Question is ⇒ A ring counter with 5 flip flops will have, Options are ⇒ (A) 5 states, (B) 10 states, (C) 32 states, (D) infinite states, (E) , Leave your comments or Download question paper.

Question is ⇒ A ring counter with 5 flip flops will have, Options are ⇒ (A) 5 states, (B) 10 states, (C) 32 states, (D) infinite states, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	A ring counter with 5 flip flops will have
A.	5 states [Correct Answer]
B.	10 states [Wrong Answer]
C.	32 states [Wrong Answer]
D.	infinite states [Wrong Answer]
View Answer 2 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a colour TV receiver, the function of comb filter is
to pass only the clusters of monochrome signal energy while blocking chrome signals
to pass only chrome signals and block monochrome signals
to block both monochrome and chrome signals
none of the above

⇒ The 8085 microprocessor is interrupted while executing MOV instruction at location 0210 H. What is the location at which contents of register E are stored.
054 CH
054 DH
054 EH
054 FH

⇒ A low ratio of the A.C. load impedance of a diode detector results in
diagonal clipping
poor AGC operation
poor AF response
negative peak clipping

⇒ A voltage wave containing 10% third harmonic is applied to a scries R-L circuit. The percentage third harmonic content in the current wave will be
more than 10%
10% or less than 10%
less than 10%
10% or more or less

⇒ In a bipolar transistor, emitter efficiency is about
0.99
0.9
0.8
0.7

⇒ In a series R-L-C circuit at the resonant frequency the
current is maximum
current is minimum
impedance is maximum
voltage is maximum

⇒ RC network shown in the given figure can provide a maximum theoretical phase shif
90°
180°
270°
360°

⇒ Two identical silicon diodes D₁ and D₂ are connected back to back shown in figure. The reverse saturation current I_s of each diode is 10^-8 amps and the breakdown voltage V_Br is 50 v. Evaluate the voltages V_D1 and V_D2 dropped across the diodes D₁ and D₂ assuming KT/q to be 25
4.983 V, 0.017 V
- 4.98 V, - 0.017 V
0.17 V, 4.983 V
- 0.017 V, - 4.98 V

⇒ To obtain very high I/P and O/P impedances in a feedback amplifier, the topology used is
voltage series
current series
voltage shunt
current shunt

⇒ Which of the following semiconductor has the highest melting point?
Germanium
Silicon
Gallium arsenide
Lead sulphide

⇒ In the given figure, the input frequency is such that R = X_C.
v₀ lags v_i by 45°
v₀ lags v_i by 90°
v₀ leads v_i by 45°
v₀ leads v_i by 90°

⇒ Square root of 4 is
(16)₁₆
(2)₂
(8)₁₆
(5)₁₆

⇒ The voltage transfer functions of two port circuits connected in cascade can be easily found from
product of individual ABCD matrices
product of voltage transfer functions of two networks
sum of z matrices
sum of h matrices

⇒ The first column of a Routh arra
2
3
4
5

⇒ Induction wattmeter is an absolute instrument.
TRUE
FALSE

⇒

Assertion (A): The 'do while' statement is used less frequently than the 'while' statement.

Reason (R): For most applications it is more natural to test for continuation of loop at the beginning than at the end of loop.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ When a TTL is driving an CMOS gates it is necessary to ensure that
V_OL(for TTL) ≤ V_IL (for CMOS) and V_0H (for TTL) ≥ VIH (for CMOS)
V_0L (for TTL) ≥ V_IL (for CMOS)
V_0H (for TTL) ≤ V_IH (for CMOS)
V_0L (for TTL) ≥ V_IL (for CMOS) and V_0H (for TTL) ≤ VIH (for CMOS)

⇒ In portable instruments, damping is provided by
spring
gravity
eddy current
either (a) or (c)

⇒ The conversion or collector circuit efficiency is a measure
how successfully the active device converts D.C. power to A.C. signal power
how much distortion in output is reduced with respect to input
how successfully the active device converts A.C. power to D.C. signal power
none of the above

⇒ Which of the following statement is correct?
Decimal 9 is represented as 1011 in Excess-3 code
Decimal 9 is represented as 1001 is BCD code
Decimal 10 is represented as 1100 is Gray code
Decimal 10 is represented as 1001 in binary code

⇒ Which of the following is correct in FORTRAN 77?
PARAMETER PMOS = 9.8, NMOS = X
PARAMETER (PMOS = 9.8, NMOS = X)
PARAMETER PMOS = 9.8, NMOS = X
PARAMETER PMOS, NMOS = 9.8, X

⇒ Henry is equivalent to
Volts/Ampere
Weber/Volt
Weber/Ampere
Weber/Ampere²

⇒

Match the following:

	List I (Set operation)		List II (Set operator)
A.	Set equality	1.	-
B.	Set inclusion	2.	=
C.	Set intersection	3.	< =
D.	Set difference	4.	∗

A-2, B-3, C-4, D-1
A-3, B-2, C-4, D-1
A-1, B-2, C-3, D-4
A-4, B-2, C-3, D-1

⇒ The use of free wheeling diode in controlled rectifier improves the waveshape of load current.
TRUE
FALSE

⇒ Regarding TASI which one of the following statements is wrong?
It snatches the channel in his speech and may allocate it to another speaker needing it.
The same speaker is reassigned a channel almost instantly when he speaks again even when the circuit is heavily loaded.
It increases the overall utilization of the transmission channel
Intercontinental callers sometimes confuse the effects of TASI with the effects of satellite delay.

⇒ The Sun blots out the transmission of a geosynchronous satellite twice a year when satellite passes directly in front of it. This outage lasts for about
10 minutes on 5 consecutive days
5 minutes on 10 consecutive days
30 minutes for 5 consecutive days
one hour for 5 consecutive days

⇒ In colour TV system the colour sub carrier frequency is 4.43 MHz.
TRUE
FALSE

⇒ A 2 bit binary multiplier can be implemented using
2 I/P only
2 I/P XOR_s and 4 I/P and gates only
two 2 I/P_s NOR and one XNOR gate
XOR gates and shift Register

⇒

Assertion (A): When the phase margin of a control system is improved using a lead network, noise transmission increases.

Reason (R): Phase lead compensation increases bandwidth.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
R is correct but A is wrong

⇒ The output impedance of a logic pulser is
low
high
may be Low or High
can't say