Question is ⇒ Assertion (A): Cut-in voltage for Germanium diode is greater than that for silicon diode.Reason (R): Germanium diode has a higher reverse saturation current than silicon diode., Options are ⇒ (A) Both A and R are individually true and R is the correct explanation of A, (B) Both A and R are individually true but R is not the correct explanation of A, (C) A is true but R is false, (D) A is false but R is true, (E) , Leave your comments or Download question paper.

Question is ⇒ Assertion (A): Cut-in voltage for Germanium diode is greater than that for silicon diode.Reason (R): Germanium diode has a higher reverse saturation current than silicon diode., Options are ⇒ (A) Both A and R are individually true and R is the correct explanation of A, (B) Both A and R are individually true but R is not the correct explanation of A, (C) A is true but R is false, (D) A is false but R is true, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Assertion (A): Cut-in voltage for Germanium diode is greater than that for silicon diode. Reason (R): Germanium diode has a higher reverse saturation current than silicon diode.
A.	Both A and R are individually true and R is the correct explanation of A [Wrong Answer]
B.	Both A and R are individually true but R is not the correct explanation of A [Wrong Answer]
C.	A is true but R is false [Wrong Answer]
D.	A is false but R is true [Correct Answer]
View Answer 1 -1 Explanation:- Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ A rectangular wave guide is designed to propagate at the dominant mode TE₁₀ at a frequency of 5 GHz. The cut-off frequency is 0.8 of signal frequency. The ratio of the guide width to height is 2. The dimensions of the guide are
3.75 cm, 1.875 cm
4 cm, 2 cm
8 cm, 4 cm
2.54 cm, 1.27 cm

⇒ Consider the following statements about transport-lag

It is of non-minimum phase behaviour
It normally exists in thermal, hydraulic and pneumatic systems
It has an excessive phase lag with no attenuation at high frequency

Which of the above statements are correct?
1 only
1 and 2
All
2 and 3

⇒ The stud in a stud mounted SCR acts as
anode
cathode
gate
anode or cathode

⇒ Which of these has 3 layers?
PIN diode
Zener diode
Schottky diode
Photo diode

⇒ If a sample of Ge and a sample of Si have the same impurity density are kept at room temperature
both will have equal value of resistivity
both will have equal - ve of resistivity
resistivity of germanium will be higher than that of silicon
resistivity of silicon will be higher than of Ge

⇒ In the circuit, shown in figure, V₀ = V_i. The values of 1, m, n are: (x represents don't care conditi
0, 1, 1
∞, x, x
x, ∞, x
0, x, ∞

⇒ An ac network has a power factor of 0.8 lagging for fundamental frequency. If the applied voltage contains thrid and fifth harmonics, the overall power factor will be
more than 0.8 lagging
0.8 lagging
less than 0.8 lagging
0.8 lagging or less

⇒ An ideal power supply has
zero internal resistance
very high internal resistance
high output resistance
both (b) and (c)

⇒ As frequency is increased, the skin effect
increases
decreases
remains the same
either (b) or (c)

⇒ A number given in binary as 0101.01 is to be scaled up 4 times. The scaled up binary is
10101
1.0101
404.04
10.101

⇒ Which factor determines whether the medium is free space, lossless dielectric, lossy dielectric or good conductor?
Attenuation constant
Constitutive parameters (σ, μ, ε)
Loss tangent
Reflection coefficient

⇒ Short-circuited stubs are used, because open-circuited stubs are
liable to radiate
complex in nature
providing open-circuit environments
unable to provide work over large frequency range

⇒ An amplifier without feedback has a voltage gain of 50, input resistance of 1 kΩ and output resistance of 2.5 kΩ. The input resistance of the current shunt -ve feedback amplifier using the above amplifier with a feedback factor of 0.2 is
1/11 kΩ
1/5 kΩ
5 kW
11 kW

⇒ The expression A ** B / C + D is equivalent to
AB / C + D
AB / C + D
AB / (C + D)
None of the above

⇒ If sequence y(n) = x(-n) then it is
Causal
Non-Causal
Depends on x(-n)
None

⇒ In an amplitude modulated waveform, the amplitude of the sideband is
independent of the carrier amplitude
independent of the modulation index
carrier amplitude x modulation index
1/2 carrier amplitude x modulation index

⇒ A half adder adds __________ bits and a full adder adds __________ bits.
two, three
three, four
four, six
two, four

⇒ Resistivity is a property of a semiconductor that depends on
the atomic weight of the semiconductor
the atomic number of the semiconductor
the atomic nature of the semiconductor
the shape of the semiconductor

⇒ A class A chopper has an input voltage of 200 V. T_on = 1.5 ms and T_off = 4.5 ms. The duty cycle, average output voltage and ripple factor respectively are
0.5, 100 V and 1
0.25, 50 V and 3
0.25, 50 V and 1
0.5, 100 V and 3

⇒ In the given figure, the curves 1, 2, 3 are respectively
all pass, minimum phase and non-minimum phase functions
minimum phase, all pass and non-minimum phase functions
non-minimum phase, all pass and minimum phase functions
minimum phase, non-minimum phase and all pass functions

⇒ In a semiconductor material. The hole concentration is found to be 2 x 2.5 x 10¹⁵ cm^-3. If mobility of carriers is 0.13 m²/ v-s. Then find the current density if electric field intensity is 3.62 x 10^-19
7.6237 x 10^-4 A/cm²
7.6237 x 10^-5 A/cm²
7.6237 x 10^-3 A/cm²
none of these

⇒ A rectangular waveguide of internal dimensions (a = 4 cm and b = 3) is to be operated in TE₁₁ mode. The minimum operating frequency is
6.25 GHz
6.0 GHz
5.0 GHz
3.75 GHz

⇒ A thermometer requires 1 minute to indicate 98% of its final response to a step input. If it is a first order system the time constant is
1 minute
0.5 minute
0.25 minute
0.1 minute

⇒ Which of the following be true for a CE transistor amplifier if the emitter resistor value is made equal to zero?

Its gain will increase
Its stability will increase
Its gain will decrease
Its stability will decrease

Select the correct answer from the codes given below
1 and 2
2 and 3
3 and 4
1 and 4

⇒ In a combination limiter with sinusoidal input voltage the output wave can be nearly square.
TRUE
FALSE

⇒ For input and later stages, BI-FET op-amp use
JFETs and MOSFETs respectively
MOSFETs and JFETs respectively
JFETs and BJTs respectively
BJTs and JFETs respectively

⇒ What is the length of SP (Stack pointer) of 8085 μp?
6 bits
8 bits
12 bits
16 bits

⇒ The impedance inversion may be objected with
a short-circuited stub
an open-circuited stub
a half-wave line
a quarter-wave line

⇒ The inductance of a single layer solenoid of 10 turns is 5 μH. Which one of the following is the correct value of inductance when the number of turns is 20 and the length is doubled.
10 μH
20 μH
40 μH
5 μH

⇒ Consider the following statement in B
200, 250, 150 respectively
150, 200, 250 respectively
250, 200, 150 respectively
200, 150, 250 respectively