Question is ⇒ The normal operation of JFET is, Options are ⇒ (A) constant voltage region, (B) constant current region, (C) both constant voltage and constant current regions, (D) either constant voltage or constant current region, (E) , Leave your comments or Download question paper.

Question is ⇒ The normal operation of JFET is, Options are ⇒ (A) constant voltage region, (B) constant current region, (C) both constant voltage and constant current regions, (D) either constant voltage or constant current region, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The normal operation of JFET is
A.	constant voltage region [Wrong Answer]
B.	constant current region [Correct Answer]
C.	both constant voltage and constant current regions [Wrong Answer]
D.	either constant voltage or constant current region [Wrong Answer]
View Answer 4 -3 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In some on-off controllers a differential gap is provided
to make the manufacture process easier
to prevent too often frequent operation of controller
both (a) and (b)
neither (a) nor (b)

⇒ If X = 1 in the logic equation [X + Z { Y + (Z + X Y)}] { X + Z (X + Y)} = 1, then
Y = Z
Y = Z
Z = 1
Z = 0

⇒ The access time of ROM using bipolar transistors is about
1 sec
1 mili sec
1 μ sec
1 n sec

⇒ In fi
Wave A is lagging wave B by ∠θ
Wave A is leading wave B by ∠θ
Wave A is lagging wave B by ∠θ and the two waves have same rms values
Wave A is lagging wave B by ∠θ and the two waves have different rms values

⇒ The most commonly used magnetron is
cylindrical
parallel plate
inclined plate
flat plate

⇒ For generating 1 MHz frequency signal, the most suitable circuit is
phase shift oscillator
weinbridge oscillator
colpitt's oscillator
clapp oscillator

⇒ In synchronous detection of an AM signal
Carrier is completely suppressed
Both side hands are suppressed
Only one side band and part of carrier is suppressed
One side band and full carrier is suppressed

⇒ In figure the bridge is balanced when Z₄
120∠70°
187.5∠ - 10°
187.5∠ - 70°
333.3∠ - 70°

⇒ The power consumption of a present day colour TV receiver is about
8 W
80 W
200 W
400 W

⇒ Two RLC series circuit has same damping ratio. Circuit 1 has higher natural frequency as compared to circuit 2. Then
transients in circuit 2 will decay faster
transients in circuit 1 will decay faster
transients in both circuits will decay at the same rate
transients in any one may decay faster than in the other

⇒ If σ standard deviation, probable error
σ
± 1.19 σ
± 0.6745 σ
± 0.4125 σ

⇒ The relation between bandwidth B, modulating frequency f_m and frequency deviation Δf for a sinusoidally modulated FM signal is
B = Δf + f_m
B = 2(Δf + f_m)
B = f_m - Δf/
B = 2(f_m - Δf)

⇒ Consider the following stateme
1 only
1 and 2
2 and 3
2 and 4

⇒ A JFET can operate on
enhancement mode only
depletion mode only
both depletion as well as enhancement modes
neither depletion nor enhancement mode

⇒ Which of the following is the common feature between FETs and bipolars?
Have low input impedance
Have low voltage gain
Are difficult to bias
None of them

⇒ For attenuation of high frequencies we should use
shunt capacitance
series capacitance
inductance
resistance

⇒ Armstrong FM transmitter uses
LC oscillator
crystal oscillator
RC oscillator
either (a) or (c)

⇒ Six sets of electromagnetic waves are given bel
VLF, LF, MF, HF, VHF, UHF
LF, VLF, MF, HF, VHF, VHF
LF, VLF, HF, MF, VHF, UHF
VHF, VLF, HF, MF, LF, UHF

⇒ A moving coil meter has a shunt of 0.02 Ω resistance. If coil resistance is 1000 Ω and a potential difference of 500 mV is required across it to cause full scale deflection, the current through shunt is
2.5 A
25 A
0.25 A
0.025 A

⇒ The code used to reduce the error due to ambiguity in reading of a binary optical encoder is
Octal code
Excess-3 code
gray code
BCD code

⇒ A coil has a designed for high Q performance at a rated voltage and a specified frequency. If the frequency of operation is doubled, and the coil is operated at the same rated voltage, then the Q factor and the active power P consumed by the coil will be affected as follows.
P is doubled, Q is halved
P is halved, Q is doubled
P remains constant, Q is doubled
P decreases 4 times, Q is doubled

⇒ In a photo transistor the photocurrent is
emitter base junction
collector base junction
collector
either (a) or (b)

⇒ The ripple factor of power supply is a measure of
its filter efficiency
diode rating
its voltage regulation
purity of power output

⇒ Poynting vector signifies which of the following?
Power density vector producing electrostatic field
Power density vector producing electromagnetic field
Current density vector producing electrostatic field
Current density vector producing electromagnetic field

⇒ The function Z(s) has a pole at infinity if
the degree of numerator and denominator of Z(s) are equal
the numerator of Z(s) is one degree higher than denominator
the denominator of Z(s) is one degree higher than numerator
the degree of numerator and denominator are either equal or differ by one

⇒ A parallel plate capacitor has area of plate A and plate separation d. Its capacitance is C. A metallic plate P of area A and negligible thickness is added as shown in Figure. The new value of capacitance
C
2C
0.5 C
0.25 C

⇒ In the circuit shown, the power supplied by the voltage so
0 W
5 W
10 W
100 W

⇒ Inputs A and B of the given figure are applied to a NAND gate. The output is
from 0 to 6
from 0 to 2
from 0 to 1 and 2 to 3
from 1 to 2 and 3 to 4

⇒ Yettrium-iron garnet (Y₂Fe₅O₁₂) is a soft magnetic material suitable for applications involving
dc
50 Hz ac
ac of a few K Hz
ac of a few hundred MHz

⇒ In a dual converter operated in circulating current mode, the circulating current flows
when load current is zero
when load current is non-zero
even when load current is zero
none of the above