Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
Assertion (A): Copper is a monoatomic solid. Reason (R): In a metal the valence electrons belong to all atoms. | |
A. | Both A and R are true and R is correct explanation of A [Wrong Answer] |
B. | Both A and R are true but R is not correct explanation of A [Correct Answer] |
C. | A is true but R is false [Wrong Answer] |
D. | A is false but R is true [Wrong Answer] |
View Answer
Explanation:-
Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ The range of life time carriers (electrons and holes) is
1 μs to 100 μs
1 nano sec to 1 μs
1 nano sec to hundreds of μs
none of the above
⇒ In figure I_{D} = 4 mA. Then V_{S20 V4.4 V0.4 V0.44 V}
⇒ For 10 bit PCM system, the signal to quantization noise ratio is 62 dB. If the number of bits is increased by 2, then the signal to quantization noise ratio will
increased by 6 dB
increased by 12 dB
decreased by 6 dB
decreased by 12 dB
⇒ Which of the following statement is correct for two wattmeters method of power measurement in 3 phase circuit?
Power can be measured by this method only for star connected loads
When two wattmeters have equal readings power factor is 0.5.
When power factor is 1, one of the wattmeters readings is zero
When the two wattmeter read equal and opposite, p.f. is zero.
⇒ The upper end of the d.c. load line is called the __________ point and the lower end is the __________ point.
cut off, saturation
saturation, active
saturation, cut off
active saturation
⇒ What is the major cause of creeping in an energy-meter?
Over compensation for friction
Mechanical vibrations
Excessive voltage across the potential coil
Stray magnetic fields
⇒ In figure, S is closed at t = 0. At t = t_{1}, I = 1 A and di/dt = 1 A/s. Then the value of
1 H
2 H
3 H
4 H
⇒ For TM waves in a parallel plate waveguide, the minimum attenuation arising from imperfect conductors would occur at a freq. of (f_{c} is the cut off frequency)
3 f_{c}
3 f_{c}
2 f_{c}
2 f_{c}
⇒ An index register in digital computer is a register to be used for
performing arithmetic and logic operations
temporary storage of result
counting number of times a program is executed
address modification purpose
⇒ The input impedance of op-amp circuit of figur
120 k ohm
110 k ohm
infinity
10 k ohm
⇒ In a full bridge circuit supplying an RLC under damped circuit
the waveshapes of output voltage and load current are square
the waveshapes of output voltage and load current are sinusoidal
the waveshapes of output voltage is square but the waveshape of load current is nearly sinusoidal
none of the above
⇒ In figure, the position of voltmeter and ammeter are exchanged. It may result in damage
both the instruments
ammeter
voltmeter
neither of two
⇒ The characteristic equation of a closed loop system is (s + 2) (s + 3) + K = 0. The centroid of the asymptotes in root locus is:
2.5
-2.5
0.5
-0.5
⇒ Figure represen
Tunnel diode
Zener diode
Photo diode
Photo sensitive diode
⇒ LET JCOKE = 11 and LPEPSI = 19. Consider the statement13
16
9
14
⇒ In a 4 bit parallel in parallel out shift register A = 1, B = 1, C = 0, D = 1. The data output after 3 clock pulses is
1101
1001
101
1
⇒ The turn on time of an SCR is 5 micro second. Its trigger pulse should have
short rise time with pulse width = 2.5 μs
long rise time with pulse width = 3 μs
short rise time with pulse width = 4 μs
long rise time with pulse width = 4 μs
⇒ For a photo conductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in the intensities of optical illumination results in
change in open circuit voltage
change in short circuit current
a reduction resistance
an increase of resistance
⇒ A matched generator (Z_{g} = Z_{0}) with 1 Ω available. If all ports are matched, the power delivered at ports 1, 2, 3 respectively are
0.5 W, 0.5 W, 0 W
0 W, 0 W, 1 W
0.33 W each
0 W, 0.25 W, 0.25 W
⇒ Ferrites are
ferromagnetic materials
ferrimagnetic materials
ferroelectric materials
ferri-ferromagnetic materials
⇒ The following program starts at location 0
20 H
02 H
00 H
FFH
⇒ Choose correct option for a stable system :
I is true, II is true
I is true, II is false
I is false, II is true
I is false, II is false
⇒ When a ferromagnetic substance is magnetised, small changes in dimensions occur. Such a phenomenon is known as
magnetic hystresis
magnetic expansion
magneto striction
magneto calorisation
⇒ A pulse function can be represented as difference of two equal step functions.
TRUE
FALSE
⇒ An FM signal with a deviation is passes through the mixer, and has its frequency reduced five fold. The deviation in the output of the mixer is
Δ
5Δ
Δ/5
indeterminant
⇒ Tellegen's theorem is applicable to
circuits with passive elements only
circuits with linear elements only
circuits with time invariant elements only
circuits with active or passive, linear or nonlinear and time invariant or time varying elements
⇒ In a phase discriminator f_{c}, is the IF to which primary circuit is tuned. Consider the following statements: The primary and secondary voltages are
1 only
1 and 2
1, 2 and 3
2 and 3
⇒ Under ordinary circumstances, impulse noise can be reduced in
FM only
AM only
both AM and FM
none of the above
⇒ The two conductors of a single phase transmission line suspended in air carry currents in opposite directions. The force per unit length on each conductor varies
directly as the current in either conductor
directly as the distance between the two conductors
directly as the square of the current in either conductor
inversely as the square of the distance between the two conductors
⇒ Consider the following statements a half adder.
1, 3, 4
1, 2, 4
4 only
2 and 3
⇒ The range of life time carriers (electrons and holes) is
1 μs to 100 μs
1 nano sec to 1 μs
1 nano sec to hundreds of μs
none of the above
⇒ In figure I_{D} = 4 mA. Then V_{S20 V4.4 V0.4 V0.44 V}
⇒ For 10 bit PCM system, the signal to quantization noise ratio is 62 dB. If the number of bits is increased by 2, then the signal to quantization noise ratio will
increased by 6 dB
increased by 12 dB
decreased by 6 dB
decreased by 12 dB
⇒ Which of the following statement is correct for two wattmeters method of power measurement in 3 phase circuit?
Power can be measured by this method only for star connected loads
When two wattmeters have equal readings power factor is 0.5.
When power factor is 1, one of the wattmeters readings is zero
When the two wattmeter read equal and opposite, p.f. is zero.
⇒ The upper end of the d.c. load line is called the __________ point and the lower end is the __________ point.
cut off, saturation
saturation, active
saturation, cut off
active saturation
⇒ What is the major cause of creeping in an energy-meter?
Over compensation for friction
Mechanical vibrations
Excessive voltage across the potential coil
Stray magnetic fields
⇒ In figure, S is closed at t = 0. At t = t_{1}, I = 1 A and di/dt = 1 A/s. Then the value of
1 H
2 H
3 H
4 H
⇒ For TM waves in a parallel plate waveguide, the minimum attenuation arising from imperfect conductors would occur at a freq. of (f_{c} is the cut off frequency)
3 f_{c}
3 f_{c}
2 f_{c}
2 f_{c}
⇒ An index register in digital computer is a register to be used for
performing arithmetic and logic operations
temporary storage of result
counting number of times a program is executed
address modification purpose
⇒ The input impedance of op-amp circuit of figur
120 k ohm
110 k ohm
infinity
10 k ohm
⇒ In a full bridge circuit supplying an RLC under damped circuit
the waveshapes of output voltage and load current are square
the waveshapes of output voltage and load current are sinusoidal
the waveshapes of output voltage is square but the waveshape of load current is nearly sinusoidal
none of the above
⇒ In figure, the position of voltmeter and ammeter are exchanged. It may result in damage
both the instruments
ammeter
voltmeter
neither of two
⇒ The characteristic equation of a closed loop system is (s + 2) (s + 3) + K = 0. The centroid of the asymptotes in root locus is:
2.5
-2.5
0.5
-0.5
⇒ Figure represen
Tunnel diode
Zener diode
Photo diode
Photo sensitive diode
⇒ LET JCOKE = 11 and LPEPSI = 19. Consider the statement
16
9
14
⇒ In a 4 bit parallel in parallel out shift register A = 1, B = 1, C = 0, D = 1. The data output after 3 clock pulses is
1101
1001
101
1
⇒ The turn on time of an SCR is 5 micro second. Its trigger pulse should have
short rise time with pulse width = 2.5 μs
long rise time with pulse width = 3 μs
short rise time with pulse width = 4 μs
long rise time with pulse width = 4 μs
⇒ For a photo conductor with equal electron and hole mobilities and perfect ohmic contacts at the ends, an increase in the intensities of optical illumination results in
change in open circuit voltage
change in short circuit current
a reduction resistance
an increase of resistance
⇒ A matched generator (Z_{g} = Z_{0}) with 1 Ω available. If all ports are matched, the power delivered at ports 1, 2, 3 respectively are
0.5 W, 0.5 W, 0 W
0 W, 0 W, 1 W
0.33 W each
0 W, 0.25 W, 0.25 W
⇒ Ferrites are
ferromagnetic materials
ferrimagnetic materials
ferroelectric materials
ferri-ferromagnetic materials
⇒ The following program starts at location 0
20 H
02 H
00 H
FFH
⇒ Choose correct option for a stable system :
- Roots of the characteristic equation of the system are real and negative
- Area within the impulse response is finite
I is true, II is true
I is true, II is false
I is false, II is true
I is false, II is false
⇒ When a ferromagnetic substance is magnetised, small changes in dimensions occur. Such a phenomenon is known as
magnetic hystresis
magnetic expansion
magneto striction
magneto calorisation
⇒ A pulse function can be represented as difference of two equal step functions.
TRUE
FALSE
⇒ An FM signal with a deviation is passes through the mixer, and has its frequency reduced five fold. The deviation in the output of the mixer is
Δ
5Δ
Δ/5
indeterminant
⇒ Tellegen's theorem is applicable to
circuits with passive elements only
circuits with linear elements only
circuits with time invariant elements only
circuits with active or passive, linear or nonlinear and time invariant or time varying elements
⇒ In a phase discriminator f_{c}, is the IF to which primary circuit is tuned. Consider the following statements: The primary and secondary voltages are
- exactly 90° out of phase when input frequency is f_{c}
- more than 90° out of phase when input frequency is higher than f_{c}
- less than 90° out of phase when input frequency is lower than f_{c}
1 only
1 and 2
1, 2 and 3
2 and 3
⇒ Under ordinary circumstances, impulse noise can be reduced in
FM only
AM only
both AM and FM
none of the above
⇒ The two conductors of a single phase transmission line suspended in air carry currents in opposite directions. The force per unit length on each conductor varies
directly as the current in either conductor
directly as the distance between the two conductors
directly as the square of the current in either conductor
inversely as the square of the distance between the two conductors
⇒ Consider the following statements a half adder.
- As a half subtractor also
- has two outputs C_{H} = x x y and S_{n} = x ⊕ y for two inputs x and y
- has two outputs CH = x + y and SH = x ⊕ y for two inputs x and y
- is a combinational circuit
1, 3, 4
1, 2, 4
4 only
2 and 3