Question is ⇒ Which of the following is incorrect?, Options are ⇒ (A) 11101 + 10 = 11111, (B) (8)8 + (2)8 = (11)8, (C) (8)16 + (7)16 = E, (D) All of them are incorrect, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following is incorrect?, Options are ⇒ (A) 11101 + 10 = 11111, (B) (8)8 + (2)8 = (11)8, (C) (8)16 + (7)16 = E, (D) All of them are incorrect, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following is incorrect?
A.	11101 + 10 = 11111 [Wrong Answer]
B.	(8)₈ + (2)₈ = (11)₈ [Correct Answer]
C.	(8)₁₆ + (7)₁₆ = E [Wrong Answer]
D.	All of them are incorrect [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Which of the following statement is incorrect?
Curl of vector potential is magnetic field density
Electric charges in motion produce magnetic field
Electric charges at rest produce electrostatic field
None of the above

⇒ Consider the following statements as regards BPSK and QPSK:

In BPSK we deal individually with each bit of duration T_b
In QPSK we lump two bits to form a symbol
In both BPSK and QPSK signal changes occur at bit rate
In QPSK the symbol can have any one of four possible values

Which of the above statements are correct?
1, 2, 3, 4
1, 2, 3
1, 2, 4
2, 3, 4

⇒ The electric energy required to raise the temperature of a given amount of water is 1000 kWh. If heat losses are 25%, the total heating energy required is __________ kWh.
1500
1250
1333
1000

⇒

Match the following:

	List I		List II
A.	D Layer	1.	110 km
B.	E layer	2.	10 km
C.	F layer	3.	60 km
D.	Troposphere	4.	350 km

A-3, B-1, C-4, D-2
A-2, B-1, C-4, D-2
A-3, B-2, C-1, D-4
A-4, B-3, C-1, D-2

⇒ For an RC driving point impedance function, the poles and zeros
should alternate on real axis
should alternate only on negative real axis
should alternate on imaginary axis
none of the above

⇒ A 0-150 voltmeter has a guaranteed accuracy of 1% of full scale reading. If actual reading is 83 V, the percentage error is
0.0083
0.01
0.0181
none of the above

⇒ What would be the rms value of a sine wave having the same peak value as that of the above mentioned periodic wave?
42.2 V
19 V
38.2 V
none

⇒ Impedance Z as shown in the given figur
j29 Ω
j9 Ω
j19 Ω
j35 Ω

⇒ Given I_s = 20 A, V_s = 20 V, the current I in the 3 Ω resistance is give
0.166666666666667
0.333333333333333
0.0833333333333333
16 A

⇒

Match the following:

	List I (Digital circuit)		List II (Circuit type)
A.	BCD to 7 segment decoder	1.	sequential circuit
B.	4-to-1 MUX	2.	combinational circuit
C.	4 bit shift register	3.	neither sequential nor combinational circuit

A-2, B-1, C-2, D-1
A-3, B-2, C-1, D-3
A-2, B-2, C-1, D-1
A-3, B-1, C-2, D-3

⇒ Which of the following is not a data base function?
DAVERAGE
MAX
DCOUNT
DSTDEV

⇒ The current I for the netw
0 mA
10.72 mA
10.94 mA
11.32 mA

⇒ In an RLC series circuit having finite values of RLC, the phase difference between applied voltage and current is
always 0°
between 0 and 180°
between 0 and 90°
always 90°

⇒ In a 3 phase full converter, the instantaneous output voltage can have negative part if
firing angle is less than 60°
firing angle is less than 90°
firing angle is more than 60°
firing angle is more than 90°

⇒ An amplifier of passband 450 kHz to 460 kHz will be named as
video amplifier
audio frequency amplifier
tuned voltage amplifier
wideband amplifier

⇒ Which of the following microphones is used as a standard for calibration?
Moving coil
Carbon
Condenser
Ribbon

⇒ For a circular wave guide
cutoff frequency for TE₁₀ and TE₀₁ modes are same
cutoff frequency for TE₁₀ and TE₀₁ modes are different
cutoff frequency for TE₁₀ mode = twice the cutoff frequency for TE₂₀ mode
cutoff frequency for TE₁₀ mode = haf the cutoff frequency for TE₂₀ mode

⇒ In a full bridge single phase inverter feeding RLC load
one thyristor and one diode conduct simultaneously
two thyristors conduct simultaneously
two thyristors or two diodes conduct simultaneously
four thyristors conduct simultaneously

⇒ If a two port network is represented by an equivalent T network, the impedance of shunt arm in terms of ABCD parameters is equal to
1/C
(A - 1)/C
1/B
(D - 1)/C

⇒ In the given figure A = 1, B = 1. B is now changed to a sequence 101010................The outputs X and Y wil
fixed at 0 and 1 respectively
X = 1010.......and Y = 0101........
X = 1010..........and Y = 1010
fixed at 1 and 0 respectively.

⇒ Which of the following is not a valid arithmetic statement in C?
x = x + 1
x = y ^* z
x ^* y = z
z = y / x

⇒ P flag is for parity.
TRUE
FALSE

⇒ The noise margin of a TTL gate is about
0.2 V
0.4 V
0.6 V
0.8 V

⇒ The terminals of a power BJT are called
emitter, base, collector
emitter, base, drain
source, base, drain
source, base, collector

⇒ The function shown in figure, can represent a probability density function for A _______
A = 1/4
A = 1/6
A = 1/9
A = 1/2

⇒ In 8086 the flag which enables or disables external interrupts is
IF
DF
TF
CF

⇒ The output data lines of microprocessor and memories are usually tristated because
more than one device can transmit information over the data bus by enabling only one device at a time
more than one device can transmit information over the data bus at the same time
the data lines can be multiplexed for both I/P and O/P
it increases the speed of data transfers over the data bus

⇒ A waveguide connected to a circularly polarized antenna must be able to efficiently propagate both vertically and horizontally polarised waves.
TRUE
FALSE

⇒ RF amplifiers are used in radio receivers for
improved image frequency rejection
improved rejection of adjacent unwanted signals
prevention of re-radiation of the local oscillator through the antenna of the receiver
all of the above

⇒ For a base current of 10 μA, what is the value of collector current in common emitter if β_dc = 100
10 μA
100 μA
1 mA
10 mA