Question is ⇒ In a R-L-C circuit at resonance is, Options are ⇒ (A) maximum in series resonance and minimum in parallel resonance., (B) maximum in parallel resonance and minimum in series resonance, (C) minimum in both series and parallel resonances, (D) maximum in both series and parallel resonances., (E) , Leave your comments or Download question paper.

Question is ⇒ In a R-L-C circuit at resonance is, Options are ⇒ (A) maximum in series resonance and minimum in parallel resonance., (B) maximum in parallel resonance and minimum in series resonance, (C) minimum in both series and parallel resonances, (D) maximum in both series and parallel resonances., (E) , Leave your comments or Download question paper. Previous question Next question


Q1.	In a R-L-C circuit at resonance is
A.	maximum in series resonance and minimum in parallel resonance. [Correct Answer]
B.	maximum in parallel resonance and minimum in series resonance [Wrong Answer]
C.	minimum in both series and parallel resonances [Wrong Answer]
D.	maximum in both series and parallel resonances. [Wrong Answer]
View Answer 1 -1 Explanation:- Answer : A Discuss it below : !! OOPS Login [Click here] is required to post your answer/result Help other students, write article, leave your comments

Previous question Next question

Also Read Similar Questions Below :

⇒ In a microwave resistor the wall thickness is made as small as possible to
have high value of R
have low value of R
minimize capacitive effect
reduce inductance

⇒ The ratio of diffusion constant for hole D_P to the mobility for holes is proportional to
T²
T
1/T
T³

⇒ Which coupling produces the minimum interference with frequency response?
RC coupling
Transformer coupling
Direct coupling
Impedance coupling

⇒ An FM signal has modulating frequency f_m and maximum frequency deviation of δ. The bandwidth will be nearly equal to
δ
2 δ
2f_m δ
f_m δ

⇒ When thyristors are connected in parallel, the current distribution may become non-uniform due to
inductive effect of current carrying conductors
capacitive effect of current carrying conductors
both inductive and capacitive effects
none of the above

⇒

Assertion (A): Power transistors are more commonly of silicon npn type.

Reason (R): The fabrication of silicon npn transistors is easy.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A single phase half wave controlled rectifier circuit has an R-L load. A freewheeling diode is also in the circuit. When freewheeling diode is conducting the SCR
is forward biased
is reverse biased
may be forward biased or reverse biased
forward biased initially but reverse biased afterwards

⇒ In a broadcast superheterodyne receiver
the local oscillator operates below the signal frequency
local oscillator frequency is normally double the IF
RF amplifier normally works at kHz above the carrier frequency
mixer input must be tuned to the signal frequency

⇒ To select one out of N equally probable events, the number of bits required is
log₂ N
log₁₀ N
log_e N
N

⇒ Which one of following is correct condition to check the stability of system?
Bounded I/P unbounded O/P
Bounded I/P and O/P
Bounded O/P and I/P
Bounded I/P Bounded O/P

⇒

Assertion (A): In intrinsic semiconductors, the charge concentration increases with temperature.

Reason (R): At higher temperatures, the forbidden energy gap in semiconductors is lower.

Both A and R are true and R is correct explanation of A
Both A and R are true but R is not a correct explanation of A
A is true but R is false
A is false but R is true

⇒ A first order element yields almost exact duplication only for constant or slowly varying phenomenon.
TRUE
FALSE

⇒ The radiation resistance of a λ/16 wire dipole in free space will be nearly
1 Ω
3 Ω
13 Ω
30 Ω

⇒ A ripple counter has 4 bits and uses flip flops with propagation delay time of 25 ns. The maximum possible time for change of state will be
25 ns
50 ns
75 ns
100 ns

⇒ The circuit of figur
Precision integrator
Hartley oscillator
Butterworth high pass filter
Wien bridge oscillator

⇒ The three sides of an admittance triangle denote
G, B, Y
R, X, Y
G, B, Z
(R, Y, Z) or (R, X, Z)

⇒ If a wave is propagated in free space, it will be in nature of
TE
TM
TEM
Any one of above

⇒ The standard FORTRAN exponential form of decimal number - 0.000000023 is
2.3 E - 8
-2.3 E - 8
2.3 E - 7
-2.3 E - 7

⇒ The output of a diode detector contains
D.C. voltage
modulating signal
RF ripple
all of the above

⇒ Which of the following is the poorest conductor of electricity?
Aluminium
Nichrome
Copper
All of the above

⇒ The most commonly used magnetron is
cylindrical
parallel plate
inclined plate
flat plate

⇒ In a BJT CE amplifier circuit the value of coupling capacitor should be such that
its reactance is small for the lowest frequency in the input and output
its reactance is high for the lowest frequency in the input and output
its reactance is zero for the lowest frequency in the input and output
its reactance is infinite for the lowest frequency in the input and output

⇒ Compared to coaxial lines, the advantages of wave guides are
higher power handling capacity
lower loss per unit length
cheaper and simple mechanical structure
all of the above

⇒ In order to protect a MOSFET against damage from any stray voltage at the gate
grounding rings are provided
terminals are shorted
source terminal is earthed during transit
none of these

⇒ For an RC impedance function
all poles lie on jω axis
all poles are simple ,
all poles are simple and lie on negative real axis
none of the above

⇒ In a transistor E mode the collector current with the transistor in cut off region is
zero
high
equal to saturated value
none of the above

⇒ Which of the following is used to provide tracking between RF amplifier and local oscillator stages of receiver?
Variable tuning inductor
Ganged tuning inductor
Variable capacitor
Variable preset

⇒

Assertion (A): Master slave JK flip flop is commonly used in high speed synchronous circuitry

Reason (R): Master slave JK flip flop uses two JK flip flops in cascade.

Both A and R are correct and R is correct explanation of A
Both A and R are correct but R is not correct explanation of A
A is true, R is false
A is false, R is true

⇒ In a series circuit with X_L constant and R variable the current locus lies in the third quadrant.
TRUE
FALSE

⇒ Simplify : A + B + A B + (A + B)AB + C(B + AB)
B + A
C
C
1