Users Also Read
MCQ's Search Engine
Electrical Engineering
Mechanical Engineering
Civil Engineering
Automobile Engineering
Chemical Engineering
Computer Engineering
Electronics Engineering
Medical Science Engg
In a positive-edge-triggered JK flip-flop, a low J and a low K produce __________ state. A high __________ on the rising edge of the clock. | |
A. | inactive, reset [Wrong Answer] |
B. | active, reset [Wrong Answer] |
C. | active, toggle [Wrong Answer] |
D. | inactive, toggle [Correct Answer] |
View Answer
Explanation:-
Answer : D Discuss it below : !! OOPS Login [Click here] is required to post your answer/result |
Also Read Similar Questions Below :
⇒ The decimal equivalent of the hexadecimal number E 5 is
279
229
327
0
⇒ In TE_{10 }mode the largest electric field in a rectangular wave guide, occurs
along centre line of broad wall (i.e. x = a/2)
along the broad wall (i.e. x = 0 and x = a)
either (a) or (b)
neither (a) nor (b)
⇒ The abbreviation DTL stands for
Digital Timing Logic
Diode Transistor Logic
Dynamic Transient Logic
Delayed Tracking Logic
⇒ The following circuit is implementation of
⇒ The decimal equivalent of the hexadecimal number E 5 is
279
229
327
0
⇒ In TE_{10 }mode the largest electric field in a rectangular wave guide, occurs
along centre line of broad wall (i.e. x = a/2)
along the broad wall (i.e. x = 0 and x = a)
either (a) or (b)
neither (a) nor (b)
⇒ The abbreviation DTL stands for
Digital Timing Logic
Diode Transistor Logic
Dynamic Transient Logic
Delayed Tracking Logic
⇒ The following circuit is implementation of
- Sum of full adder
- Carry of half adder
- Difference of full subtractor <
(i) only
(iii) only
(ii) only
(i) and (ii)
⇒ The term 'Poisson's ratio' is connected with
strain gauge
LVDT
Bourden tube
capacitance transducer
⇒ The conductivity of intrinsic semiconductor is given by
en_{i}(μ_{p} - μ_{n})
en_{i}(μ_{p} + μ_{n})
n_{i}(μ_{p} + μ_{n})
n_{i}(μ_{p}μ_{n})
⇒ A 10 km long line has a characteristic impedance of 400 ohms. If line length is 100 km, the characteristic impedance is
4000 Ω
400 Ω
40 Ω
4 Ω
⇒ In all base driver amplifiers
ac collector voltage is 180° out of phase with ac base voltage
ac emitter voltage is 180° out of phase with ac base voltage
ac collector voltage is in phase with ac base voltage
none of the above
⇒ The orbital period of a geostationary communication satellite is
12 hours
24 hours
36 hours
48 hours
⇒ A signal x(n) = sin(ω_{0}n + φ) is the input to a linear time invariant system having a frequency response H(e^{jω}) If the O/P of the system is Ax(n -n_{0}), then the general form of H(e^{jω}) will be
- n_{0}ω_{0} + β for any arbitrary real β
- n_{0}ω_{0} + 2pk for any arbitrary integer k
n_{0}ω_{0} + 2pk for any arbitrary integer k
- n_{0}ω_{0} + φ
⇒ Pre-emphasis circuit is used
after modulation
before modulation
before detection
after detection
⇒ The voltage across the secondary of the transformer in a half wave rectifier (without any filter circuit) is 25 volts. The maximum voltage on the reverse biased diode will be
100 V
50 V
25 V
12.5 V
⇒ A parallel resonant circuit can be used
as a high impedance
to reject a small band of frequencies
both (a) and (b)
to amplify certain frequencies
⇒ Geosynchronous satellites are always launched in the equatorial plane because it is the only plane which provides
24-hour orbit
stationary satellite
global communication
zero-gravity environs
⇒ Which of the following is unlikely to happen when quantising noise is decreased in PCM?
Increased bandwidth
Increased channel noise
Increased number of standard levels
All of the above
⇒ The ratio of the diffusion coefficient in a semiconductor has the units
V^{-1}
em.V^{-1}
V.cm^{-1}
V.s
⇒ A uniform plane wave in the free space is normally incident on an infinitely thick dielectric slab (dielectric constant ε_{r} = 9). The magnitude of the reflection coefficient is
0
0.3
0.5
0.8
⇒ Which one of the following is an active component?
Diode (p-n)
Transistor as Amplifier
Transformer
Inductor
⇒ A wave is propagated in a waveguide at frequency of 9 GHz and separation is 2 cm between walls Calculate group velocity for dominant mode.
1.8 x 10^{8} m/sec
5 x 10^{8} m/sec
3 x 10^{8} m/sec
1.5 x 10^{8} m/sec
⇒ Which of the following characteristics is not true for TTL Logic?
Good speed
Low power dissipation per gate
High cost
None of these
⇒ In the CMOS inverter
one transistor is N channel and the other P channel
one is enhancement type and other depletion type
both are N channel with one enhancement and the other depletion type
none
⇒ When the number of quantising levels is 16 in PCM, the number of pulses in a code group will be
3
4
8
16
⇒ A complex wave is 5 + 5 sin ωt. Its rms value is
7.07 V
5 V
10 V
6.12 V
⇒ Which of the following equations satisfy Maxwell's equations?
E_{x} = E_{y} = 0, E_{z} = cos (y - ct)
E_{x} = E_{y} = 0, E_{z} = cos (y- ct)
F_{y} = cos (y - ct), E_{x} = E_{z} = 0
None of these
⇒ A source is delivering maximum power to a resistance through a network. The ratio of power delivered to the source power,
is always 0.5
may be 0.54 or less
may be 0.5 or less
may be 0.5 or more
⇒ In full wave rectification, if the input frequency is 50 Hz, then frequency at the output of filter is
50 Hz
0 Hz
100 Hz
75 Hz
⇒ The impulse response of the DT - LTI system is given be
1 and 2
2 and 3
1 and 3
1, 2 and 3
⇒ Maximum effective aperture of an antenna which is operating at a wavelength of 3 meters and has a directivity of 100
71.68 m^{2}
716 m^{2}
7.16 m^{2}
71.6 m^{2}
⇒ The element in the feedback circuit of a logarithmic amplifier using op-amp is
a resistor
a capacitor
an inductor
a diode
⇒ A transistor in CE mode is in saturation region. Then the collector is almost at
ground potential
a potential equal to V_{CC}
a potential equal to 0.5 V_{CC}
a potential equal to 2 V_{CC}