Question is ⇒ Consider a 300 Ω, quarter wave long at 1 GHz transmission line as shown in figure. It is connected to a 10 V, 50 Ω source at one end is left open circuited at the other end. The magnitude of the voltage at the open circuit end of the line, Options are ⇒ (A) 10 V, (B) 5 V, (C) 60 V, (D) 60/7 volt, (E) , Leave your comments or Download question paper.

Question is ⇒ Consider a 300 Ω, quarter wave long at 1 GHz transmission line as shown in figure. It is connected to a 10 V, 50 Ω source at one end is left open circuited at the other end. The magnitude of the voltage at the open circuit end of the line, Options are ⇒ (A) 10 V, (B) 5 V, (C) 60 V, (D) 60/7 volt, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Consider a 300 Ω, quarter wave long at 1 GHz transmission line as shown in figure. It is connected to a 10 V, 50 Ω source at one end is left open circuited at the other end. The magnitude of the voltage at the open circuit end of the line
A.	10 V [Correct Answer]
B.	5 V [Wrong Answer]
C.	60 V [Wrong Answer]
D.	60/7 volt [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ The function Z(s) has a pole at infinity if
the degree of numerator and denominator of Z(s) are equal
the numerator of Z(s) is one degree higher than denominator
the denominator of Z(s) is one degree higher than numerator
the degree of numerator and denominator are either equal or differ by one

⇒ In an amplifier with a gain of - 1000 and feedback factor β = - 0.1, the change in gain is 20% due to temperature. The change in gain for feedback amplifier will be
0.1
0.05
0.002
0.0001

⇒ The effective value of the waveform in the given figur
5
2.5
2.5
5.0

⇒ When number of quantization levels are two; then the average transmission power in NRZ polar signaling is __________ that of NRZ unipolar signaling
42737
42739
42743
none of these

⇒ A 3 phase induction motor is fed by a 3 phase ac regulator to change the stator voltage. The variation in speed will be more if
load torque is constant
load torque increases with increase in speed
load torque decreases with increase in speed
either (a) or (b)

⇒ When a transistor is connected in common emitter mode, it with have
negligible input resistance and high output resistance
high input resistance and low output resistance
medium input resistance and high output resistance
low input resistance as well as output resistance

⇒ Registers and counters are similar in the sense that they both
count pulses
store binary information
are made from an array of flip-flops and gates integrated on a single chip
are shift registers

⇒ For making a capacitor it is better to have a dielectric having
high permittivity
low permittivity
permittivity same as that of air
permittivity which is neither high nor low

⇒ Narrow band FM signal can be represented as
A cos (2pf_ct) - βA sin (2pf_ct) sin (2pf_mt)
A cos (2pf_mt) - βA sin (2pf_ct) sin (2pf_mt)
A cos (2pf_ct) + βA sin (2pf_ct) sin (2pf_mt)
A cos (2pf_mt) + βA sin (2pf_mt) sin (2pf_ct)

⇒ What is the direction of address
Unidirectional into μp
Unidirection out of μp
Bidirectional
Mixed direction, i.e., some lines into up and some others out of μp

⇒ Two coil have their axis perpendicular to each other. The coefficient of coupling k is
1
0.5
more than 0 but less than 1
0

⇒ Which of the following sampling frequencies is considered adequate in voice telephony?
4 kHz
8 kHz
16 kHz
32 kHz

⇒ Which of the following is not advantage of FM over AM?
Noise immunity
Capture effect
Fidelity
Spluttering effect

⇒ A 4 bit parallel type A/D converter uses a 6 volt reference. How many comparators are required and what is the resolution in volts?
0.375 V
15 V
4.5 V
10 V

⇒ Typical switching time for ECL is
5 nano seconds
5 micro seconds
5 milli seconds
5 seconds

⇒ Which of the following microphones has lowest output impedance?
Moving coil
Ribbon
Crystal
Condenser

⇒ As per temperature limits, the number of categories of solid dielectrics are
7
6
8
5

⇒ For a reactance function H(s), the slope dH (jω)/dω is
0
always positive
always negative
either 0 or positive

⇒

Assertion (A): An op-amp amplifier can amplify dc signal

Reason (R): An op-amp amplifier is a direct coupled amplifier

Both A and R are correct and R is correct explanation for A
Both A and R are correct but R is not correct explanation for A
A is correct R is wrong
A is wrong R is correct

⇒ What is the frequency of audio modulation?
1000 Hz
2000 Hz
3000 Hz
2000 kHz

⇒

Match the following:

	List I		List II
A.	Silicon	1.	is trivalent
B.	Arsenic	2.	rarely used as semiconductor
C.	Indium	3.	is pentavalent
D.	Germanium	4.	intrinsic semiconductor

A-1, B-2, C-3, D-4
A-4, B-3, C-2, D-1
A-4, B-3, C-1, D-2
A-2, B-1, C-3, D-4

⇒ A chopper cannot be line commutated.
TRUE
FALSE

⇒ The radiation resistance of a rod tubing antenna is
55 Ω to 60 Ω
60 to 100 Ω
0 to 377 Ω
60 to 200 Ω

⇒ Assuming accumulator contain A 64 and the carry is set (1). What will register A and (CY) contain after XRA A?
A 6 H, 1
A 6 H, 0
00 H, 0
00 H, 1

⇒ If in a radio receiver, RF signal has a frequency of 800 kHz and local oscillator that of 1000 kHz, then at the output of the mixer, the frequencies found would be __________ kHz.
800 to 1000
200, 800, 1000, 1800
only 200
only 1800

⇒

Assertion (A): In 8085 when RESET OUT goes low processing begins.

Reason (R): CPU remains reset till RESET IN signal goes high.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct R is wrong
A is wrong R is correct

⇒ Maximum usable frequency is [f_muf]
f_c sec i
f_c cos i
f_c sin i
f_c sec i

⇒ A number given in binary as 0101.01 is to be scaled up 4 times. The scaled up binary is
10101
1.0101
404.04
10.101

⇒ The number of accumulators in 6800 are
2
3
1
4

⇒ A full adder is to be implemented using half adders and OR gates. A 4 bit parallel adder without any initial carry requires
8 half adders and 4 OR gates
8 half adders and 3 OR gates
7 half adders and 3 OR gates
7 half adders and 4 OR gates