Question is ⇒ The product of which of the following gives the figure of merit of a logic family?, Options are ⇒ (A) Gain and bandwidth, (B) Propagation delay time and power dissipation, (C) Fan-out and propagation delay time, (D) Noise margin and power dissipation, (E) , Leave your comments or Download question paper.

Question is ⇒ The product of which of the following gives the figure of merit of a logic family?, Options are ⇒ (A) Gain and bandwidth, (B) Propagation delay time and power dissipation, (C) Fan-out and propagation delay time, (D) Noise margin and power dissipation, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The product of which of the following gives the figure of merit of a logic family?
A.	Gain and bandwidth [Wrong Answer]
B.	Propagation delay time and power dissipation [Correct Answer]
C.	Fan-out and propagation delay time [Wrong Answer]
D.	Noise margin and power dissipation [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Skin effect is more pronounced at high frequencies.
TRUE
FALSE

⇒ In 8085 microprocessor, what is the memory word size?
6 bits
8 bits
12 bits
16 bits

⇒ In a voltage regulated power supply the zener operates in the breakdown region when (V_in is input voltage and V_z is zener breakdown voltage)
V_in < V_z
V_in > V_z
V_in = V_z
both (a) or (b)

⇒ In a linear circuit, the superposition principle can be applied to calculate the
voltage and power
voltage and current
current and power
voltage, current and power

⇒ Sampling frequency
100 Hz
200 Hz
400 Hz
none of these

⇒ In EM waves, polarization
is always vertical in an isotropic medium
is caused by reflection
is due to transverse nature of waves
results from longitudinal nature of waves

⇒ The Hall constant in Si bar is given by 5 x 10³ cm³/ coulomb, the hole concentration in the bar is given by
10⁵/cm³
1.25 x 10¹⁵/cm³
1.5 x 10¹⁵/cm³
1.6 x 10¹⁵/cm³

⇒ In figure, the value of R shoul
5 kΩ
50 kΩ
20 kΩ
10 kΩ

⇒ Consider the following sets of values of E, R and C for the circuit in the given fig
1 and 4
1 and 2
3 and 4
2 and 3

⇒ A single layer air cored coil has n turns and inductance L. If a new coil is formed by having 2n turns while keeping the coil length and diameter the same, the new inductance is
0.5 L
L
2 L
4 L

⇒ A low-pass filter frequency responce H (jω) = A (ω) e^jΦ(ω) does not produce any phase distortion, if
A(ω) = Cω², Φ (ω) = kω³
A(ω) = Cω², Φ (ω) = kω
A(ω) = Cω², Φ (ω) = kω²
A(ω) = C, Φ (ω) = kω^-1

⇒ A differential amplifier is invariably used in the I/P stage of all OP-amps. This is done basically to produce the OP-amp with a very high.
CMRR
bandwidth
slew rate
open-loop gain

⇒ The frequency of oscillation in a backward wave oscillator can be changed by
varying the voltage which controls beam velocity
varying the beam current
both by varying the beam current and by light varying the voltage which controls beam velocity
changing the rate of thermionic emission

⇒ If operator 'a' = 1 ∠120° then (1 - a²) =
1 ∠ - 30°
1 ∠ 30°
1 ∠ - 60°
1 ∠60°

⇒ Sweep voltage generators, sweep current generators, multivibrators and blocking oscillators can be combine
negative resistance oscillators
tuned base tuned collector oscillators
relaxation oscillators
L-C tuned oscillators

⇒ While calculating Norton's resistance, all current sources are short circuited.
TRUE
FALSE

⇒ The threshold voltage of a MOSFET can be lowered by

using thin gate oxide
reducing the substrate concentration
increasing the substrate concentration.

Of the above statement
3 alone is correct
1 and 2 are correct
1 and 3 are correct
2 alone is correct

⇒ The selectivity of most receivers is determined largely by
sensitivity
characteristics of IF section
antenna direction
all of the above

⇒ PWM can be generated
by a free running multivibrator
by integrating the signal
by a monostable multivibrator
by differentiating pulse position modulation

⇒ A semiconductor in its purest form called
intrinsic semiconductor
extrinsic semiconductor
P-type semiconductor
N-type semiconductor

⇒ The ripple factor from a capacitor filter __________ as the load resistance __________ .
decreases, decreases
decreases, increases
increases, decreases
increases, increases

⇒

Assertion (A): In a circuit using FET, gate is approximately at dc ground

Reason (R): Self bias stabilizes the quiescent operating point against changes in JFET parameters

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ Some typical examples of macroscopic quantities are
conductivity
µ_r
dielectric constant
all of the above

⇒ In using mesh current method it is necessary that at least one mesh current links every element.
TRUE
FALSE

⇒ At midband frequencies the coupling capacitor in RC coupled CE amplifier may be considered as
open circuit
short circuit
a reactance equal to load resistance
none of the above

⇒ It is very likely in __________ gate family that when one gate is driving number of gates in __________ , a gate having least voltage for saturation may consume large __________ leaving other gates inoperative and this phenomenon is called __________ .
DTL, parallel, current, current - sinking
DCTL, parallel, current, current-lagging
ECL, series, voltage, voltage-deterioration
DCTL, series, current, current-lagging

⇒ Which of the following is a balanced line?
Coaxial line
Strip line
Microstrip line
TV twin lead

⇒ The value of program counter of 6800 at power on are after reset is
0
FFFE
User Programmable
FFFF

⇒ In energy band diagram of p type semiconductor the acceptor energy level is
in valence band
in conduction band
slightly above valence band
slightly below conduction band

⇒ E7F6₁₆ = __________ .
600000₁₀
59382₁₀
9382₁₀
382₁₀