Question is ⇒ The circuit of figur, Options are ⇒ (A) clipper, sine wave clipped at - 2 V, (B) clamper, (C) clamper, sine wave clamped at zero V, (D) clipper, sine wave clipped at + 2 V, (E) , Leave your comments or Download question paper.

Question is ⇒ The circuit of figur, Options are ⇒ (A) clipper, sine wave clipped at - 2 V, (B) clamper, (C) clamper, sine wave clamped at zero V, (D) clipper, sine wave clipped at + 2 V, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	The circuit of figur
A.	clipper, sine wave clipped at - 2 V [Wrong Answer]
B.	clamper [Correct Answer]
C.	clamper, sine wave clamped at zero V [Wrong Answer]
D.	clipper, sine wave clipped at + 2 V [Wrong Answer]
View Answer 3 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ Symbol shown in figure represen
P-channel DMOSFET
N-channel DMOSFET
UJT with P-type base
UJT with N-type base

⇒ A wire strain gauge has a gauge factor of 2, resistance of 125 Ω and length 1 m. If length of wire changes by .005 m, change in resistance will be
0.25 Ω
0.5 Ω
1.25 Ω
2.5 Ω

⇒ The function Z(s) has a pole at infinity if
the degree of numerator and denominator of Z(s) are equal
the numerator of Z(s) is one degree higher than denominator
the denominator of Z(s) is one degree higher than numerator
the degree of numerator and denominator are either equal or differ by one

⇒ For determining the network functions of a two-port network, it is required to consider that
all initial conditions remain same
all initial conditions are zero
part of initial conditions are equal to zero
initial conditions vary depending on nature of network

⇒ Resistivity of electrical conductors is most affected by
Pressure
temperature
composition
ageing

⇒ The term 'Poisson's ratio' is connected with
strain gauge
LVDT
Bourden tube
capacitance transducer

⇒ A discrete LTI system is non-casual if its impulse response is
aⁿ ∪(n - 2)
a^n-2 ∪(n)
aⁿ⁺² ∪(n)
aⁿ ∪(n + 2)

⇒

Assertion (A): In a BJT base current is very small.

Reason (R): In a BJT recombination in base region is high.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ Which of the following antennas is λ /4 length?
Dipole
Marconi
Monopole
Parabolic

⇒ For transmission-line matching over range of frequencies, it is best to use a
single stub of adjustable position
double stub
broadband directional coupler
balun

⇒

Assertion (A): Transient analysis uses Laplace transformation.

Reason (R): Laplace transform method is suitable for solution of integro differential equations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ The phase angle of a lag circuit is
between 0 and -90°
between 0 and +90°
90°
more than 90°

⇒ In a BJT amplifier circuit the size of coupling capacitor depends on
lowest frequency
highest frequency
average of lowest and highest frequencies
none of the above

⇒ In n-well CMOS fabrication substrate is:
heavily doped n-type
heavily doped p-type
lightly doped n-type
lightly doped p-type

⇒ The resistance of the circuit shown is figur
5 Ω
More than 6 Ω
More than 4 Ω
Between 6 and 7 Ω

⇒ The number of variables in a function is odd and the number of minterms with even number of 0's are same as the number of minterms with odd number at 1 's, the expression formed can be represented in __________ as well as __________ form.
exclusive - OR, NOR
equivalence, exclusive - OR
AND, coincidence
OR, exclusive - OR

⇒ Peak inverse voltage will be highest for
half wave rectifier
full wave rectifier
bridge rectifier
three phase full wave rectifier

⇒ Performance of a PIN diode switch is represented by
insertion loss when switch is off
insertion loss when switch is on
insertion loss when switch is on and isolation loss when switch is off
insertion loss when switch is off and isolation loss when switch is on

⇒ A single phase half wave controlled rectifier circuit has an R-L load. A freewheeling diode is also in the circuit. When freewheeling diode is conducting the SCR
is forward biased
is reverse biased
may be forward biased or reverse biased
forward biased initially but reverse biased afterwards

⇒ For most metals, Fermi level E_F is less than
0.1 eV
2 eV
5 eV
10 eV

⇒ A person with a receiver is 5 km away from the transmitter. What is the distance that this person must move further to detect at 3 dB decrease in signal strength?
942 m
2070 m
4978 m
5320 m

⇒ Quantization error occurs in
D/A converter
A/D converter
both D/A and A/D converter
neither D/A nor A/D converter

⇒ A gate in which shift register is connected as shown in the figure below. How many clock pulse (after reset to '0') the contents of the shift register are '000' ag
3
6
16
8

⇒ The effective channel length of a MOSFET in saturation decreases with increase in
gate voltage
drain voltage
source voltage
body voltage

⇒ The complete video signal consists of
video signal and synchronising pulses
video signal, synchronising pulses and blanking pulses
video signal corresponding to picture information only
video signal and blanking pulses

⇒ Maximum power from a source having internal resistance R_i is delivered to a resistive load R_L, if
R_i > R_L
R_i < R_L
R_i = R_L²
R_i = R_L

⇒ One commercial unit of energy is equal to
1 watt-sec
1 kilowatt-sec
1 kilowatt-hour
One watt-hour

⇒ The threshold voltage of an n-channel enhancement mode MOSFET is 0.5 when the device is biased at a gate voltage of 3V. Pinch off would occur at a drain voltage of
1.5 V
2.5 V
3.5 V
4.5 V

⇒ The combination of registers in 8085 is B-C, D-E, H-L only.
TRUE
FALSE

⇒ SWR for a transmission line is infinity when the load is

Short circuit
Complex impedance
Open circuit
Pure reactance

Of the above statements:
1, 3, 4 are correct
1 and 3 are correct
2, 3, 4 are correct
1, 2, 4 are correct