Question is ⇒ Which of the following combinations has no phase inversion of the signal?, Options are ⇒ (A) Two CE stages, (B) CE and CC stages, (C) Three CE stages, (D) CE stages and emitter follower, (E) , Leave your comments or Download question paper.

Question is ⇒ Which of the following combinations has no phase inversion of the signal?, Options are ⇒ (A) Two CE stages, (B) CE and CC stages, (C) Three CE stages, (D) CE stages and emitter follower, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Which of the following combinations has no phase inversion of the signal?
A.	Two CE stages [Correct Answer]
B.	CE and CC stages [Wrong Answer]
C.	Three CE stages [Wrong Answer]
D.	CE stages and emitter follower [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The most noise resistant modulation system is
PCM
SSB suppressed carrier
FM
pulse position modulation

⇒ In a certain '12 channel TDM' system it is found that channel no. 3 and channel no. 8 are connected to the same input signal. This technique
wastes the channel capacity
takes care of different sampling rate
is required when different bandwidth signals are to be transmitted
reduces noise

⇒ In a series RLC circuit, the current at resonance is I₀ the total energy stored in the circuit at resonance is
LI₀²
2 LI₀²
2 LI₀²
0.5 LI²

⇒ The following components are used to measure power output of a 2 kW TWT amplifier

TWT
Low pass/High pass filter
Low power 20 dB attenuator
40 dB directional coupler with matched load
Power meter.

The correct sequence of connections of these components is:
1, 4, 2, 3, 5
1, 3, 4, 2, 5
1, 2, 4, 3, 5
1, 4, 3, 2, 5

⇒

Match the following:

	List I		List II
A.	RC coupled amplifier	1.	Very low drift
B.	Tuned amplifier	2.	Flat frequency response from zero frequency onwards
C.	Chopper stabilized amplifier	3.	Flat frequency response with upper and lower cut off frequency
D.	DC amplifier	4.	Peak in gain frequency response

A-4, B-3, C-1, D-2
A-3, B-4, C-2, D-1
A-3, B-4, C-1, D-2
A-4, B-3, C-2, D-1

⇒ In case of a low level AM transmitter, the amplifier modulated stage must be
class A
class B
class B (linear)
class C

⇒ McMurray Bedford full bridge inverter uses
natural commutation
auxiliary commutation
complementary commutation
any of the above

⇒ If X(z) = (1 - a)z^-1/[(1 - z^-1)(1 - az^-1)] and 1 < |z|, the final value of x_k is
0
1
∞
2

⇒ Radio broadcasts are generally
amplitude modulation
frequency modulation
both amplitude and frequency modulation
neither amplitude nor frequency modulation

⇒ Which of the following has unique representation of 0?
sign magnitude
1's complement
2's complement
both (b) and (c)

⇒ At a frequency less than the resonant frequency
series circuit is inductive and parallel circuit is capacitive
series circuit is capacitive and parallel circuit is inductive
both circuits are capacitive
both circuits are inductive

⇒ The correct hierarchy of operations for the operators & &, = = , = , * is
& & , = = , = , *
* , = = , & & , =
* , & & , = = , =
= , & & , = = , *

⇒ Consider the following materials

Nickel
Silver
Oxygen
Aluminium

The correct sequence in the order of decreasing permeability is
1, 4, 3, 2
1, 4, 2, 3
4, 1, 3, 2
4, 1, 2, 3

⇒ In a channel voice coder, the outputs of sixteen 20 Hz low pass filters are sampled, multiplexed and A/D converted. If sampling is at 40 samples/second and 3 bits/sample represents each voltage sample, the bit rate is about
1.9 k bits/sec
0.95 k bits/sec
3.8 k bits/sec
7.6 k bits/sec

⇒ In radar system if the antenna diameter is increased by a factor of 4, the minimum range will increased by a factor of
1
2
22
4

⇒ NMOS devices have __________ switching speeds and __________ on-state resistance; as compared with PMOS devices.
slower, higher
faster, lower
faster, higher
slower, lower

⇒ A 6 bit DAC uses binary weighted resistors. If MSB resistor is 20 k ohm, the value of LSB resistor is
20 k ohm
80 k ohm
320 k ohm
640 k ohm

⇒ A dc network has 3 independent nodes and 4 loops. In total analysis, the number of equations is
4
3
2
1

⇒ Double spotting in a receiver is due to
poor sensitivity of RF amplifier
high gain of IF amplifier
inadequate image frequency rejection
all of the above

⇒ The problem associated with tuned-radio frequency receiver is
instability
insufficient adjacent frequency rejection
bandwidth variation
all of the above

⇒ A liquid has N permanent dipoles μ_p per unit volume and has been subjected to dc field for a long time such that orientation polarization is P₀. At t = 0, the field is suddenly removed, then polarization
will remain constant at P₀
will become zero at t = 0
will delay to zero with a time constant
either b or c

⇒ An engineer designs an amplifier to have a voltage gain of 60, but when constructed it only had a gain of 50. Which of the following will increases from this type of operation?
Stability
Bandwidth
Distortion
Input resistance

⇒ The unit of permeability is
T
Wb
H/M
H

⇒ In a microwave power measurement using bolometer, the principle of working is variation of
inductance with absorption of power
resistance with absorption of power
capacitance with absorption of power
cavity dimension with heat generated by power

⇒ When a series RL circuit having power factor angle 0 is switched on to an ac voltage V_m sin (ωt + Φ), the transient term is zero if Φ = 0.
TRUE
FALSE

⇒ An RC series circuit is charged by a voltage E. After a long time the battery is removed and a short circuit is placed across R-C. Then
the polarity of voltage across R is same during discharge and during charge
the polarity of voltage across R during discharging is opposite to that during charging
the polarity of voltage across R depends on time constant RC
none of the above

⇒ A Si sample is doped with a fixed number of group N impurities. The electron density n is measured from 4 K to 1200 k for the sample. Which one of the following is correct?
n remains constant over the temperature range
n increases monotonicaliy with increasing temp
n increases first remains constant over a range and again increases with increasing temperature
n increases show a peak and then decrease with temperature

⇒ A transmission line has Z₀ = 300 Ω and Z_L = (300 - j300) ohm. The transmission coefficient is
1.265 ∠ - 18.43°
1.01 ∠ - 10°
1.14 ∠ 66.68°
1.09 ∠ 66.68°

⇒ In an electrochemical process the mass of material deposited at an electrode is proportional to
time for which current is passed
magnitude of current
electric charge through the electrolyte
none of the above

⇒ The parity bit is
always 1
always 0
1 or 0
none of the above