Question is ⇒ In a CE amplifier circuit, the output voltage, Options are ⇒ (A) is very small, (B) is always constant, (C) depends on β, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ In a CE amplifier circuit, the output voltage, Options are ⇒ (A) is very small, (B) is always constant, (C) depends on β, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a CE amplifier circuit, the output voltage
A.	is very small [Wrong Answer]
B.	is always constant [Wrong Answer]
C.	depends on β [Correct Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The phase difference (jω - p₁) means
phasor drawn from p₁ to jω
phasor drawn from origin to p₁
phasor directed from origin to jω point
phasor directed from jω to p₁

⇒ If a microcomputer has a 64 K memory; what is the hexadecimal notations for the last memory location?
1111
1A1A
EEEF
FFFF

⇒ The rate of change of excess carrier density is proportional to carrier density.
TRUE
FALSE

⇒ An RC impadence function has a pole at s = 0. The first element in the Foster form of synthesis
is R
may be R and C
is C
is R and C in parallel

⇒ In a digital voltmeter the oscillator frequency is 400 kHz and the ramp voltage falls from 8 V to 0 V in 20 ms. What is the number of pulses counted by the counter?
800
2000
4000
8000

⇒ In a purely inductive circuit, the current __________ the voltage by __________ .
lags, 0°
leads, 90°
lags, 90°
lags, 45°

⇒ Beamwidth (between first nulls) will be for an antenna at 3 MHz with directivity of 100
140°
70°
210°
60°

⇒ In a conductor the current flow is due to
holes
electrons
ions
electrons and ions

⇒ Figure shows a NAND latch used as a switch debouncer. With the switch in STOP position. Q will be equal to
0
1
CLK
none of these

⇒ Typical switching time for ECL is
5 nano seconds
5 micro seconds
5 milli seconds
5 seconds

⇒ Two coils X and Y have self inductances of 5 mH and 10 mH and mutual inductance of 3 mH. If the current in coils X change at a steady rate of 100 A/s, the emf induced in coil Y is
0.3 V
0.5 V
1 V
1.5 V

⇒ The reactance of coupling capacitor for AC signals in an amplifier, should be
as low as possible
as high as possible
neither low nor high
either low or high

⇒ The current through a resistance R is shown in figure. The computed value of power
400 ± 0.42 W
400 ± 4.6 W
400 ± 8.85 W
400 ± 10.65 W

⇒ An FM transmitter delivers 80W to a load of 30 W when no modulation is present. The carrier is now frequency modulated by a single sinusoidal signal and the peak frequency deviation is so adjusted to make the amplitude of the second sideband is zero in the given out
5.12 W
21.78 W
2.56 W
16.81 W

⇒ The advantage of transistor over vacuum tube is
no heat is required
small size and light in weight
very low power consumption
all of the above

⇒

Assertion (A): The s domain impedance of a series R-L circuit is R + sL irrespective of initial conditions.

Reason (R): Complex frequency s = σ + jω.

Both A and R are true and R is correct explanation of A
Both A and R are true and R is not the correct explanation of A
A is true but R is false
A is false but R is true

⇒ For measuring current at a high frequency we should use
moving iron instrument
electrostatic instrument
thermocouple instrument
moving coil instrument

⇒ In the circuit of figure the d
will conduct as the whole cycle
will conduct in the positive half cycle
will not conduct
will conduct from 30° to 150° in the positive half cycle

⇒ Fourier transform is defined for
periodic
non-periodic
finite duration
all

⇒ A fully controlled bridge converter is feeding an RLE load. For some circuit conditions firing angle is 47°. If connections of battery are reversed, the firing angle is likely to be
47°
less than 47°
more than 47°
either more or less than 47°

⇒ The horizontal intercept of dc load line is the same as ideal
cut off point
saturation point
operating point
quasi saturation point

⇒ Nyquist plot provides information about absolute stability as well as relative stability.
TRUE
FALSE

⇒ CMOS is extensively used in
pocket calculators
digital wrist watches
satellites
all of the above

⇒ What is the major cause of creeping in an energy-meter?
Over compensation for friction
Mechanical vibrations
Excessive voltage across the potential coil
Stray magnetic fields

⇒ In Jone chopper, the commutating element
is a capacitor
is a capacitor and an inductor
is a capacitor and an auto transformer
none of the above

⇒

Assertion (A): Feedback control systems offer more accurate control than open loop systems.

Reason (R): The feedback path establishes a link for comparison of input and output and subsequent error correction.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The code used to reduce the error due to ambiguity in reading of a binary optical encoder is
Octal code
Excess-3 code
gray code
BCD code

⇒ The JFET in the circuit shown in figure has an I_DSS = 10 mA and V_p = -5V. The value of the resistance R_s for a drain current I_DS = 6.4 m
156 Ω
470 Ω
560 Ω
1 kΩ

⇒ In an R-L circuit excited by a battery of voltage E, the current and voltage across resistor are 1- e^-t and 2(1 - e^-t) respectively. If there were an initial current of 2 A in the inductance, the voltage across resistance would have been
1 - e^-t
2 - 2e^-t
2 + 2e^-t
4 - 4e^-t

⇒ In a broadcast superheterodynes receiver having no RF amplifier, the loaded Q of the antenna coupling circuit is 100. If the intermediate frequency is 455 kHz. The image frequency at 1000 kHz will be
1010 kHz
1455 kHz
1910 kHz
545 kHz