Question is ⇒ A counter has a modulus of 10. The number of flip flops is, Options are ⇒ (A) 10, (B) 5, (C) 4, (D) 3, (E) , Leave your comments or Download question paper.

Question is ⇒ A counter has a modulus of 10. The number of flip flops is, Options are ⇒ (A) 10, (B) 5, (C) 4, (D) 3, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A counter has a modulus of 10. The number of flip flops is
A.	10 [Wrong Answer]
B.	5 [Wrong Answer]
C.	4 [Correct Answer]
D.	3 [Wrong Answer]
View Answer 5 -1 Explanation:- Answer : C Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The electric energy required to raise the temperature of a given amount of water is 1000 kWh. If heat losses are 25%, the total heating energy required is __________ kWh.
1500
1250
1333
1000

⇒ The use of thermocouple meters for ac measurement leads to a scale which is
linear
square law
logarithmic
exponential

⇒ If a dipole is meant for a frequency of 1 MHz, the length of each rod is about
5 m
20 m
100 m
50 m

⇒ A carry look ahead adder is frequently used for addition because
it costs less
it is faster
it is more accurate
is uses fewer gates

⇒ If a function has only cosine terms, it must satisfy the equation
f(t) = -f(t)
f(-t) = f(t)
f(-t) = -f(t)
none of the above

⇒ Reluctivity is analogous to
permeability
conductivity
resistivity
retentivity

⇒ A moving iron instrument can be used for dc as well as ac.
TRUE
FALSE

⇒ Which of the following produces very wide drifts in clock frequency?
Crystal
RC circuit
LC resonant circuit
Crystal and RC circuit

⇒ The output y(t) of a linear time invariant system is related to its input x(t) by the following equation y(t) = 0.5x(t - t_d + 1) + x(t - t_d) + 0.5 x(t - t_d + 7). The filter transfer function H(ω) of such a system is given by
(1 + cos ωt)e^-jωt d
(1 + 0.5 cos ωt)e^-jωt d
(1 + cos ωt)e^jωt d
(1 - 0.5 cos ωt)e^-jωt d

⇒ Which of the following bus is used to transfer data from main memory to peripheral device?
DMA bus
Output bus
Input bus
Data bus

⇒ Which of the following is not a travelling wave?
e = E_m sin (βx - ωt)
e = E_m cos (βx - ωt)
e = E_m sin (ωt - βx)
e = E_m sin (βx)

⇒ If a line having Z₀ = 300 ∠ 0 W is short circuited at far end, VSWR is
0
1
∞
2

⇒ Consider the following statements about DRAM

Page mode read operation is faster than RAS read
RAS input remains active during column address strobe
The row and column addresses are strobed into the internal buffers using RAS and CAS inputs respectively

Which of the above statements are correct?
1 and 3 only
All
1 and 2 only
2 and 3 only

⇒ In a full bridge single phase inverter feeding RLC load
one thyristor and one diode conduct simultaneously
two thyristors conduct simultaneously
two thyristors or two diodes conduct simultaneously
four thyristors conduct simultaneously

⇒ Equal amplitude ac signals are given as inputs to both inverting and given as inputs to both inverting and non-inverting terminals of an op-amp. The output will be zero when the phase difference between inputs is
0°
90°
180°
270°

⇒ If there are no permanent dipoles in a dielectric material, the dielectric constant is independent of temperature.
TRUE
FALSE

⇒ Low-orbit satellites are not used for communications because they
produce sonic booms
do not provide 24 hour/ day contact to the users on Earth
heat up and melt
none

⇒ Start and stop bit do not contain any information but are used in serial communication for
error correction
error detection
synchronization
slowing down the communication

⇒ In which of the following semiconductor are holes majority carriers
intrinsic
extrinsic
p type
n type

⇒ An S/N ratio of 3 expressed in db is
4.8 dB
2.4 dB
0.48 dB
0.24 dB

⇒ As a compared to a CB amplifier, a CE amplifier has
lower current amplification
higher current amplification
lower input resistance
higher input resistance

⇒

Assertion (A): Transient analysis uses Laplace transformation.

Reason (R): Laplace transform method is suitable for solution of integro differential equations.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ A sinusoidal current having peak value of 7.07 A is superimposed on dc of 5A. If a hot-wire ammeter is used to measure the combined current in the circuit, it will indicate __________ ampere.
7.07
10
12.07
2.07

⇒ Value of Z_L for maximum power transfe
R
R + jωL
R - jωL
None of these

⇒ FM has
two sidebands only
four sidebands only
eight sidebands only
infinite sidebands

⇒ Carbon steel has a residual flux density of 1 Wb/m².
TRUE
FALSE

⇒ The D.C. alpha(a) of a transistor is approximately
unity
10 to 50
100 to 500
1000 to 5000

⇒ The maximum effective aperture of a microwave antenna which has a directivity of 900, will be
71.619 λ²
716.19 λ²
7161.9 λ²
71619 λ²

⇒ For an amplifier the input output signals are shown in figure. The class of amplifie
A
AB
B
C

⇒ For the circuit, let us assume that R = 1 Ω, L = 10^-3 H, and V(t) = 10 cos (1000t + 30°)V and the differential equation for I(t) is give
7.07 cos (1000t + 15°) A
70.7 cos (1000t - 30°) A
7.07 cos (1000t - 15°) A
7.07 cos (1000t + 15°) A