Question is ⇒ A 3 phase dual converter consists of, Options are ⇒ (A) two 3 phase semiconverters connected in parallel, (B) two 3 phase semiconverters connected in antiparallel, (C) two 3 phase full converters connected in antiparallel, (D) two 3 phase full converters connected in parallel, (E) , Leave your comments or Download question paper.

Question is ⇒ A 3 phase dual converter consists of, Options are ⇒ (A) two 3 phase semiconverters connected in parallel, (B) two 3 phase semiconverters connected in antiparallel, (C) two 3 phase full converters connected in antiparallel, (D) two 3 phase full converters connected in parallel, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A 3 phase dual converter consists of
A.	two 3 phase semiconverters connected in parallel [Wrong Answer]
B.	two 3 phase semiconverters connected in antiparallel [Wrong Answer]
C.	two 3 phase full converters connected in antiparallel [Correct Answer]
D.	two 3 phase full converters connected in parallel [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ __________ switch, a T flip-flop is used as __________ switch, a T flip-flop is used as switch
toggled, delay
delay, toggle
set reset
reset, set

⇒ The logic operations of the two circuits given below
complementary
identical
entirely different
none of these

⇒ The process of deliberately adding impurity to a semi-conductor material is called
impurification
pollution
deionisation
doping

⇒ Binary 1000 will be the result of which of the following?
Binary 1000 - 100
Binary 1011 - 1111
Binary 1111 - 111
Binary 11111 - 1111

⇒ Which of the following antennas is λ /4 length?
Dipole
Marconi
Monopole
Parabolic

⇒ A coaxial RF cable has a characteristic impedance of 50 Ω and C equal to 40 pF/m. The inductance is
1 μ H/m
10 μ H/m
0.1 μ H/m
0.01 μ H/m

⇒ In a NAND SR latch S = R = 1. Then
Q = 1, Q = 0
Q = 0, Q = 1
both Q and Q will be same as before
the latch will be set

⇒ A 16 bit counter type ADC uses 1 MHz clock then its maximum conversion time is __________ .
16 μs
15 ms
6.6 ms
66 ms

⇒ SHF range is
30 - 300 MHz
300 - 3000 MHz
3000 - 30000 MHz
30000 - 300000 MHz

⇒ RC oscillator can be used upto
1 kHz
10 kHz
50 kHz
100 kHz

⇒ It is found that in a telephone system 60 subscribers initiate calls during a 30 minute interval and the total duration of all the calls is 100 minutes. The load is
2
3 erlang
3.333 erlang
0.333 erlang

⇒ Computer communication networks have
star configuration
tree configuration
loop/mesh configuration
All of the above

⇒ A clipper
adds a dc component to the input signal
removes signal voltages above or below a specified value
both (a) and (b)
either (a) or (b)

⇒ A parallel plate capacitor has area of plate A and plate separation d. Its capacitance is C. A metallic plate P of area A and negligible thickness is added as shown in Figure. The new value of capacitance
C
2C
0.5 C
0.25 C

⇒ In calculating input impedance, the load impedance is considered to be connected at the output.
TRUE
FALSE

⇒ Which of the following antennas is circularly polarized?
Yagi-Uda
Parabolic reflector
Small circular loop
Helical

⇒ Highest value of autocorrelation function 100 sin 50 pt is
50
zero
100
100/p

⇒ The emitter bias largely depends on
gain
signal input
I_E
none of the above

⇒ In a three input AND gate A = 1, B = 1, C = 0 The output Y =
ABC
ABC
ABC
ABC

⇒ The following circuit diagram resembl
logic 0
logic 1
f(A, B, C) = Σm(0, 1, 4, 6, 7)
none

⇒ The capacitance of a capacitor is not affected by
area of plates
thickness of plates
∈_r
distance between plates

⇒ The circuit in figure, the switched on at t = 0. After a long time the current through 5 Ω resistanc
0.0416666666666667
0.166666666666667
0.416666666666667
0

⇒ The integral of a unit step function is
an impulse function
a ramp function
a ramp function of slope 1
none of these

⇒ In figure V_{011 V_i
10 V_i
V_i
0}

⇒ In an n-p-n transistor biased for operation in forward active region
emitter is positive with respect to base
collector is positive with respect to base
base is positive with respect to emitter and collector is positive with respect to base
none of the above

⇒ In a TV, studio the function of vision switcher is to
edit television programs
relay television programs
control zoom lens
mix audio and video signals

⇒ A rectangular waveguide having TE₁₀ mode as dominant mode is having a cut off frequency of 18 GHz for the TE₃₀ mode. The inner broad wall dimension of the rectangular waveguide is
5/3 cm
5 cm
5/2 cm
10 cm

⇒ In a single phase power factor meter the phase difference between currents in the two pressure coils is
exactly 0°
approximate 0°
exactly 90°
approximate 90°

⇒ In a radio receiver with simple AGC
the highest AGC voltage is produced between stations
an increase in signal strength produces more AGC
the audio stage gain is normally controlled by AGC
the faster the time constant of AGC, more accurate the output

⇒ The word size accessible at a time from the memory subsystem depends on
width of data bus
width of address bus
width of control bus
both (b) and (c)