Question is ⇒ Kirchoff's voltage law is not valid for a non-linear network, Options are ⇒ (A) the statement is true, (B) the statement is false, (C) can't say, (D) none of the above, (E) , Leave your comments or Download question paper.

Question is ⇒ Kirchoff's voltage law is not valid for a non-linear network, Options are ⇒ (A) the statement is true, (B) the statement is false, (C) can't say, (D) none of the above, (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	Kirchoff's voltage law is not valid for a non-linear network
A.	the statement is true [Wrong Answer]
B.	the statement is false [Correct Answer]
C.	can't say [Wrong Answer]
D.	none of the above [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : B Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In the wave mechanical theory, the maximum of the charge distribution in the ground state occurs for a distance from the nucleus equal to
first Bohr radius
second Bohr radius
third Bohr radius
either first or second Bohr radius

⇒ Which of the following is not true as regards communication receiver?
It is exactly same as radio receiver used in households
It can be used, besides communication, for detection in high frequency bridges
It is designed to perform the task of low and high frequency reception better than in household receiver
Its tuning and operation are more complicated than those in household receiver

⇒ A dc voltage source is connected across a series RLC circuit, Under steady state conditions, the applied dc voltage drops entirely across the
R only
C only
L only
R and L

⇒ In a picture tube, the video signal is applied to
cathode
grid
any anode
either cathode or grid

⇒ If a function Z(s) has a pole at infinity, then
the degrees of numerator and denominator are equal
the degree of numerator is one higher than that of denominator
the degree of denominator is one higher than that of numerator
the difference between the degrees of numerator and denominator is 0 or 1

⇒ At FM demodulator output noise power density
increases with frequency
decreases with frequency
remains unaltered
none of the above

⇒ Fourier transform and F(jω) of a signal f(t) has the property
F(jω) = F(-jω)
F(jω) = -F(-jω)
F(jω) = F^*(jω)
F(jω) = -F^*(-jω)

⇒ The resistance of voltmeter affects the accuracy of measurement in loss of charge method.
TRUE
FALSE

⇒ A bit synchronizer regenerates at the receiver a clock waveform which is
synchronous with original clock waveform
out of phase by 180° with original clock waveform
out of phase by 90° with the original clock waveform
none of the above

⇒ The parameter β of a BJT change by 300%. If self bias is used in the amplifier using this BJT, the quiescent value of I_C and V_CE remain almost the same.
TRUE
FALSE

⇒ A current of 1 A in the coil of an iron cored electromagnet causes B = 0.5T. If current is 2A, B =
0.5 T
1 T
1 T or more
1 T or less

⇒ The current i(t) through a 10 Ω resistor in series with an inductance is given by i(t) = 3 + 4 sin (100t + 45°) + 4 sin (300t + 60°) Amperes. The RMS value of the current and the power dissipated in the circuit are
41 A, 410 W respectively
35 A, 350 W respectively
5 A, 250 W respectively
11 A, 1210 W respectively

⇒ Absolute instruments are used in
laboratories
industries
power houses
standard laboratories

⇒ Which of the following cannot be used to demodulate SSB?
Complete phase shift generator
Product detector
Diode balanced modulator
Bipolar transistor balanced modulator

⇒ In a system an input resistance of 20 kΩ causes a noise voltage of 15μV. If two such input resistances each of 20 kΩ are used in parallel, the total noise voltage will be about
15 μV
30 μV
7.5 μV
10.6 μV

⇒ The stage marked X in the architecture shown below of a two stage op-amp
Direct coupled amplifier
Buffer amplifier
Level shifter
Blocking oscillator

⇒ The simplest standing wave is due to the value of reflection co-efficient is
-1
zero
unity
infinity

⇒ Which of these devices have four layers?
UJT
SCR
TRIAC
SCR and TRIAC

⇒ Which of the following pairs are correctly matched?

Brune's realisation : realisation with ideal transformer.
Cauer realisation : ladder realisation.
Bott Duffin realisation : with non ideal transformer.

Select the answer using the following codes:
1, 2 and 3
2 and 3
1 and 3
1 and 2

⇒ Determine the transistor capacitance of a diffused junction varicap diode of a reverse potential of 4.2 V if C(0) = 80 pf and V_T = 0.7 V
42 pf
153.03 pf
13.33 pf
Data inadequate

⇒ A zinc carbon cell is a primary cell.
TRUE
FALSE

⇒ At present, the radio-frequency band mainly used by most satellites is
EHF
UHF
VHF
SHF

⇒ The power rating of radio transmitters is around
100 mW
10 W
10 kW
10 MW

⇒ Consider the following statements

Impedance of Gunn diode is about tens of ohms.
Impedance of Impatt diode is a few ohms.
Impedance of Impatt diode are of the same order.
Impedance of Impatt diode is more than that of Gunn diode.

Which of the above statement are correct?
all
1 and 2 only
1, 2 and 3
1, 2 and 4

⇒ For the K map of the given figure the simplified Boolean expressio
A B + A B
B
A
AB

⇒

Assertion (A): Artificial transmission lines are frequently used in laboratories.

Reason (R): An artificial transmission line can be used to represent an actual line and can also be used as a delay circuit, as attenuator, as filter network etc.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is correct but R is wrong
A is wrong but R is correct

⇒ The waveguides compared to equivalent transmission lines at low frequency are
able to carry more power
less noisy
having lower attenuation
all of the above

⇒ In 8085 the instruction MOV A, M is an example of
Direct addressing
Immediate addressing
Register addressing
Register indirect addressing

⇒ In a power system, reactive power is necessary for
power transmission
stabilising the voltage level
counteracting the effect of reactance in the transmission system
none of the above

⇒ In some on-off controllers a differential gap is provided
to make the manufacture process easier
to prevent too often frequent operation of controller
both (a) and (b)
neither (a) nor (b)