Question is ⇒ When the video signal is applied to the picture tube in a TV receiver, the strength of video signal is about, Options are ⇒ (A) 1000 V, (B) 200 V, (C) 50 V, (D) 1 V, (E) , Leave your comments or Download question paper.

Question is ⇒ When the video signal is applied to the picture tube in a TV receiver, the strength of video signal is about, Options are ⇒ (A) 1000 V, (B) 200 V, (C) 50 V, (D) 1 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	When the video signal is applied to the picture tube in a TV receiver, the strength of video signal is about
A.	1000 V [Wrong Answer]
B.	200 V [Wrong Answer]
C.	50 V [Correct Answer]
D.	1 V [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ State variable formulation is very suitable for computer solution.
TRUE
FALSE

⇒ In a synchro transmitter, which coil acts as primary?
Rotor
Stator
Partly rotor and partly stator
Tertiary

⇒ A meter with a resistance of 100 Ω and a full scale deflection of current of 1 mA is to be converted into voltmeter of 0 - 5 V range. The multiplier resistance should be
490 Ω
5000 Ω
4900 Ω
5100 Ω

⇒ The volt ratio box is basically a
potential divider
current transformer
a high resistance voltmeter
either (a) or (c)

⇒ Two voltages are 50 ∠0 V and 75 ∠ - 60° V. The sum of these voltages is
109 ∠ - 60° V
109 ∠ - 25° V
109 ∠ - 36.6° V
100 ∠ - 50.1° V

⇒ India's first three-axis stabilised geostationary communication satellite is
Rohini
Aryabhatta
Apple
Bhaskara

⇒

Assertion (A): An electronic tuner uses varactor diode

Reason (R): The capacitance of a varactor diode depends on the magnitude of reverse bias.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ In control systems the magnitude of error voltage
is very small
is very large
neither small nor large
may be any value from 0 to 50 V

⇒ A loudspeaker transformer has a turns ratio of 20 : 1. The speaker impedance is 20Ω. Primary impedance of transformer is
10 K
8 K
20 K
0.5 K

⇒

Assertion (A): Mnemonics are used in assembly level program.

Reason (R): Computer cannot understand mnemonics.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ In intrinsic semiconductor magnitude of free electron and hole concentrations are equal.
TRUE
FALSE

⇒ Which of these is the most recent display device?
LED
LCD
VF
(a) and (c)

⇒ A thermistor is used for
over voltage protection
temperature alarm circuit
automatic light control
none of the above

⇒ The life time of a geosynchronous communication
5
10
20
50

⇒ Which of the following is not a legal subscript?
J + 2
JA - 4
-3
3^* IA - 2

⇒ A transistor has

collector
emitter
base

In a N-P-N transistor the electron flow into the transistor at
I only
II only
II and III only
I and II only

⇒ Which of the following is error correcting code?
EBCDIC
Gray
Hamming
ASCII

⇒ Measurement of Hall coefficient enables the determination of
transportation factor decreases and a increases
transportation factor increases and a increases
transportation factor increases and a decreases
transportation factor decreases and a decreases

⇒ In a bipolar transistor which current is smallest
collector current
base current
emitter current
any of the three currents

⇒ The system shown in figure remains stable wh
k £ - 1
-1 < k < 1
l < k < 3
k > 3

⇒ Quartz crystal has
very small Q
small Q
very high Q
Q less than 1

⇒ The antenna current of an AM transmitter is 8 A. When only the carrier is sent, but it increases to 8.93 A. When the carrier is sinusoidally modulated. The percentage modulation is nearly
0.9
0.8
0.75
0.7

⇒

Assertion (A): A Darlington amplifier has very low output impedance

Reason (R): The circuit has a low resistance R_E between emitter and ground

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ In Java which operator can be used even if there is a single operand
+
-
*
%

⇒ Many circles are drawn in a Smith chart used for transmission line calculations. The circle shown in the figure represe
unit circles
constant resistance circles
constant reactance circles
constant reflection coefficient circles

⇒ The number of doped regions in a SCR is
2
3
4
5

⇒ In common base amplifier the current gain is less than one, but the voltage gain may be anywhere from
0.5 to 1
1 to 5
5 to 10
50 to 2000

⇒ To avoid objectionable noise in a microwave TV link, the SNR should be about
50 or more
10 or more
25 or more
200 or more

⇒ For a single phase half wave converter feeding a resistive load, the firing angle a. The waveshape in below figure is
output voltage
input voltage
voltage drop across thyristor
none of the above

⇒ A signal g(t) = A then g(t) is a
energy signal
power signal
neither energy nor power signal
insufficient data