Question is ⇒ If the ratio p(s)/q(s) represents a transfer function then, Options are ⇒ (A) the degree of p(s) may be as small as zero, independent of degree of q(s), (B) the degree of p(s) and q(s) must be equal, (C) the degrees of p(s) and q(s) must not be equal, (D) the degrees p(s) and q(s) must differ by at least two, (E) , Leave your comments or Download question paper.

Question is ⇒ If the ratio p(s)/q(s) represents a transfer function then, Options are ⇒ (A) the degree of p(s) may be as small as zero, independent of degree of q(s), (B) the degree of p(s) and q(s) must be equal, (C) the degrees of p(s) and q(s) must not be equal, (D) the degrees p(s) and q(s) must differ by at least two, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	If the ratio p(s)/q(s) represents a transfer function then
A.	the degree of p(s) may be as small as zero, independent of degree of q(s) [Correct Answer]
B.	the degree of p(s) and q(s) must be equal [Wrong Answer]
C.	the degrees of p(s) and q(s) must not be equal [Wrong Answer]
D.	the degrees p(s) and q(s) must differ by at least two [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): Two equal and opposite travelling waves result in a standing wave.

Reason (R): The ratio of maximum to minimum value of a standing wave is called SWR.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ To obtain very high input and O/P impedance in a feedback amplifier, the type of feedback utilized
voltage series
current series
voltage shunt
current shunt

⇒ A sheet of bakelite is inserted between the plates of an air capacitor. The capacitance will
increase
decrease
remain the same
may increase or decrease

⇒ The power dissipation in a transistor is the product of
emitter current and emitter to base voltage
emitter current and collector to emitter voltage
collector current and collector to emitter voltage
none of the above

⇒ A microwave connector should have high SWR.
TRUE
FALSE

⇒ A stationary process has
all statistical properties independent of time
all statistical properties dependent of time
zero variance
ensemble average equal to time average

⇒ The value of parameter r_e used in r_e transistor model
increases with increase in temperature
decreases with increase in temperature
is not affected by increase in temperature
either (b) or (c)

⇒ As the magnitude of reverse bias is increased, the capacitance of varactor diode
increases
decreases
first increase, then decreases
first decreases then increases

⇒ FM amplifier in a superheterodyne receiver
increases selectivity
suppresses noise
provides improved tracking
improves the rejection of the image frequency

⇒ A transmission line of characteristic impedance z₀ = 50 Ω. Phase Velocity = 2 x 10⁸ m/sec, and length l = 1 m is terminated by a load z₁ = (30 - j 40) ohms. The input impedance of the line for a frequency of 100 MHz will be
(30 + j x 40) Ω
(30 - j 40) Ω
(50 + j x 40) Ω
(50 - j 40) Ω

⇒ Find V_th in the cir
100 V
10 V
0 V
5 V

⇒ In C-language f- = 9 is equivalent to
f = -9
f = f - 9
f = 9 - 1
-f = 9

⇒ Epitaxial growth is used in ICs
because it produces low parasitic capacitance
because it yields back to back isolating pn junction
to grow single crystal n doped silicon on a single crystal p type substrate
to grow selectively single crystal p doped silicon of one resistivity on a p type substrate of a different resistivity

⇒ Radar is essentially an echo ranging system
TRUE
FALSE

⇒ The RC network of wein bridge oscillator consists of resistors and capacitors of values R = 220 kΩ and C = 250 PF Determine the frequency of oscillation
2.98 kHz
3 kHz
2 kHz
10 kHz

⇒ Antiferromagnetic materials do not have permanent dipoles.
TRUE
FALSE

⇒ For a superconductor, magnetisation M in a field H is
extremely small
- H
- I
zero

⇒ In a piezoelectric crystal, the application of mechanical force will cause
plastic deformation of crystal
magnetic dipoles in the crystal
electrical polarization in the crystal
shift in Fermi level

⇒ Which of the following are the non-linear application of op-amp?

Current-to-voltage converter
Comparator
Peak detector
Limiter

Select the correct answer from the codes given below:
1, 2 and 3
2, 3 and 4
1, 3 and 4
1, 2 and 4

⇒ In an RC series circuit excited by dc voltage E, the current at t = 0 is
E/R
E/C
zero
infinity

⇒ Which of the following Boolean Expression correctly represents the relation between P, Q, R and M_{1M₁ = (P OR Q) XOR R
M₁ = (P AND Q) XOR R
M₁ = (P NOR Q) XOR R
M₁ = (P XOR Q) XOR R}

⇒ For a D/A converter, inputs and outputs are given. The output corresponding to digital input 01
2.0 V
2.5 V
3.0 V
4.0 V

⇒ In the graphical analysis of CE amplifier circuit, the intersection of base current and dc load line is called
saturation point
cut off point
Q point
operating point

⇒

Match the following:

	List I		List II
A.	Coastals receiver	1.	VSB
B.	Stereo-multiplexing	2.	Demodulating DSB-SC
C.	TV broad casting	3.	FM radio broad casting
		4.	Slope overload
		5.	Matched filter

A-1, B-3, C-2
A-2, B-3, C-1
A-2, B-1, C-4
A-4, B-3, C-1

⇒ X COPY is an internal DOS command.
TRUE
FALSE

⇒ If f(t) is in volts, then F(jω) is in
volts
volt seconds
volts/sec
volt-sec²

⇒ If sequence y(n) = x(-n) then it is
Causal
Non-Causal
Depends on x(-n)
None

⇒ To protect an SCR against high di/dt we connect
a capacitance in series with SCR
a capacitance in parallel with SCR
an inductance in parallel with SCR
an inductance in series with SCR

⇒ Which of the following is correct? The circuit shown in the fig
1, 2 and 3
2, 3 and 4
1, 3 and 4
1, 2 and 4

⇒ The disadvantage of FET over BJT is
poor high frequency performance
low power-handling ability
low values of voltage gain
all of the above