Question is ⇒ In which mode of BJT operation are both junctions reverse biased?, Options are ⇒ (A) Active, (B) Saturation, (C) Cut off, (D) Reverse active, (E) , Leave your comments or Download question paper.

Question is ⇒ In which mode of BJT operation are both junctions reverse biased?, Options are ⇒ (A) Active, (B) Saturation, (C) Cut off, (D) Reverse active, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In which mode of BJT operation are both junctions reverse biased?
A.	Active [Wrong Answer]
B.	Saturation [Wrong Answer]
C.	Cut off [Correct Answer]
D.	Reverse active [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A current of 1 A in the coil of an iron cored electromagnet causes B = 0.5T. If current is 2A, B =
0.5 T
1 T
1 T or more
1 T or less

⇒ The tuned circuit of the oscillator in a simple AM transmitter employs a 50 H coil and a 1 nanofarad capacitor. If the oscillator output is the carrier frequency will be
448 kHz
555 kHz
625 kHz
712 kHz

⇒ If the atomic number of germanium is 32, the number of electrons in the outer most shell will be
2
3
4
6

⇒ VF glows with __________ colour when activated.
Red
Orange
Bluish green
none of these

⇒ In a Karnaugh map for an expression having 'don't care terms' the don't cares can be treated as
0
1
1 or 0
none of the above

⇒ At room temperature the number of conducting electrons in an intrinsic semiconductor
is almost equal to the number of valence electrons
is about half the number of valence electrons
is small as compared to the number of valence electrons
is a very small fraction of the number of valence electrons

⇒ Which of the following is non-saturating?
TTL
CMOS
ECL
Both (a) and (b)

⇒ In the network of figure it is desired that maximum power be supplied to Z₂. The values of Z₁ and Z₂ are fixed. However the transformation ratio 'a' of transformer can be changed. The value of 'a' for maximum power transfe
|Z₂|/|Z₁|
[|Z₂|/|Z₁|]^0.5
[|Z₂|/|Z₁|]²
[|Z₂|/|Z₁|]^0.75

⇒ In the given figure the number of combinations of three non touching loop
0
1
2
3

⇒ In a CE amplifier the ac signal is increased. Which of the following will not change?
Ac base voltage
Ac collector voltage
Ac emitter voltage
Ac collector voltage and ac emitter voltage

⇒ The advantage of using dual slope ADC in digital voltmeter is that
its conversion time is small
its accuracy is high
its output is in BCD
it does not require a comparator

⇒ Varactor diodes use
silicon
GaAs
either (a) or (b)
neither (a) nor (b)

⇒ Which of the following microphones is used as a standard for calibration?
Moving coil
Carbon
Condenser
Ribbon

⇒ The current through a 10 Ω resistance in a dc circuit having two emf sources is 3A. If this resistance is changed to 20 Ω, the new value of current will be
less than 3 A
equal or less than 3 A
equal to or less or more than 3 A
1.5 A

⇒ Which of the following is used as detector in audio frequency ac bridges?
AC voltmeter
CRO
Head phones
Vibration galvanometer

⇒ Of the four INSAT-I satellites planned by India so for, only __________ has proved to be successful.
INSAT-IA
INSAT-IB
INSAT-IC
INSAT-ID

⇒ For the discrete time system of the given fig
y_k = 0.5 u_{k - 2} - u_k - 0.25 y_k - 1
y_k = 0.5 u_k_{- 1} - u_k - 0.25 y_k - 1
y_k = 0.5 u_k - u_k_{- 1} - 0.25 y_k - 1
y_k = 0.5 u_k_{- 1} - u_k_{- 1} - 0.25 y_k - 1

⇒ Antenna is a __________ element
passive
active
resistive
capacitive

⇒ In the circuit of figure β = 100 and quiescent value of base current is 20 μA. The quiescent value of colle
0.2 μA
2 μA
2 mA
20 mA

⇒ Which of the following is/are not a property/properties power spectral density function Sx(ω)?
Sx(ω) is real function of ω
Sx(ω) is a even function of ω
Sx(ω) is non-positive function of ωSx(ω) ≤ 0 for all ω
All of the above

⇒ In a waveguide if TE mode exist for z direction propagation, then
E_z = 0, H_z ≠ 0
E_z = 0, H_z = 0
E_z ≠ 0, H_z = 0
E_z ≠ 0, H_z ≠ 0

⇒

Assertion (A): Chopper always requires forced commutation

Reason (R): Morgan chopper uses a saturable reactor.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ When two 4 bit parallel adders are cascaded we get
4 bit parallel adder
8 bit parallel adder
16 bit parallel adder
none of the above

⇒ The disadvantage of direct coupled amplifiers is
drift
large size of transistor
low voltage gain
both (b) and (c)

⇒ Two wattmeter method for 3 phase power measurement can be used only for
balanced loads
unbalanced loads
both balanced and unbalanced loads
star connected loads

⇒ Holes and electrons move in opposite directions.
TRUE
FALSE

⇒ The colour of an object is decided by
the reflected colour
the wavelength transmitted through it
reflected colour for opaque object and wavelength transmitted through it for transparent objects
none of the above

⇒ In a power amplifier the collector current flows for 270° of the input cycle. The operations is
class A
class B
class AB
class C

⇒ Binary 1000 will be the result of which of the following?
Binary 1000 - 100
Binary 1011 - 1111
Binary 1111 - 111
Binary 11111 - 1111

⇒ Maximum power transfer theorem finds application in
power circuits
distribution circuits
communication circuits
both power and communication circuits