Question is ⇒ The sum of positive real functions, Options are ⇒ (A) is a positive real function, (B) may be a positive real function or not, (C) can not be a positive real function, (D) either (b) or (c), (E) , Leave your comments or Download question paper.

Question is ⇒ The sum of positive real functions, Options are ⇒ (A) is a positive real function, (B) may be a positive real function or not, (C) can not be a positive real function, (D) either (b) or (c), (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The sum of positive real functions
A.	is a positive real function [Wrong Answer]
B.	may be a positive real function or not [Wrong Answer]
C.	can not be a positive real function [Correct Answer]
D.	either (b) or (c) [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The counter shown in figure is built using 4 negative edge triggered toggle FFs. The FFs can be set synchronously when R = 0. The combinational logic required to realize a modulo 13 counte
F= Q₄ Q₃ Q₂ Q₁
F= Q₄ + Q₃ + Q₂ + Q₁
F = Q₄ + Q₃ + Q₂ + Q₁
F = Q₄ Q₃ Q₂ Q₁

⇒ If the temperature of an extrinsic semiconductor is increased so that the intrinsic carrier concentration is doubled, then
the majority carrier density is doubled
the minority carrier density is doubled
the minority carrier density becomes 4 times the original value
both the majority and minority carrier densities double

⇒ Gain margin and phase margin can be determined from Bode plots as well as Nyquist plot.
TRUE
FALSE

⇒

Assertion (A): In an intrinsic semiconductor J = (μ_n x μ_p)en_i.

Reason (R): Intrinsic charge concentration n_i at temperature T is given by n_i² = A₀ T³ e^-E_G0/kT.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not correct explanation of A
A is true but R is false
A is false but R is true

⇒ In a J-K flip flop the input J = K = 1 pulse is about
set
reset
no change
toggle

⇒ Thevenin's theorem is used to find current in a branch of a network. It is now desired to find current in another branch of the network
the same Thevenin's circuit can be used
the same Thevenin's circuit with some modification can be used
it is necessary to find new Thevenin's circuit
either (b) or (c)

⇒ A 4 bit shift register is initialized to value 1000 for (Q₃, Q₂, Q₁, Q₀). The D input is derived from Q₀, Q₂ and Q₃ through two XOR gates as shown in figure. The pattern 1000 will appea
3rd pulse
7th pulse
6th pulse
4th pulse

⇒ UJT can be used for
firing an SCR
turning off an SCR
both firing and turning off an SCR
none of the above

⇒ A bulb rated at 60 W, 120 V is used for 30 minutes. The charge associated with this operation is
3600 C
900 C
7200 C
600 C

⇒ A transistor may fail due to
open weld at the wire leads to the semi-conductor
short circuit caused by momentary overloads
overheating due to circuit failures
any of the above

⇒ In a TWT the axial component of electric field advances along the tube
at a velocity that is almost equal to speed of light
at a velocity that is a small fraction of speed of light
at a velocity that is about 50% of speed of light
at a velocity that may be even more than speed of light

⇒ A transmission line has a characteristic impedance of 50 Ω and a resistance of 0.1 Ω/m, if the line is distortion less, the attenuation constant (in Np/m) is
500
5
0.014
0.002

⇒ It is required to measure temperature in the range of 1300-1520°C. The most suitable thermocouple is
chromel constantan
iron constantan
chromel aluminium
platinum-rhodium

⇒ The effective length of an λ/2 antenna (Given R_r = 73 Ω and (A_e)_max = 0.13 λ² and η = 120 p is __________ .
0.6348 λ
0.317 λ
0.158 λ
0.371 λ

⇒ In a centre tap full wave rectifier, 50 V is the peak voltage between the centre tap and one of the ends of the secondary. The maximum voltage across the reverse biased diode will be
100 V
72 V
50 V
38 V

⇒ A ramp input applied to a unity feedback system results in 5% steady state error. The type number and zero frequency gain of the system are respectively.
1 and 20
0 and 20
0 and 1/20
1 and 1/20

⇒ State variables which describe a system are a unique set.
TRUE
FALSE

⇒ In a combination limiter with sinusoidal input voltage the output wave can be nearly square.
TRUE
FALSE

⇒ A device that converts from decimal to binary numbered is called
decoder
encoder
CPU
converter

⇒ The saturation current in a semi-conductor diode
depends on forward voltage
depends on reverse voltage
is due to thermally generated minority carriers
none of the above

⇒ Mutual impedance is not depend upon
magnitude of induced current
tuning condition
self impedance
phase relationship between induced and original currents

⇒ The phase velocity of an EM wave propagating in a hollow metallic rectangular waveguide in the TE₁₀ mode is
equal to its group velocity
less than the velocity of light in free space
equal to the velocity of light in free space
greater than the velocity of light in free space

⇒ The amount of photoelectric emission current depends on the frequency of incident light.
TRUE
FALSE

⇒ The following k-map implem
BCD to Decimal Decoder
Decimal to BCD Encoder
1 of 10 Decoder
(a) and (c)

⇒ For the same length of arrays, half power beam-width of binomial array
is equal to that of uniform arrays
is less than that of uniform array
is more than that of uniform array
is negligible as compared to that of uniform array

⇒ In phase modulation, the phase deviation is
proportional to the amplitude of the signal and varies with frequency
remains constant while amplitude and frequency of signal varies
proportional to the amplitude of the signal and independent of the frequency
none of the above

⇒ The stage marked X in the architecture shown below of a two stage op-amp
Direct coupled amplifier
Buffer amplifier
Level shifter
Blocking oscillator

⇒ For a reactance function H(s), the slope dH (jω)/dω is
0
always positive
always negative
either 0 or positive

⇒ In a conductor which of the following relations hold good?
∇ x D = r
∇ . D = r
∇ x D = 0
∇ . D = 0

⇒

Assertion (A): L[e^-at f(t)] = F(s + a)

Reason (R): In use of Laplace transform method, initial conditions may be neglected.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true