Question is ⇒ The conductivity of an intrinsic semiconductor is, Options are ⇒ (A) generally less than that of a doped semiconductor, (B) given by σ1 = eni (μn - μp), (C) given by σ1 = eni (μp + μn), (D) given by σ1 = ni (μn + μp), (E) , Leave your comments or Download question paper.

Question is ⇒ The conductivity of an intrinsic semiconductor is, Options are ⇒ (A) generally less than that of a doped semiconductor, (B) given by σ1 = eni (μn - μp), (C) given by σ1 = eni (μp + μn), (D) given by σ1 = ni (μn + μp), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The conductivity of an intrinsic semiconductor is
A.	generally less than that of a doped semiconductor [Wrong Answer]
B.	given by σ₁ = en_i (μ_n - μ_p) [Wrong Answer]
C.	given by σ₁ = en_i (μ_p + μ_n) [Correct Answer]
D.	given by σ₁ = n_i (μ_n + μ_p) [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the self biasing scheme (R_F across collector to base) of BJT, S₁ tends to unity by __________ R_C is the collector load Resistance.
increasing R_F
decreasing R_F
decreasing R_F and increasing R_C
increasing R_F and decreasing R_C

⇒ The network shown in the figure represen
band pass filter
low pass filter
high pass filter
band stop filter

⇒ The hexadecimal number given below represent decimal numbers which are multiples of DC, C8, BE, 46, IE
2
6
7
10

⇒ In TE₁₀ mode of rectangular waveguide
there is one half sine wave variation along x direction and one along y direction
there is one half sine wave variation along y direction and one along x direction
there is one full sine wave variation along x direction and one along y direction
none of the above

⇒ When microprocessor processes both positive and negative numbers, the representation used is
l's complement
2's complement
signed binary
any of the above

⇒ As per BIS, the number of accuracy classes of instrument is
5
6
7
8

⇒ A signal f(t) = cos 10pt + 3 cos 4pt is instantaneously sampled. The maximum allowable value of sampling interval T_s in sec is
1 / 4 sec
1 / 8 sec
1 / 8p sec
1 / 10 sec

⇒ Which of the following integer expressions is incorrect in Pascal?
L div M + P
A * * B
A div B - C
A mod B

⇒ With 2's complement representation, the range of values that can be represented on the data bus of an 8 bit microprocessor is given by
-128 to 127
-128 to +128
-127 to 128
-256 to 256

⇒ A fully controlled bridge converter feeds a highly inductive load such that the load current can be assumed to be constant. The wave shape of input current is
dc
sinusoidal
rectangular
none of the above

⇒ Consider the following statements about a moving iron instrument

It is an unpolarised instrument.
It has permanent magnet.
It has a fixed coil.
It has two iron vanes.

Of these statements
1, 2, 3 are correct
1, 2, 4 are correct
1, 3 and 4 are correct
2, 3, 4 are correct

⇒ In figure, E = 1 V (rms value). The average power is 250 mW. Then phase angle between E and
90°
60°
45°
30°

⇒ In a perfect conductor the incident and reflected wave combine to produce
a stronger incident wave
a stronger reflected wave
a standing wave which is not progressing
none of the above

⇒ For an illumination control circuit it is advisable to use a matched TRIAC-DIAC pair.
TRUE
FALSE

⇒ A 400 W carrier is amplitude modulated with m = 0.75. The total power in AM is
400 W
512 W
588 W
650 W

⇒ The gain of collinear arrays is maximum when the spacing between the elements is
0.1 λ to 0.3 λ
0.3 λ to 0.9 λ
0.5 λ to 0.7 λ
0.7 λ to 0.9 λ

⇒ A capacitor with initial charge q₀ at t = 0⁺ acts as
current source
voltage source
short-circuit
open-circuit

⇒ The total number of leads in MOS controlled thyristor is
2
3
4
2 or 3

⇒ For emitter-couple logic, the switching speed is very high because
negative logic is used
the transistors are not saturated when conducting
emitter-coupled transistors are used
multi-emitter transistors are used

⇒ Transformer coupling is mostly used in
RF amplifier
audio amplifier
both audio and RF amplifier
none of the above

⇒ Ferrities are particularly suited for high frequency applications because of their
low distortion
low eddy current loss
high conductivity
high mobility

⇒

Assertion (A): For same drain current rating N-channel MOSFET occupies more area than p-channel MOSFET.

Reason (R): Electron mobility is much higher than hole mobility.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ For BJT transistor. The maximum power dissipation is specified as 350 mW if ambient temperature is 25°C. If ambient temperature is 60°C the maximum power dissipation should be limited to about
100 mW
250 mW
450 mW
600 mW

⇒ In 8085 microprocessor, how many lines are there in address bus?
6
8
12
16

⇒ In a CRO which of the following is not a part of electron gun
cathode
grid
accelerating anode
X - Y plates

⇒ For FM, which of the following statement is not true?
The bandwidth increases as modulation index is increased
The total power remains constant with respect to modulation index
The carrier never becomes zero
All of the above

⇒ In active filter circuits, inductances are avoided mainly because they
are always associated with some resistance
are bulky and unsuitable for miniaturisation
are non-linear in nature
saturate quickly

⇒ A resistance is measured by voltmeter-ammeter method. The voltmeter is 0-250V, ± 1% accuracy and ammeter is 0-5 A, ± 1 % accuracy. The readings of voltmeter and ammeter are 100 V and 2 A respectively. The error in the measured resistance can be
± 1%
± 2%
± 5%
± 10%

⇒ Consider the following in C

An arithmetic operation between integer and an integer gives integer as the result.
An arithmetic operation between a real and a real constant gives real constant as the result.
An arithmetic operation between an integer constant and a real constant is not valid.

Which of the above are correct?
All
1 and 2 only
2 and 3 only
1 and 3 only

⇒ An ac circuit has an impedance of (3 + j6) ohm for fundamental. The impedance for fifth harmonic is
(15 + j 30) Ω
(15 + j 6) Ω
(3 + j 30) Ω
(3 + j 1.2) Ω