Question is ⇒ In the circuit of figure β = 100 and quiescent value of base current is 20 μA. The quiescent value of colle, Options are ⇒ (A) 0.2 μA, (B) 2 μA, (C) 2 mA, (D) 20 mA, (E) , Leave your comments or Download question paper.

Question is ⇒ In the circuit of figure β = 100 and quiescent value of base current is 20 μA. The quiescent value of colle, Options are ⇒ (A) 0.2 μA, (B) 2 μA, (C) 2 mA, (D) 20 mA, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In the circuit of figure β = 100 and quiescent value of base current is 20 μA. The quiescent value of colle
A.	0.2 μA [Wrong Answer]
B.	2 μA [Wrong Answer]
C.	2 mA [Correct Answer]
D.	20 mA [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒

Assertion (A): McMurray Bredford half bridge inverter uses complementary commutation

Reason (R): Three phase inverter can have two modes of operation.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒

Assertion (A): The condition of minimum distortion in a transmission line is L = RC/G.

Reason (R): Line loading means addition of inductance to satisfy the condition L = RC/G.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ An 8156 has A₁₅ connected to its CE input. A₁₄ to A₈ are unconnected, and AD₇ to AC₀ are connected ignoring shadows, what are the RAM locations?
(4000)_H - (40FF)_H
(8000)_H - (80FF)_H
(8000)_H - (40FF)_H
Any of the above

⇒ n channel FETs are better as compared to p-channel FET because
they are more efficient
they have high switching time
they have higher input impedance
mobility of electrons is more than that of holes

⇒ What is the frequency of audio modulation?
1000 Hz
2000 Hz
3000 Hz
2000 kHz

⇒ Which one of the following theorem can be conveniently used to calculate the power consumed by the 10 Ω resistor in the network shown in the above fig
Thevenin's theorem
Maximum power transfer theorem
Millman's theorem
Superposition theorem

⇒ A digital watch contains
quartz crystal oscillator
RC oscillator
LC oscillator
either quartz or RC oscillator

⇒ In telecast
video and audio signals are frequency modulated
video signals are frequency modulated but audio signals are amplitude modulated
both audio and video signals are amplitude modulated
video signals are amplitude modulated and audio signals are frequency modulated

⇒ The following properties are associated with ferroelectric materials:

Its susceptibility is negative.

The susceptibility is expresse
1 only
1 and 3
2 only
1, 2 and 3

⇒ In high power AM transmission modulation is done at
IF stage
RF power
buffer stage
oscillator stage

⇒
Assertion (A): Ideal current sources and ideal voltage sources do not exist in reality.
Reason (R): All sources have finite internal impedances.

Both A and R are individually true and R is the correct explanation of A
Both A and R are individually true but R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ When a voltage is applied to a semiconductor crystal then the free electrons will flow.
towards positive terminal
towards negative terminal
either towards positive terminal or negative terminal
towards positive terminal for 1 μs and towards negative terminal for next 1 μs

⇒ In the circuit of figure the switch is open for a long time, At t = 0 the switch is closed. At t = 0⁺ the current supplied by batter
0.25
0.125
3.6 A
1.5 A

⇒ The output y(t) of a linear time invariant system is related to its input x(t) by the following equation y(t) = 0.5x(t - t_d + 1) + x(t - t_d) + 0.5 x(t - t_d + 7). The filter transfer function H(ω) of such a system is given by
(1 + cos ωt)e^-jωt d
(1 + 0.5 cos ωt)e^-jωt d
(1 + cos ωt)e^jωt d
(1 - 0.5 cos ωt)e^-jωt d

⇒ In N channel MOSFET with gate reverse biased, the gate current is of the order
10^-3 amp
10^-6 amp
10^-9 amp
10^-12 amp

⇒
Assertion (A): The output voltage of an inverter can be controlled by PWM technique
Reason (R): In a current source inverter the input current is constant.

Both A and R are correct and R is correct explanation of A
Both A and R correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒
Match the following:
List I (Bits operator in C) List II (Meaning)
A. ˜ 1. Bitwise XOR
B. & 2. Bitwise AND
C. | 3. Bitwise OR
D. U 4. One's complement

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-2, B-3, C-1, D-4
A-4, B-2, C-3, D-1

⇒ In a single phase full wave ac regulator feeding R-L load, the gate pulses
are always of short duration
may be of short duration
should be rectangular with width (p - a)
cannot be rectangular with width (p - a)

⇒ A Q meter uses the principle of
variation of self inductance
variation of mutual inductance
series resonance
none of the above

⇒ In an R-L circuit excited by a battery of voltage E, the current and voltage across resistor are 1- e^-t and 2(1 - e^-t) respectively. If there were an initial current of 2 A in the inductance, the voltage across resistance would have been
1 - e^-t
2 - 2e^-t
2 + 2e^-t
4 - 4e^-t

⇒ In a communication system, noise is most likely to affect the signal
at the transmitter
in the channel
in the information source
at the destination

⇒ Which of the following photodetector does not provide gain?
Phototransistor
Photoconductor
Avalanche photodiode
p-i-n photodiode
⇒ Consider the following statements about root locus
1. The intersection of root locus branches with the imaginary axis can be determined by the use of Routh criterion
2. Segments of real axis having an odd number of real axis open loop poles plus zeros to their right are not parts of root locus
3. The number of root locus branches terminating on infinity is always zero
Which of the above statements are correct?
1, 2 and 3
1 and 2 only
1 only
2 and 3 only
⇒ In C-language f- = 9 is equivalent to
f = -9
f = f - 9
f = 9 - 1
-f = 9

⇒ Double integration of unit step function leads to
an impulse
a parabola
a ramp
a doublet

⇒ The electron and hole concentration in a intrinsic semiconductor are n_i and P_i respectively when doped with a P type material, these change to n and P, respectively. Then
n + P = n_i + P_i
n + n_i = P + P_i
nP_i = n_iP
n_P = n_i P_i

⇒ In a commercially available good power supply the voltage regulation is about
0.01
0.05
0.1
0.2

⇒ Which of the following has highest resistivity?
Mica
Paraffin wax
Air
Mineral oil

⇒ For the logic circuit shown in figure, the simplified Boolean expression for the output
A + B + C
AB
B
C

⇒ If a short line is terminated in characteristic impedance it behaves as an infinite line.
TRUE
FALSE

	List I (Bits operator in C)		List II (Meaning)
A.	˜	1.	Bitwise XOR
B.	&	2.	Bitwise AND
C.	\|	3.	Bitwise OR
D.	U	4.	One's complement