Question is ⇒ The voltage across the secondary of the transformer in a half wave rectifier with a shunt capacitor filter is 50 volts. The maximum voltage that will occur on the reverse biased diode will be, Options are ⇒ (A) 100 V, (B) 88 V, (C) 50 V, (D) 25 V, (E) , Leave your comments or Download question paper.

Question is ⇒ The voltage across the secondary of the transformer in a half wave rectifier with a shunt capacitor filter is 50 volts. The maximum voltage that will occur on the reverse biased diode will be, Options are ⇒ (A) 100 V, (B) 88 V, (C) 50 V, (D) 25 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The voltage across the secondary of the transformer in a half wave rectifier with a shunt capacitor filter is 50 volts. The maximum voltage that will occur on the reverse biased diode will be
A.	100 V [Correct Answer]
B.	88 V [Wrong Answer]
C.	50 V [Wrong Answer]
D.	25 V [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ If both emitter base and collector base junctions of a BJT are forward biased, the transistor is in
active region
saturated region
cut off region
inverse mode

⇒ When iron rod is magnetised by the flowing through its coil, the polarities of its different points wil
Pole A is N-pole, B is S-pole and C is neutral
A is N, B and C is S
A is N, C is S
A is S, C is neutral, B is N

⇒ For the block diagram of the given figure, the equation describing system dynamic
(1 + RCs) Δθ₀(s) = Δθ_i(s) + R Δ H(s)
(1 + RCs) [ΔH(s)] = Δθ(s) - Δθ₀(s)
(1 + RCs) Δθ₀(s) = RΔ H(s) - Δ θ_i(s)
(1 + RCs) Δθ_i(s) = Δ H(s)[R] - Δθ₀(s)

⇒ Hysteresis loss is proportional to
f and B^1.6_m
f and B_m
f² and B_m
f² and B²_m

⇒ Symbol in the given figure is IEEE symbol
AND
OR
NAND
NOR

⇒ The stationary process has
all the statistical Properties dependent on time.
all the statistical Properties independent of time.
aime average is equal to ensemble average.
zero variance.

⇒ T.V. antennas are usually
Yagi-Uda
loops
helical
parabolic

⇒ In a reverse biased p-n junction, the reverse bias is 4V. The junction capacitance is about
0.1 F
4 μF
10 nF
20 pF

⇒ A magnetic circuit has an iron length of 20 cm and air gap length 0.1 cm. If μ_r = 200 then
mmf for iron and air gap are equal
mmf for iron is much less than that for air gap
mmf for iron is much more than that for air gap
either (a) or (c)

⇒ Which one of the following power amplifier has the maximum efficiency?
Class A
Class B
Class AB
Class C

⇒ A computer program is used to read M and print the sum 2 + 4 + 6 + 8 +.........+ 2M. If M = 9 , the print out will show the number
9
18
90
100

⇒ Which of the following amplifiers has highest output impedance?
CE
CB
CC
Push pull

⇒ The discussing sharing of a communication satellite by many geographically dispersed Earth station, DAMA means
Demand-Assigned Multiple Access
Decibel Attenuated Microwave Access
Digital Analog Master Antenna
Dynamically-Assigned Multiple Access

⇒ A pulse train with a 1 MHz frequency is counted using a 1024 modulus ripple counter using JK flip flops. The maximum propagation delay for each flip-flop should be
1 μs
0.5 μs
0.2 μs
0.1 μs

⇒ Which of the following is incorrect?
(111)₂ + (10)₂ = 9
(111)₂ + (2)₁₀ = (9)₁₆
7 + 2 = (1001)₂
None of the above

⇒ For a transistor if a_dc = 0.98 and emitter current I_E is 2 mA, then collector current will be
0.44 mA
0.88 mA
1.96 mA
3.32 mA

⇒ The electric field in a TWT due to applied signal
is directed along the helix axis
is directed radially from helix axis
is inclined to the helix axis by about 60°
is inclined to the helix axis by about 45°

⇒

Assertion (A): When an SCR is conducting, the voltage drop across is about 1 V.

Reason (R): When an SCR is conducting, the junction temperature is about 200°C.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ An exponential amplifier has diode in feedback path.
TRUE
FALSE

⇒ Neutralization is used in RF amplifiers to
stop oscillation
increase bandwidth
improve selectivity
all of the above

⇒ Capacitance hats are installed on low frequency antenna is
increase the electrical length
reduce the electrical length
protect against lightening
protect against corona effects

⇒ A single phase dual converter consists of
two fully controlled converters connected in parallel
two fully controlled converters connected in antiparallel
two fully controlled semiconverters connected in antiparallel
two fully controlled semiconverters connected in parallel

⇒ Out of the three transforms viz. Z-transform, Laplace transform and Fourier transform
all three are used in continuous time domain
all three are used in both continuous time domain and discrete time domain
Z transform is used in continuous time domain while Laplace and Fourier transforms are used in discrete time domain
Z transform is used is discrete time domain while Laplace and Fourier transforms are used in continuous time domain

⇒ Which of the following types of noise assumes greater importance at high frequencies?
Transit time noise
Shot noise
Impulse noise
Random noise

⇒ Which of the following number specification refers to FET with one gate?
2N
3N
3Y
3X

⇒ RAMs can be built with bipolar or CMOS transistor RAMs that are not possible with bipolar transistors are
SRAM
SRAM, DRAM
DRAM
PROM

⇒ In microwave system, waveguide twists
change the plane of polarization of a propagating wave
change the direction of a propagating wave
change the mode of a propagating wave
both (b) and (c)

⇒ In a shift register the data is loaded in one operation but shifted out one bit at a time, The shift register is
serial in-serial out
parallel in-serial out
serial in-parallel out
parallel in-parallel out

⇒ Directivity gain depends on
the distribution of radiated power in space
solid angle of the radiated field pattern
both (a) and (b)
none of the above

⇒ In figure the effective resistance faced by voltage source
1 Ω
2 Ω
3 Ω
3.3 Ω