections
		4.	A/D converter

A-3, B-2, C-1
A-3, B-1, C-2
A-2, B-4, C-1
A-4, B-2, C-3

⇒

Assertion (A): Impedance matching can be done by using stubs.

Reason (R): A double stub is used for impedance matching when frequency of signal varies.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ Which of the following is not a valid variable name in C?
p_ce1
1p_ce
p1_ce
p _ced

⇒ A duplexer is used to
couple two antennas to a transmitter
isolate the antenna from the local oscillator
prevent interference between two antennas connected to receiver
use an antenna for reception or transmission without interference

⇒ In amplitude modulation
the amplitude of carrier varies in accordance with the amplitude of the modulating signal.
the modulating frequency lies in the audio range
the amplitude of the carrier remains constant
the amplitude of the carrier varies in accordance with the frequency of the modulating signal.

⇒ Consider the following statements

Tellegen's theorem is applicable to any lumped network.
Reciprocity theorem is applicable to linear bilateral network.
Thevenin theorem is applicable to two terminal linear active network.
Norton's theorem is applicable to linear active network.

Which of the above statements are correct?
1, 2 and 3
1, 2, 3 and 4
1, 2 and 4
3 and 4

⇒ The modulation index of an AM wave is measured using a CRO. The waveform is as shown in figure, the modulation index is nea
0.43
0.3
0.23
0.17

⇒

Assertion (A): The gain of an FET amplifier can be changed by changing g_m

Reason (R): Most receivers use automatic gain control to counteract changes in volume caused by fading

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ A T.V. station works at 300 MHz and radiates 100 kW of power. This signal received at a distance of 200 km will be
a few μV/m due to attenuation by atmosphere
1-5 mV due to ionospheric reflection
nil since propagation is line of sight
nil because signal fades completely at 300 MHz

⇒ How many lines are there in address bus of 8085 μp?
6
8
12
16

⇒ Phase modulation is commonly-used for data transmission mainly because
phase can be varied from + 180° to 180°
it is resistant to the effects of noise
demodulation is very easy
it gives highest data rates that can be transmitted over a given channel

⇒ Which of the following 8085 instructions do not effect CY flag?
SEE M
SEE R
DCRM
ADC M

⇒ When a p-n junction is reverse biased
holes and electrons move away from the junction
holes and electrons move towards the junction
holes move towards junction and electrons move away from junction
holes move away from junction and electrons move towards junction

⇒ Huffman code is also known as redundancy code
TRUE
FALSE
in some cases
depend upon efficiency

⇒ In using mesh current method it is necessary that at least one mesh current links every element.
TRUE
FALSE

⇒ The overall noise temperature T_e, absolute temperature T and noise figure F are related as
T_e = T(F - 1)
T_e = F(T - 1)
T = T_e(F - 1)
T_e = (T)(F)

⇒ In a BJT CE amplifier circuit the value of coupling capacitor should be such that
its reactance is small for the lowest frequency in the input and output
its reactance is high for the lowest frequency in the input and output
its reactance is zero for the lowest frequency in the input and output
its reactance is infinite for the lowest frequency in the input and output

⇒

Assertion (A): Oxide coated cathodes are very commonly used.

Reason (R): Work function of oxide coated cathode is 1 eV whereas it is 4.5 eV for pure tungsten.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true